Consider a compressor which is adiabatic. At the inlet of the compressor the temperature is 360 K and pressure is 130 kPa and the air passes at the rate of 1 kg/s. At the exit of the compressor the temperature is 550 K and pressure is 900 kPa. Find the volumetric flow rate of air at the exit [m³/s and also, power consumed by the compressor [kW]. Assumptions. Steady state process. Kinetic and potential energy changes are negligible. Air is an ideal gas with variable specific heats.

Consider a compressor which is adiabatic. At the inlet of the compressor the temperature is 360 K and pressure is 130 kPa and the air passes at the rate of 1 kg/s. At the exit of the compressor the temperature is 550 K and pressure is 900 kPa. Find the volumetric flow rate of air at the exit [m³/s and also, power consumed by the compressor [kW]. Assumptions. Steady state process. Kinetic and potential energy changes are negligible. Air is an ideal gas with variable specific heats.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Refrigerant 134a enters an insulated diffuser as a saturated vapor at 80°F with a velocity of 1400 ft/s. The inlet area is 1.4 in?. At the exit, the pressure is 400 lb;/in? and the velocity is negligible. The diffuser operates at steady state and potential energy effects can be neglected. Determine the mass flow rate, in Ib/s, and the exit temperature, in °F.
Thermodynamics question
*** ***Solve the following problems, correctly and systematically, and show all the necessary figures. Show your correct and complete solution neatly. There are required 2000 kW of compressor power to handle air adiabatically from 1 atmosphere, 27 °C, to 305 kPaa. The initial air velocity is 20 m/s and the final velocity is 85 m/s. a) If the compression is isentropic, find the compressor capacity, in m3/s. b) If the compression process is irreversible adiabatic to a temperature of 160 °C, with the capacity found in (a), determine the compressor power input, in Hp.
A liquid expands reversibly in keeping with a linear regulation from 4.5 bar to 2 bar. The preliminary and very last volumes are 0.008 m^3 and 0.03 m^3. The fluid is then cooled reversibly at regular pressure, and subsequently compressed reversibly in keeping with a regulation pv regular again to the preliminary situations of 4.5 bar and 0.008 m^3. Calculate: a) the volume at the start isothermal compression. b) the work completed in every process, and c) the network of the cycle. Assume liquid as fluid
Steam turbine Wout P2 X2 = 1.0 V2 Steam enters a well-insulated turbine at 3.5 MPa and T,°C with a velocity of 130 m/s. At the exit, water is saturated vapor at 30 kPa and the velocity is 220 m/s. What should be inlet temperature T1, in °C, if work generated by turbine (wout) is 700 kJ/kg.
Time left 0:22:28 Air enters a compressor with h₁ = 378.7 kJ/kg and exists with h₂ = 7134 k/kg Steam enters a turbine with the shown conditions and exis's the turbine with quality x= 15%. If 13.4% of the turbine power is used to drive the compressor and the rest of the turbine power is sed to drive an electrical generator that needs 1.35 MW, what is the mass flow rate of the air (kg/s)? Note: Enter your answer. 1 MPa 10.0MP 700°C Answer: > < Air compressor ON L.P
The subject is thermodynamics 2
No Handwriting please
I am getting lost in this practice problem for thermodynamics - thank you! Air at 100 kPa and 280K is compressed steadily to 600 kPa and 400K in an air compressor. The mass flow rate of air through the compressor is 0.02 kg/s and the compressor a heat loss of 16 kJ/kg from the compressor occurs. Assuming steady state steady flow conditions and ideal gas behavior (with constant specific heats, Cp=1.009 kJ/kgK, R=0.287 kJ/kgK, determine: a) The necessary power in put to the compressor(kW).b) The volumetric flow rate of air at the exit of the compressor (m3/s).
3) A cup of rather dilute hot tea initially at 140 degrees F is served to a customer at Howard Johnson's. Unfortunately, before they get around to drinking it, it has spontaneously cooled off to 200 0 100 degrees F. Calculate the change in this process. The temperature of the entropy of the universe for restaurant (the surroundings) is 70 degrees F. (DHD 2/6/22) Suppose that the heat has problem 3, in order to save the inside temperature is been turned off in the HoJo's in money in the cold winter months, and 32 degrees F. The hot tea cools from HOWARD 140 degrees F to 32 degrees F, and then freezes, making it JOHNSON'S impossible to drink. What is the change in entropy of the universe in this case? (DHD 2/6/22) LCE CREAM 28 FLAVORS Restaurant Return to problem 3. Suppose that our customer complains about the cold tea and is given a second cup of hot tea. Feeling especially hungry (for tea?) they mix the hot tea and the cold tea together so that they will have twice as much tea (albeit…
Do all parts in detail