Consider the following balanced three-phase system. Determine vi(t) and i2(t).Nj0.102mV₁ = 100/0°Vmm(0.1+/0.01)02BLmmj1.002B'-/2⁰C'HEB'

Three phase balanced system:Since all impedances are equal then Delta to star transformation:- Star…

Answered: Consider the following balanced…

Consider the following balanced three-phase system. Determine vi(t) and i2(t). j0.102 V₁ = 100/0°V (0.1+/0.01)02 B Lm /1.00 N' B' -/2⁰ C' не B'

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A sinusoidal voltage is applied to a single phase load. The input current wave form is as shown…

A: Phaser diagram is given, From the diagram, vm=1202 V RMS voltage is given by, Vr=Vm2=12022=120 V

Q: For the circuit in the figure, Rab =6002, Zbc = 8022+ j6022. Compute the following: a. Phase and…

Q: 152-240° V C a n 1520° V ial -8+j8 N Vab in 152-120° V Vca b ibl 1 Vbc icl -8+j80-8+j8 N Find the…

Q: A balanced three-phase circuit phase voltage Van = 160230° V and Ven = 160--90° V then the Von is O…

A: Explanation: In a balanced three-phase circuit the phase voltages are apart 1200 from each other If…

Q: For a three-phase circuit following an "abc" sequence, which of the following statements about phase…

A: First we will draw phasor diagram with abc as phase sequence than we will select correct option from…

Q: in the following circuit the complex power by each phase is 0.1+ j0.22 + (),1+ j0.22 480V rms b B…

A: Complex power/Apparent Power: The product of Voltage(v) and current(I) in the circuit is called as…

Q: 1. From the given circuit, take V₁ = 240, ZL = currents. Determine also the total complex power from…

A: Given A delta -Delta connected circuit.we need to determine the line and phase currents and the…

Q: Is |L 20020°V, L Vs rms S. - In the circuit in the figure; • L1 load draws 15 kVA with lagging power…

A: complex power S =Scos(angle)+ S sin(angle) where S is KVA and angle is power factor angle

Q: Q1. A balanced 3 phase Y-Y connected circuit with positive sequence is as shown in the figure. 06Ω…

A: A) Single Phase Equivalent Circuit :

Q: all V R sine sine Let the voltage source be 202135, the current source be 10245 and the impedance of…

A: In this question, We need to determine the value of resistance R if angle of current flow in this…

Q: a ZA ZA bo ZA The circuit shown is excited by a balance three phase source. 357 V and 55 phase…

A: convert star connection in to ∆ connection;Zy in ∆=3Zy in starZy∆=3×4+j6Ω=12+j18ΩZ∆ is parallel with…

Q: ) Find the ICA load current. b) Give the line voltage Vab. c) Calculate the total complex power…

A: In the circuit a) Find the ICA load current. b) Give the line voltage Vab. c) Calculate the total…

Q: Find the rms value of I0 in the unbalanced three-phase circuit shown.

A: Applying KCL at node n

Q: Key =93 Consider the circuit shown below. Here, R = 2092, R2 = 1092, ZL = +jKEYN and Zc = -j102. The…

Q: Problem 6: Given the circuit below, find the total complex, average, and reactive power absorbed by…

A: In this question, We need to determine the total complex power, average power and reactive power.…

Q: 1. Determine the line currents in the given three-phase circuit. I₂ 44020° 440/120° n a 440-120° (50…

Q: From the given circuit, take V₁ = 240, Z₁ = 20 - j3 ohms. Find the phase currents and line ZL…

A: In this question, A 3phase balance source supply to 3 phase balance load. We need to find the…

Q: A symmetrical three-phase, 440 V supply fed a mesh connected load as follows: Load AB: 20 KW at 0.69…

A: The Given is, 440V supply; Load AB: 20KW at power factor of 0.69 lag; Load BC: 25KVA at power factor…

Q: balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil of…

Q: In the circuit shown in (Figure 1) Z₁ = 2.4-0.6) 2. Z₂ = 8.9+5.71 2, and Z3 = 20.5+0j 2. Take that…

Q: 4. For the circuit below, = 24230° v, z, = 2 + j2 SN, z, 4 - j3 2, Z, 6 + j8 2, Z, = 8 - j6 Q, Z, =…

A: The solution is given below

Q: A 5+j1552 15-j5r

A: Given data, Circuit diagram is given as,

Q: What is the rms value of the voltage V0 in the circuit given below

A: This network is combination of resistance, inductive and capacitive elements. Rms value of Vo.…

Q: Calculate "terminal" phase voltage of phases "a" and "c" of generator. Calculate Vab and Vca across…

Q: Find the load current IAB b) Find the line voltage Vbc c) Calculate the total complex power on the…

A: Find the load current IAB Find the line voltage Vbc Calculate the total complex power on the loads

Q: Why we did not multiply by 3

A: Condition no (01) If the value of the load in the question is given as power [ whatever Active…

Q: Z11 a' Z12 w www w A Z13 Z14 B Consider the balanced three-phase network. Z12-40, Z13-130.…

A: In this question We need to determine the voltage Van as shown the circuit. We are solving this…

Q: Take look correct answer and show all work

Q: The voltage between two phases in a balanced three phase-system (4 conductors) is U = 660V. The…

Q: An alternator is connected in star. Its phase voltage is 250 V. This alternator supplies the load…

A: We have an alternator that is connected in star and gives supply to an delta connected load with,…

Q: Time left 0:51:47 Z1 Z2 V sine sine B Let Z1 = 3+j4 ohm and Z2 = 3-j4 ohm. Let the current source…

A: Brief discussion: For the given AC circuit we need to calculate the value of thevenin equivalent for…

Q: A voltage and current applied to a single phase load is v= 27 cos (300t+20°) and i= 17 cos (250t-…

A: Voltage and current signals are given Find the active power and reactive power of the system.

Q: Find the load current IAB b) Find the line voltage Vbc c) Calculate the total complex power on the…

A: ) Find the load current IAB b) Find the line voltage Vbc c) Calculate the total complex power on the…

Q: Problem3. Find the average power delivered by the current source in the following circuit: -j2Ω + 4Ω…

A: We need to calculate the average power delivered by the current source. Circuit:-

Q: Calculate the value of current "I" using Thevenin's theorem.

A: The given circuit is as shown below,

Q: rom the given circuit, take V₁ = 240, Z₁ = 20 - j3 ohms. Find the phase currents and line urrents.…

A: The given three phase system is balance. So we can analyse the circuit by per phase analysis.

Q: Calculate the line currents for phase a, b and c. 2. Calculate the line to neutral voltages at the…

A: Fig: Given citrcuit (1) Although in the Y- connected system Line current =phase…

Q: 12. Refer to the circuit below. The alternator has a line voltage of 240 V and the load has an…

A: In this question, Star connect alternator is supplied to Delta connected load. Find the phase,…

Q: A single phase circuit is supplying the two loads, Load1 draws a real power of 450 kW at a power…

A: From power triangle KVA S=Active power (P)power factor(cosθ). and KVA S =…

Q: CONVERT UNEBALANCE WYE TO UNBALANCE DELTA Solve Phase Currents, Line Currents, and S PQ powers.

A: "Since, you have posted a question with multiple parts. According to our guidelines, we can answer…

Q: The apparent power in a three-phase balanced circuit is 150 VA, and the active power is 100 W. What…

A: Given, Apparent power, S=150 VA Active power, P=100 W

Q: The phase A sequence components of three-phase current are: lao = 0; la1 = 90+j5.8; la2 = 10- j5.8.…

Question

Consider the following balanced three-phase system. Determine vi(t) and i2(t).
N
j0.102
m
V₁ = 100/0°V
mm
(0.1+/0.01)02
B
Lmm
j1.002
B'
-/2⁰
C'
HE
B'

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given:

VIEW

Step 2: Calculation of voltage and current

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 14 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

12 For the circuit shown, the complex power absorbed by the load at phase B is.VA. Take Van as your reference. * a A Va 100Vms 80 +J50 2 20 + J30 2 60-J40 2 Vc
In the circuit below, write the KVL equation of the secondary side E300 Select one: O a. 70 = (30 + j40)|L -j10l O b.0 = (30 + j40) - j101 O c. None O d.0= (j10)+(30 + j40)| to If a Load absorbs 10 kVAara ead
39 Determine the total equivalent impedance of the circuit as shown. Note: the student must put the imaginary part of the reactances and its sign. 1 MAZ0 XL 5 ΚΩ Xc :4 kf2 R 20 kN IR 10000+j10000 ohms 10000 - j10000 ohms 1000 + j1000 ohms O 1000 - j1000 ohms
QUESTION 6 Find the total real power dissipation in a balanced wye-delta system. Load impedance is 5kN270° and phase voltage is 320V RMS O 63W 99W 150W 36W
A Time left 0:51 Z1 22 V sine sine B Let Z1 = 3+j4 ohm and Z2 = 3-j4 ohm. Let the current source phasor be I = j10 ampere and V = 50 volt and phase angle 0 degree. Both sources operate at 50 Hz. Real part of the Thevenin Voltage phasor between nodes A and B is Volt Imaginary part of the Thevenin Voltage phasor between nodes A and B is Volt Real part of the Thevenin Impedance between nodes A and B is Ohm
a) Find the load current IABb) Find the line voltage Vbcc) Calculate the total complex power on the loads.
Can someone please explain how to convert V1=-0.4220 to poloar phasor form? (V1=0.578<0)
A 415 V, 58 Hz 3-phase supply is connected to a 3-phase star connected balanced R-L load each of resistance 17 ohm and impedance 81 ohm. Find the value of inductance in each phase. O 8.00 79.20 O 40.50 O 0.22
Calculate the current phasor I0 and the phase voltage Van at the load Thank you
Consider the circuit shown in figure below: Vi = 150(0.5+j0.866) V 150 j150 V2 = 180(1-j) V Find the phase angle of current 'T with respect to voltage V2.
A single phase circuit is supplying the two loads, Load1 draws a real power of 225 kW at a power factor of 0.66 lagging and Load 2 draws reactive power of 35 kvar at a power factor of 0.68 leading. Find the Apparent power of the Load 1 and Load 2. Apparent power of Load 1 kVA? Apparent power of the load 2 kVA?
I need the answer as soon as possible