Consider a soil with bulk density of 1.34 g/cm3 soil. Sampling the top 7 inches of this soil and measuring the cation exchange capacity (using the ammonium acetate method) results in the following cations exchanged by NH4: 8.9 cmol Ca2*/kg soil, 3.7 cmol Mg2+/kg soil, 3.8 cmol K*/kg soil, and 3.8 cmol Al3+/kg soil. How much Ca2+ is present on the CEC in the top 7 inches of each acre of this soil (in pounds Ca/AFS)? Your Answer: Answer units

Consider a soil with bulk density of 1.34 g/cm3 soil. Sampling the top 7 inches of this soil and measuring the cation exchange capacity (using the ammonium acetate method) results in the following cations exchanged by NH4: 8.9 cmol Ca2/kg soil, 3.7 cmol Mg2+/kg soil, 3.8 cmol K/kg soil, and 3.8 cmol Al3+/kg soil. How much Ca2+ is present on the CEC in the top 7 inches of each acre of this soil (in pounds Ca/AFS)? Your Answer: Answer units

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

a dilution is needed to prepare a standard of 10 mg Zn/L from 0.5g Zn/L. To carry out the dilution we have the following available bulb pipettes: 1ml,2ml,5ml,10ml,20ml and 25 ml and the following volumetric flask: 50ml,100ml,250ml,500ml. which bulb pipette and which corresponding volumetric flask you would choose to carry out the dilution?
You are analyzing the effluent from a lotion plant for parabens using HPLC. You have a working standard solution with a concentration of 59.4 ppm which returned a Peak Height of 10,164 and Peak Area of 5,315. You take 44.4 L of the water sample and concentrate it to 0.3 L and analyze this solution. The Peak Height is 9,119 and the Peak Area is 6,320. What is the concentration of parabens in the effluent of the plant in mg/L to two decimal places.
A 25mL volumetric pipet is used to deliver a sample of the stock solution marked “0.6000M X2SO4” into a 100mL volumetric flask. Distilled water is added to the flask until it is about 3/4thfull, the solution is mixed well, then more water is added to fill it up to the calibration mark, then it is mixed again. Calculate the concentration of X+ion in the dilute solution made above.
A 1.250 g sample of bauxite (the primary ore of aluminum) was analyzed for aluminum. The sample was powderized and treated in concentrated nitric acid. The nitric acid was removed and solids were treated in hot water with added nitric acid. Insoluble solids were removed by gravity filtration. The solution was made basic by the slow addition of dilute ammonia forming the gelatinous precipitate (Al(OH), and Al,O,.x H2O). The precipitate was heated to coagulate it then filtered over filter paper. The paper and solids were placed in a porcelain crucible and the paper was ashed while the precipitate was ignited at 600°C to convert the precipitate to pure Al,O,. The mass of Al,O, recovered was 0.2890 g. The average mass of ash after charring 10 sheets of the identical filter paper was 0.0007 g. Calculate the percent aluminum in the bauxite ore sample.
A 0.879 g sample of a CaCl2·2H2O/K2C2O4·H2O solid salt mixture is dissolved in ~100mL of deionized water. The precipitate, after having been filtered and air-dried, has a mass of 0.284 g. The limiting reactant in the salt mixture was later determined to beCaCl2 ·2H2O. a.Write the ionic equation for the reaction. b.Write the net ionic equation for the reaction. c.How many moles and grams of CaCl2 ·2H2O reacted in the reaction mixture? d.How many moles and grams of the excess reactant, K 2C2O 4H2O, reacted in the mixture? e.How many grams of the K2C2O4·H2O in the salt mixture remain unreacted (inexcess)? f.What is the percent by mass of each salt in the mixture
The Answer = 841.7 mm
A pipet is used to transfer 5.00 mL of a 1.25 M stock solution in flask “S” to a 25.00-mL volumetric flask “B,” which is then diluted with DI H2O to the calibration mark. The solution is thoroughly mixed. Next, 3.00 mL of the solution in volumetric flask “A” is transferred by pipet to a 50.00-mL volumetric flask “B” and then diluted with DI H2O to the calibration mark. Calculate the molarity of the solution in volumetric flask “B.”
You dissolve 150.0 grams of a mixture of MgCl2 and KCI in water, add a solution of excess AgNO3, and precipitate all of the chloride ion as AgCI. After filtration and drying, you find that you have formed 335.0 grams of AgCl. What is the mass in grams of KCI that was in the original 150.0 grams of mixture? g 1 4 C 7 8. +/- x 100 Tap here or pull up for additional resources 3. LO
The following reactions happen simultaneously when HCl is added to a mixture of Mg(OH)2and MgCO3:Mg(OH)2 + 2HCl → MgCl2 + 2H2OMgCO3 + 2HCl → MgCl2 + H2O + CO2What volume (in mL) of 37 wt.% HCl solution (density = 1.2 g/mL) is needed to completelyreact a 25-g mixture of 35.2% MgCO3 and 64.8% Mg(OH)2 by weight?
Could you please provide the balanced chemical equation for the reaction