Consider a single-level cache with an access time of 5 ns, a block size of 128 bytes and a hit ratio H = 0.95. Main memory uses a block transfer capability that has a first-word (8 bytes) access time of 100 ns and an access time of 10 ns for each word thereafter. A.What is the access time when there is a cache miss? Assume that the cache waits until the line has been fetched from main memory and re-executes for a hit. B.Suppose that increasing the block size to 256 bytes increases H to 0.97. Does this reduce the average memory access time?

Q: A cache memory system with capacity of N words and block size of B words is to be designed. If it is…

A: For a 4-way set associative cache, the length of the TAG field is given below:

Q: Suppose a computer using direct mapped cache has 4M byte of byte-addressable main memory, and a…

A: Computer memory is a device that stores data and allows us to retrieve it when needed. Primary…

Q: Given: A MIPS computer system with 1 GB of main memory. It has a 4K-Byte direct-mapped cache with a…

A: Given: *) computer system with 1 GB of main memory  *) 4K-Byte direct-mapped cache . *) block size…

Q: 1. For a direct-mapped cache design with a 32-bit address, the following bits of address are used to…

A: Cache Design Analysis: Cache is a hardware component that is used to store frequently accessed data…

Q: A cache is set up with a block size of 32 words. There are 16 blocks in cache and set up to be…

A: Block size = 32 words  Block Offset = 5 bits Total # of blocks inside cache = 16 So index bits = 4…

Q: A direct-mapped cache consists of 8 blocks. A byte-addressable main memory contains 4K blocks of…

A: Steps to calculate:Step 1: Calculate the cache hit rate (H)            H = Number of cache hits /…

Q: For a direct-mapped cache design with a 32-bit address, the following bits of the address are used…

A: The correct answer for the above mentioned question is given in the following steps for your…

Q: Design a cache with cache size of 128K bytes, block (line) size of 8 words, and word size of 4…

A: Introduction: Cache mapping is a mechanism for transferring data from the main memory.  There are…

Q: 5. Suppose a byte-addressable computer using set-associate cache has 2^21 bytes of main memory and a…

A: If the number of address bits are n then, the size of the cache is 2n words. Since, the size of the…

Q: 3. Suppose a computer using direct mapped cache has 2^32 byte of byte-addressable main memory and a…

A: Solution:   a) It is given that the size of the main memory= 232 bytes Cache size = 1024 bytes = 210…

Q: If we have to design a 4 - way set - associative cache of 8 MB size that could work for a main…

A: Answer 1> 221 (the number of cache blocks that 8MB cache can accommodate) Answer 2> Size  of…

Q: Suppose a computer using direct mapped cache has 23232 bytes of byte-addressable main memory, and a…

A: I have answered this question in step 2.

Q: Here is the question:  A direct-mapped cache consists of 8 blocks. A byte-addressable main memory…

A: Calculate the misses and hits for the given program that loops 3 times from addresses 0 to 75 (base…

Q: Q2: a cache memory consists of 512 blocks, and if the last word in the block is 111111. I the last…

A: Considering the above scenario, Assume that Block size of main memory is 1KB Number of words in…

Q: Suppose a computer using fully associative cache has 4G bytes of byte-addressable main memory and a…

A: Cache mapping refers to the technique used for bringing content from the main memory into the cache…

Q: A cache memory has a line size of eight 64-bit words and a capacity of 4K words. The main memory…

A: A 64-bit word means 8 byte.Line size: 8 words in a line, means 8 x 8 bytes = 64 bytes in a line = 26…

Q: Suppose a byte-addressable computer using set associative cache has 4Mbyes of main memory and a…

A: Set-associative caches are an essential component of modern computer systems, aiming to improve data…

Q: Suppose we have a byte-addressable computer using 2-way set associative mapping with 16-bit main…

A: We have ,             2-way set associative mapping  Number of bits required to represent main…

Q: Suppose a computer using direct-mapped cache has 232 (that's 232)232) bytes of byte-addressable main…

A: From the question we are given that Main memory size = 232 bytes Cache memory size = 512 bytes…

Q: A certain processor uses a fully associative cache of size 16 kB. The cache block size is 16 bytes.…

A: The answer for the tag and index fields respectively in the addresses generated by the processor is

Q: A cache is set up with a block size of 32 words. There are 64 blocks in cache and set up to be 4-way…

A: Each block has 32 words, so the block offset = 25 words. So Block offset field can be represented by…

Q: The diagram below shows a 20‐bit virtual address. Identify the bits of the virtual address that…

A: In virtual memory system, it employs paging and a Translation Lookaside Buffer (TLB) to store recent…

Q: 1. Suppose a computer using direct mapped cache has 2^20 bytes of byte-addressable main memory, and…

A: Given:- Size of main memory = 220 bytes           Size of blocks   = 24 bytes…

Q: re there in a set? ANSWER: cache has? ANSWER: address format is => | Tag: blocks sets bits | Set:…

A:

Q: In a microprocessor of 32 bit addresses, the tag length will change if we design a two-way…

A: two-way set-associate cache versus a four-way set- associative cache: Two way set associative cache…

Q: e access tim ess time of c -1 is thrice th ty from the L ock cycles. T of the system

A:

Q: For a direct-mapped cache design with a 32-bit address, the following bits of the address are used…

A: For a direct-mapped cache design with a 32-bit address, the following bits of the address are…

Q: Assume you have a 8-way set associative cache having 16K lines each having capacity of 8 Bytes. A…

A: First of all, we need to determine what the index bits are and from above we know the offset is 9…

Q: Suppose a computer using fully associative cache has 4 GB of byte-addressable main memory and a…

A: We are given a fully associative cache and main memory. We are asked different questions related to…

Q: Assume you have a 8-way set associative cache having 16K lines each having capacity of 8 Bytes. A…

A: A.  Block size = 8 bytes So # of data bytes brought= size of block = 8

Q: Suppose a computer using a 4-way set associative cache mapping scheme has a 20-bits memory address…

A: Here in this question we have given 4 way set associative cache mapping Memory size = 20 bit  Block…

Q: that in 1000 memory references there are 50 misses in the first-level cache, 20 misses in the…

A: According to the question, we have to find average memory access time. In step 2, we will find…