Answered: Consider the following ternary plot. B…

Consider the following ternary plot. B 100% 90% 80% 70% 60% 50% 40% 30% 20% 10% A The composition at Point y is A = %, B = %, C = %001 %06 A%08 0% 602 10% 20% %09 30% 40% 50% 60% 70% 80% 90% 100%

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: The amount of V was found to be 0.19% (+/-) 0.02% V (N=6). Calculate t-calc, assuming 95% confidence…

A: Standard deviation=s=0.02 %

Q: A homogeneous mixture has a/ not a uniform composition throughout b/ a uniform composition…

A: Anything which have some mass and can occupy some space is known as the matter. Matter can be exists…

Q: Estimate the relative uncertainty for the measured quantity R according to the following equation: R…

A: To calculate the relative uncertainty for the following equation: R = 157±25-59±41220±108+77±11

Q: Can you please help calculate the reduced mass, μ, for a C-H bond. Answer to 2 decimal places.

Q: Q4: Draw the temperature composition diagram for the following data: melting point compound 150 Pure…

A: Given : Melting point and percentage composition of substance. To find : Temperature composition…

Q: Calculate the bulk density of a 130 cm3 soil sample with an oven-dry weight of 160 g

Q: A titrimetric method for the determination of calcium in limestone was tested with the analysis of a…

Q: Determine the slope of this line. Calculate Ea KJ / mol The slope is y = 7097.3x - 17.85

Q: Choose the following set of elements that correctly shows a DECREASING trend for atomic radius.

A: As we know atomic radius along the period from left to right in the periodic table decreases because…

Q: Plot the following data and perform linear regression to obtain the value of the slope, the value of…

A: The Plot is drawn in the Microsoft office Excel and it is follows.

Q: Please help to.identify all peaks

Q: A sample is selected from a population with µ = 46, and a treatment is administered to the sample.…

A: Solution:-The sample mean before treatment, μ1 = 46 The sample mean after treatment, μ2 = 48The…

Q: Which verbal expression best represents the algebraic expression 3n - 4? A three less than four…

A: Given algebric expression, 3n -4 Choose the correct option for the given expression ?

Q: 190.20 190 180 159.87 170 160 136.49 134.29 132.21 128.70 - 150 140 130 120 113.85 110 100 90 80 70…

Q: 3. Can the outlying result in the set of data below be rejected at the 90% level? 7.295, 7.284,…

A: Q Test The Q test, also known as Grubbs' test, is a statistical test used to detect outliers in a…

Q: Transform nanometers into jules 520(nm) 630(nm)

A: We have to transfer nanometers into joules. 520 nm = 520×10-9 m 630 nm = 630×10-9

Q: To quantify the amount of ethanol in a beverage, a technician prepared the first solution which…

A: Gas chromatography (GC) is an analytical technique that is used for detection and quantification of…

Q: 4) Other Linearization Choices 0/2 poin When using x = 1/A, the meaning of the slope is hc. There is…

A: If E = hcλ can be represented as y = mx straight line where m is the slope of the life If x = 1λ…

Q: An internal standard is incorporated into an analysis method when systematic sources of variation…

A: High-performance liquid chromatography, formerly known as high-pressure liquid chromatography, is a…

Q: Express the molecular mass and its standard uncertainty of C17H21NO4 with the correct number of…

A: Answer:- Molecular mass = 17 × mass of carbon atom + 21 × mass of hydrogen + 1 × mass of nitrogen +…

Q: if you know the standard deviation = 3 for measured data, what is the variance?

Q: 2) You have just finished a GC experiment using the standard additions method to determine the…

A: Here some important data is missing hence i am doing it on general basics . "Since there are…

Q: Compare the width of PI to the range of the y-value from the sample: min: 3.2% max: 9.0%, range =…

A: To compare the width of PI to the range of the y-value from the sample, we need to know what PI…

Q: Cassava tuber has a composition of 5.76% moisture, 6% protein, 0.2% fat and 34.3 total…

A: The explanation is given below-

Q: V 27² g (8)= - 3/2 m 5 ( 11 ) The √ C √e de a+ße 3/20 V m Ne 2π²ħ² V 2 2³ √T provel. e √x dx -¹e-1 λ…

Q: Evaluate the following expressions. Impose the rules for significant figures different ways for the…

A: Significant figures of value determine the precision and accuracy of a calculation. When expressing…

Q: i cant seem to get the right answer for this, could you please explain how i use the constant? like…

Q: Chromatography involves the separation of two or more compounds/ions caused by their molecular…

A: Chromatography involves the separation of two or more compounds/ions caused by their molecular…

Q: A chemical synthesis was carried out four times, resulting in yields of 51.2%,51.2%, 57.4%,57.4%,…

Q: 3-3 Types of Error; 3-4 Propagation of Uncertainty from Random Error (30 min) If A = 3.475 (+0.002),…

Q: You and your partner independently measure the melting point of the same pure sample .you observe q…

A: Given: observed melting points Partner A 126.5-129 oC Partner B 126-132 oC How…

Q: 5000 -4500 -4000 3500 3000 F2500 2000 F1500 -1000 500 8.0 7.5 7.0 6.5 6.0 5.5 5.0 4.5 4.0 3.5 3.0…

A: The signal splitting pattern in 1H NMR can be identified using n+1 rule. Where n = number of…

Q: Identify the data set with the highest (a) precision and (b) accuracy. Data set Certified true Mean…

A: Accuracy refers to closeness of mean value of data set to the actual value. Precision refers to…

Q: Determine the missing Kc value using the information provided below. If YM (3) = Y (3) + Mg) Kc =…

A: The equilibrium constant can be written as the ratio of concentration of products to the…

Q: Gas Chromatography can have which of the following stationery phases and/or mobile phases: O A…

A: In gas chromatography there are two phases , stationary phase and mobile phase . Mobile phase is…

Q: T (°C) -8 2 12 22 32 42 52 62 V (Liters) 1.60 4.84 8.10…

A: A question based on graph, which is to be accomplished.

Q: Complete the following data Standardization of NaOH Trial 1 Trial 2 Trial 3 Trial 4 Mass KHP, g…

A: Here we are required to find the normality of standardized NaOH in reaction 1 and then normality of…

Q: Calculate the 95% confidence interval for these set of data: 3.3,3.4,3.1 and 3.6 ppm

Q: Question: Using a method for the determination of % CaO in limestone the following results were…

A: There are numerous molecules in inorganic chemistry. Every molecule has molecular formula as well as…

Q: Given below is a diagram of separation of two components of a mixture in a chromatographic column.…

A: Given above is a diagram of separation of two components of a mixture in a chromatographic column.…

Q: Suppose that you used smaller volumetric apparatus to prepare 0.250 M NH3 solution by diluting 84.6…

A: According to the question we have, The volume of NH3 solution = V1= 84.6(±0.8) μL= 0.0846 (±0.8) ml…

Q: diantilis ether. find the peaks

A: Here we have to identify each of the peaks for the protons of Diantilis ether.

Q: 6. If we were to generate a sampling distribution of means based on a sample of size of 50, what…

Question

Consider the following ternary plot.
B
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
A
The composition at Point y is
A =
%, В %3
%, C =
%001
%06
%08
0%
602
10%
20%
%09
30%
40%
50%
60%
70%
80%
90%
100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

9) The following results were obtained in the determination of Vitamin E mass in tablet samples. Sample 1 2 3 4 5 6 Weight of Vitamin E (mg) 249.1 249.9 251.2 250.2 244.8 251.0 i. Determine whether any data should be rejected or not at 90 % confidence level. ii. Calculate the mean and standard deviation of the data set above. ii. Express the mean weight of vitamin C at 99 % confidence interval.
In an experiment with an Ostwald Viscometer, the times of flow of water and toluene are 45 s and 32.9 s respectively at 30°C. The density of water is 1.002 g/cc. Calculate the density of the toluene in g/ml. (µwater = 0.8916 %3D cP, utoluene = 0.5239 cP) Use 4 decimal places. 0.8853 0.8053 O 0.8080 O 0.8882
Please choose an appropriate technique(s) to separate following compounds (it can be one, more than one, on none): Compound Melting Point Density Boiling Point Molar mass Phenol 40.5°C 1.07 g/cm 181.7°C 94.113 g/mol Toluene -95 °C 0.87 g/mL 111 °C 92.141 g/mol Simple Filtration Column Chromatography Distilation Crystallization/Re-Crystallization Separatory funnel None www. MacBook Air
Analysis was run on samples from a known CRM with 8.85% Fe. The following results for %Fe were obtained by an analyst: 8.75, 8.51, 8.25, 8.61. Which of the following statements is true assuming none of the data points are outliers? Group of answer choices Tcalc = 63.15 The analysis is not accurate at the 95% confidence interval. Tcalc = 3.03 The analysis is accurate at the 95% confidence interval. Not enough information to determine Tcalc = 63.15 The analysis is accurate at the 95% confidence interval. Tcalc = 3.03 The analysis is not accurate at the 95% confidence interval.
2. Estimate the absolute deviation and the coefficient of variation for the results of the following calculations. Round each result so that it contains only significant digits. The numbers in parentheses are absolute standard deviations. 2 (1.203 (+0.004) x 103 + 18.25 (10.005) x 102 – 34.012(±0.001)) 3.9201 (+0.0006) x 10-3 y =
A chemical analysis yields masses of Zn that are higher by 2 mg compared to the expected value. Calculate the percentage relative error if the true mass of Zn in the sample is 125 mg. O 100.4% O 0.8% 98.4% O 1.6%
Estimate the absolute deviation and the coefficient of variation for the results of the following calculations. Round each result so that it contains only significant digits. The numbers in parentheses are absolute standard deviations. (1.203 (+0.004) × 103 + 1.625 (±0.005) × 102 – 34.012(±0.001) y = - %3D 3.9201 (±0.0006) × 10-3
Give a clear handwritten answer...
Analysis was run on samples from a known CRM with 8.85% Fe. The following results for %Fe were obtained by an analyst: 8.75, 8.51, 8.25, 8.61. Which of the following statements is true assuming none of the data points are outliers? Group of answer choices Tcalc = 63.15 The analysis is not accurate at the 95% confidence interval. Tcalc = 3.03 The analysis is accurate at the 95% confidence interval. Not enough information to determine Tcalc = 63.15 The analysis is accurate at the 95% confidence interval. Tcalc = 3.03 The analysis is not accurate at the 95% confidence interval.
Estimate the absolute deviation and the coefficient of variation for the results of the calculation below. Round off the result so that it contains only the significant digits. The numbers in parentheses are absolute standard deviations.
ie/litrs) Temperalive/Veding 120 aso 240 Bl60 ons L000 125. 12)Qut in the Gruph 1beku the dua abue Chaler's Law SO0 400 200 00 025 O50 Volamliter0 1125. 1is0
L19.