Consider a circular loop of wire of radius r lying in the xy plane, as shown in figure below. The loop contains a resistor R and a capacitor C and is placed in a uniform magnetic field which points into the page and decreases at a rate d = - –α, with dt a)0. X X X X X X X X X X X (a) Is the induced current clockwise or anticlockwise? (b) Find the maximum amount of charge on the capacitor. (c) Which plate, a, or b, has a higher potential? B X X X X R a b с X X
Q: Consider a circular loop of wire of radius r lying in the xy plane, as shown in figure below. The…
A: Magnetic field.
Q: An infinite straight wire carries current I1 = 4.3 A in the positive y-direction as shown. At time t…
A: As per guidelines we are suppose to do only three subpart from multipart questions, and one from…
Q: A long solenoid has N turns, a length L and a circular cross section with a radius R. If the current…
A: A long solenoid has N turns, a length L and a circular cross section with a radius R. If the current…
Q: Consider a circular wire loop that is getting warmer and is expanding slightly, so that its diameter…
A:
Q: circular loop of radius 5.1 cm is formed, placed with its plane perpendicular to a uniform magnetic…
A:
Q: As shown in the figure, a wire and a 10-Ω resistor are used to form a circuit in the shape of a…
A: Step 1: Step 2: Step 3: Step 4:Step 5:
Q: Consider a conducting ring of radius a and resistance R. Next, we place the ring from part a in a…
A: Given:Equation for magnetic field, B = B01-tTPower is given as, P = I2 Rwhere,R is the resistance…
Q: A circular loop of wire is placed in a uniform magnetic field pointing directly into the page, as…
A: r=1 mR=10ΩA=πr2=π m2∆B=2-0=2 T∆t=5 s
Q: The bar of length 1=20 cm, resistance 0.0005 Ohms and mass 1 kg shown in the figure slides from rest…
A: Given: Length of the bar (l) = 20 cm = 0.2 m Resistance in bar (R) = 0.0005 Ω. Mass of the bar (m)…
Q: In Fig. 5, a stiff wire bent into a semicircle of radius a = 2.0 cm is rotated at constant angular…
A:
Q: The wire loop in Figure (a) is subjected, in turn, to six uniform magnetic fields, each directed…
A:
Q: A rig of A = 100 cm ^ 2 is placed in a magnetic field that is normal to the plane of the ring. The…
A: A = 100 cm2 = 100 * 10-4 m2 B = 5sin(101t)
Q: The figure shows a conducting loop consisting of a half-circle of radius r and three straight…
A: We know that emf induced is given by ε=NAdBdt
Q: A spatially uniform magnetic field is restricted in a circular region of space with radius of 2.5 cm…
A: Given,Radius of within which the magnetic flux exist, r1 = 2.5 cmTime varying magnetic field, B =25…
Q: An infinite straight wire carries current l₁ = 3.7 A in the positive y- direction as shown. At time…
A:
Q: For a long ideal solenoid having a circular cross-section, the magnetic field strength within the…
A: The magnetic field is The electric field is The distance is
Q: Coils A and B in a magnetic circuit have 600 and 500 turns respectively. A current of 8 A in coil A…
A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…
Q: Consider a 75.0 Ohm, 5.85-cm circular loop (diameter) with 100.0 turns in the plane of the page and…
A:
Q: A rectangular wire loop with length a and width b lies in the xy-plane, as shown below. Within the…
A: →B=Cxi.coswt+y.k.sinwt
Q: Problem 7: A square loop of side length a = current that varies with time at a constant rate as,…
A:
Q: A circular loop of radius r = 0.060 m and resistance R = 0.209 is in a region where there is a…
A:
Step by step
Solved in 4 steps
- A ring of radius r = 0.24 m is made of copper wire (cross-sectional area of the wire A = 0.65 x 10-6m²). The ring is placed in a uniform magnetic field whose direction is perpendicular to the page, into the page. The magnetic field increases in time according to the equation: B = 3.0t, where B is in teslas and time is in seconds. Determine the magnitude and direction of the induced current in the copper ring at room temperature (20°C) and at -200°C. Resistivity for copper is p = 1.69 x 10-® Nm and the temperature coefficient of resistivity for copper is a = 3.86 x 10-3 хх x x X X x X ххA single circular loop of wire , radius = r , with a resistance , R , sits above a series of moving magnets . The magnets pass underneath the stationary loop of wire creating a periodic magnetic field given by the function : B=B0 (sin( omega t))2 B0 is the maximum magnetic field , and w is the angular frequency . Derive the function for induced current in the circular loop of wire as a function of timeA conducting rod slides on a conducting track in a constant B field directed into the page. What is the direction of the induced current, if any? The current is induced in a clockwise direction. No current is induced. The current is induced in a counter-clockwise direction. None of the other responses are correct.
- The plane of a flat, circular loop of wire is horizontal. An external magnetic field is directed perpendicular to the plane of the loop. The magnitude of the external magnetic field is increasing with time. Because of this increasing magnetic field, an induced current is flowing clockwise in the loop, as viewed from above. What is the direction of the magnetic field, assuming the situation is drawn on a sheet of paper? Tind O Left O Right O Into the page O Out of the page O Up the page O Down the page O Clockwise O CounterclockwiseA loop of wire sits in a uniform magnetic field, everywhere pointing toward you. Due to a changing magnetic flux through the loop, an induced current flows in the wire, clockwise as shown. The area of the loop is 0.300 m^2 , and the magnetic field initially has magnitude 0.300 T. Suppose that, over a time period of 2.30 s, the magnetic field changes from its initial value, producing an average induced voltage of 0.020 V. What is the final value of the magnetic field after this time period?A neurologist is using a device, with a thin circular coil of current-carrying wire of radius 1.3 mm, to stimulate neurons in a patient's brain. The coil is placed directly against the patient's skull, anc everywhere within the area of the coil, the magnetic field changes from zero to 1.50 T (perpendicular to the plane of the coil) in 100 ms. What is the magnitude of the average emf induced around the circumference of this circular area in the brain? Express your answer in units of mV. mV Need Help? Read It Submit Answer
- An infinite straight wire carries current I1 = 4.3 A in the positive y-direction as shown. At time t = 0, a conducting wire, aligned with the y-direction is located a distance d = 41 cm from the y-axis and moves with velocity v = 14 cm/s in the negaitve x- direction as shown. The wire has length W = 15 cm. 1) What is ɛ(0), the emf induced in the moving wire at t = 0? Define the emf to be positive if the potential at point a is higher than that at point b. V Submit 2) What is ɛ(t,), the emf induced in the moving wire at t = tj = 2 s? Define the emf to be positive if the potential at point a is higher than that at point b. V Submit 3) The wire is now replaced by a conducting rectangular loop as shown. The loop has length L = 56 cm and width W = 15 cm. At time t = 0, the loop moves with velocity v = 14 cm/s with its left end located a distance d = 41 cm from the y-axis. The resistance of the loop is R = 1.7 Q. What is i(0), the induced current in the loop at time t = 0? Define the current…A uniform magnetic field B is perpendicular to the plane of a circular wire loop of radius r and with resistance R. The magnitude of the field varies with time according to B = B0e-t/T, where B0and T are constants (T is time constant). (a) Find an expresssion for the emf induced in the loop as a function of time. (b) If the loop lies in the plane of the page and the magnetic field initially points out of the page, then what is the magnitude and direction of the induced current in the loop, i.e., is it clockwise, counter-clockwise, or is there no current induced in the loop? Include a diagram for this situation.Consider a conducting ring of radius a and resistance R. Next, we place the ring from part a in a time-varying magnetic field given by B = B. (1 – (1-) 0