Consider a BSC with error probability of 0.2. Answer the followin 1- Draw the channel model 2- Find the channel matrix of the channel 3- Find P(y,) and P(y2) if I(x1) = 1 bit 4- Find the joint probabilities P(x1,Y2), P(x2,Y1) 5- Find the channel capacity, efficiency and redundancy.

Q: a. If a periodic signal is decomposed into five sine waves with frequencies of 250, 300, 500, 850,…

A: To find the bandwidth, lowest and highest frequency.

Q: If register R1 = Ox89674523, then RO value after the following instruction was executed is given by:…

A: Given:  Register R1 = Ox89674523  ORN R0, R1 ,#0xA5A5C3C3    The value of R0 after the following…

Q: Design a code converter that converts a decimal digit from1. (a) The 8, 4, − 2 , − 1 code to BCD…

A: According to the information given:- We have to follow the instruction and develop and simulate an…

Q: The joint probability of channel is defined as: P(x1, y1)=0.25, P(x1, y2)=0, P(x2, y1)=0.3, P(x2,…

A: Joint and Conditional Entropies: Joint (system) entropy is the average amount of information…

Q: Example: Logical AND Gate X1 X1 X2 B Y W 1. 1 1 1 X2 1 -1 1 -1 1 -1 -1 -1 1 -1 b-1 Where X1, X2 are…

A: In the below steps you can find the complete python code.

Q: Show that the overall the noise figure of a system comprising three 2-port networks connected in…

A: If  the blcok are impedance matched properly, the gain G                            G=G1 G2for each…

Q: Q.1: A binary symmetric channel with error probability of 0.3 and marginal entropy H(y)= 0.97095…

A: For answer (i) Attached image below:

Q: (25M) Consider the analog signal x,(t) =3cos(100 a t) + sin(150 t). a) Determine the minimum Fs to…

A:

Q: TASK 1 a) Chanel bandwith is 4 kHz. The signal is sampled every 0,5 ms. The noise ratio is SNR=30…

A: In telecommunications, it is crucial to know how fast data can be transmitted over a given…

Q: Consider a noiseless channel with a bandwidth of 8 KHz. If we want to transmi 24 Kbps on this…

A:

Q: For SNR of 12.33 dB and signal power .4 of 22.23 mW, the value of noise power :is 1.3 mW O 0.3 W O…

A: Formula=SNR=Signal power/ Noise power Given SNR in dB so we will first convert it into normal.…

Q: Problem 5 In a CDMA system, the spreading sequences for the orthogonal code include W₁=[1 1 -1 -1 1…

A: CDMA and Orthogonal Codes: CDMA (Code Division Multiple Access) is a communication technique that…

Q: Q1. Consider a (7,4) linear block code defined by the parity check matrix as [1 1 1 0 1 0 01 1 10 1…

A: Ans v:- Syndrome test        r→receivedcodewordr=crHT=CHT=0        (C+e)HT=CHT⊕eHT=eHT…

Q: Multilayer Perceptron Draw a 2-3-4-1 multilayer perceptron network that shows its weights with bias…

A: ANSWER: Multi layer Perceptron: Multi Layer perceptron characterizes the most mind boggling…

Q: 7.4. Let x(t) be a signal with Nyquist rate wo. Determine the Nyquist rate for each of the following…

A: The Nyquist rate is a fundamental concept in signal processing that determines the minimum sampling…

Q: Q1/A/ DM system is designed to operate 3times the Nyquist rate for a signal with a 3KHZ Bandwidth…

A: Provided the solution for both the above given questions, with detailed step by step explanation as…

Q: Problem 3 The modulating signal m(t) = 4 cos(200t) cos(400nt) is multiplied by the carrier c(t) =…

A: Since you have asked multiple question ,we will slove the first question for you .If you want any…

Q: b)how does FWHM apply to an led s characteristics? c) draw the cross sectional view…

A: ANSWER: FWHM apply to an led s characteristics: In the field of LED illuminated presentation, the…

Q: Problem 3. We are transmitting our 12/4 APSK signal with outer ring voltage 10 Volts and inner ring…

A: Problem 3. We are transmitting our 12/4 APSK signal with outer ring voltage 10 Volts and inner ring…

Q: explain in terms of complexity (i.e. using asymptotic analysis) the differences between the direct…

A: The solution for the above given question is given below:

Q: (Compute the maximum channel utilization for a MAN which uses CSMA mechanism and has a length of 50…

A: Introduction :Given , A MAN , uses CSMA mechanism Length = 50 Km Bandwidth = 50 Mbps Frame size =…

Q: 2. Assume that an HF communication link between two points on earth at a distance of 2500 km is to…

A: Refer to the solution:

Q: In the Maxwell bridge shown in Figure2, let the fixed-value bridge components have the following…

A: For the given Maxwell bridge we need to find unknown Inductance , resistance and quality factor.

Q: The periodic signal x(t) = sin (2πt) is sampled using the rate fs = 5 Hz. The sampled signal is…

A: The periodic signal x(t)=sin(2pit)is sampled using rate fs=5Hz the sampled signal is x(T)=sin(0.5pi…

Q: determine SNR?

A:

Q: Question. 1(c): If the analog signal travels over a medium and its measured attenuation is 12.5 dB…

A: Equal level far end cross talk is calculated by subtracting the attenuation for the disturber pair…

Q: Determine Vo and lo for the network shown below. Please note to change the voltage s to 9V. -5V =t=…

A: assume Vt of silicon diode to be 0.7

Q: e maximum capacity of the channel.

A: Solution  part (a)  :- In the mentioned question (part a) , given parameters are mention as…

Q: y(n) x(n) + 1 sample delay 1.3 -1.2 1 sample delay -0.6 0.5 What difference equation corresponds to…

A:

Q: Q2: Consider a noisy information system has a bandwidth B Hz, maximum channel capacity C bps, and…

A: C = B log21+S/N Now, since signal capacity = 0.5 of Nyquist capacity => 0.5C = B log21 + S/N

Q: a) For amplitude modulation (AM) i) ii) iii) Write the time domain equation for AM signal XAM(t).…

A: According to the question, we have to Write the time domain equation for AM signal XAM(t), Write the…

Q: 8. Show using diagram the contents of the six output frames for a synchronous TDM multiplexer that…

A: From the diagram given below, there are typically four inputs to  the multiplexer A. Each of the…

Q: e whole dataa

A: I have Plotted below using MATLAB as given in the question:

Q: Q7/Chose the correct data input for 4-1 multiplexer that used to Design the switching network F…

A:

Q: 6. Translational Mechanical System: Find the transfer function G(s) = X₂ (s)/ F(s) for each…

A: Machines that are capable of translational motion do so in a linear fashion. There are essentially…

Q: data of 700 kbps is to be transmitted over a channel of 5 kHz bandwidth and 200 kbps capacity. The…

A: Bandwidth B = 5 kHz Data Rate, C = 700 kbps

Q: (d) Consider a cable with a bandwidth (H) of 2 MHZ and a signal-to-noise ratio (S/N) of 63. (i)…

A: We need to find maximum bit rate and reason of system fail.

Q: a. Find the minimal cost path from I to U in the following network using Dijkstra's link state…

A: