2) Consider a beam subjected to 2 point loads below. Assuming that the cross section is consistentthroughout the beam, determine the maximum tensile and compressive stress and their locations,both relative positions on the beam and on the cross-sectional area.Hint: From the formula of normal stress, for a cross-sectional area with symmetry about neutralaxis, the maximum stresses will be locate at place where maximum bending moment is inrelation to position on the beam. (Learning Activity: L07)3 m300 kN2 m+2 m60 KN30 cm 10 cm 30 cm.12 cm60 cm12 cmCross Sectional Area

solution ⇒ consider the free body daigram of of the beam Ax and Ay are the reaction forces at the…

Answered: Consider a beam subjected to 2 point…

Consider a beam subjected to 2 point loads below. Assuming that the cross section is cons throughout the beam, determine the maximum tensile and compressive stress and their loca

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

I need the answer as soon as possible
i need the answer quickly
A metal block (E = 60 GPa and Poisson's ratio of 0.35) rests on a rigid surface as shown below. It has uniformly applied loads which results in uniform stresses on the surfaces as shown. Assuming a compressive stress of 200 MPa along x-direction, determine the magnitude of stress oy for which the change in the height of the bock will be zero, (b) the corresponding change in the area of the face ABCD, and (c) the corresponding change in the area of the volume of the block. 40 2 100mm 25mm
A steel pipe is subjected to the 16-kN load shown below. Its outside diameter is 140 mm and its thickness is 7 mm. Consider that the yield strength of steel is 240 MPa. Analyze point H ONLY. Due to the pressure in the pipe, there is an 11.25-MPa (T) normal stress along x and a 22.50-MPa (T) normal stress along z of point H. A. Determine the internal forces and moments at the pertinent section through an FBD. B. Determine the stresses experienced by point H. Illustrate using a stress element. C. Determine the FS by MSST at point H D. Determine the von Mises equivalent stress at point H E. Determine the FS by MDET at point H 700 mm 16 KN 1,300 mm
i need the answer quickly
Please fast answer
Question 2. Determine the principal stress, the maximum in-plane shear stress, and average normal stress. Specify the orientation of the element in each case. 20 MPa 80 MPa 30 MPa
Please solve quick
Derive the Bending Stress Formula
Problem 2 The rigid bar is plnned at A and held by two flexible bars at E and C. The load P Is applled at B. The two flexible bars FE and DC each have a diameter of 1 In. The flexible bars are elastic- perfectly plastic with a yleld stress equal to 20 ksl and a yleld strain of 0.001. Determine the following: The load R, at first yleld and the corresponding deflection at B, &, The ultimate load Pu and the corresponding deflection du The permanent deflection and residual stresses in each rod if the ultimate load is removed Construct P - A curve showing yield, ultimate and permanent deformation o (ksi) 1 ft E F 1 ft1 ft 20 B P e (in./in.) 0.001 1 ft D 2 ft 1 ft A
3. For the given state of stress, determine the principal planes, the principal stresses, the max shear stress. You must use Mohr's Circle. 20 MPa 32 MPa 55 MPa
Write the equation for finding the principal stresses