connected to the beam a distance L = 5.0 m from the wall, at an angle 0 = 30° as shown in the sketch. The beam is bolted to the wall with an unknown force F exerted by the wall on the beam. An object of mass m2 = 6.0 x10¹ kg, resting on top of the beam, is placed a distance d = 1.0 m from the wall. L Ꮎ a. Find the tension in the cable. b. Find the horizontal and vertical components of the force that the wall exerts onto the beam.

connected to the beam a distance L = 5.0 m from the wall, at an angle 0 = 30° as shown in the sketch. The beam is bolted to the wall with an unknown force F exerted by the wall on the beam. An object of mass m2 = 6.0 x10¹ kg, resting on top of the beam, is placed a distance d = 1.0 m from the wall. L Ꮎ a. Find the tension in the cable. b. Find the horizontal and vertical components of the force that the wall exerts onto the beam.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The see-saw is balance.d What is the magnitude of the weight of the person hanging off the edge? 4m- 2m. LIST = N 11 WT-500 N
A 40.0kg uniform platform is suspended by two cables, 2.00m apart, where the centre of the platform lies midway between the cables. A 5.00kg paint bucket is placed on the platform, 24.0cm to the right of the right cable. Determine the tension in each cable.
A 15.7 m long board is supported from beneath at two locations. One is at the far left end of the board. The other is 1.2 m from the right end of the board. The board has a mass of 39.7 kg. What is the normal force (in newtons) applied by the right support?
F. y M. mg AF FY f.Y Fixle Axis The ladder in the picture has a mass of 39 kilograms and a length 3.4 meters. What is the normal force pushing the ladder up from the floor? This force is labeled Ff v in the picture. FN Assume that the ladder's weight is evenly distributed, so it can be treated as a single force through the middle. If the ladder is at a 70° angle from the ground, what is the torque exerted by the weight (using the floor as the pivot point)? N.m The torque from the ladder must be balanced by the torque caused by the normal force on the wall, labeled Fw in the picture. Calculate this force. Fw = The normal force from the wall must be balanced by the friction force from the floor, labeled Ff y in the picture Determine thn
A beam of length 11 m is supported as shown below. There is a pin in the bottom end of the beam and a mass hanging from the top end of the beam. If the mass of the beam is mb =264 kg, the hanging block has a mass of m1 =81.8 kg, theta = 50.1 degrees, and phi = 35.1 degrees, what is magnitude of the tension in the wire attaching the beam to the ground?
How do you do this? A hungry bear weighing 700 N walks out on a beam in an attempt to retrieve a basket of goodies hanging at the end of the beam (see figure below). The beam is uniform, weighs 200 N, and is 6.00 m long, and it is supported by a wire at an angle of ? = 60.0°. The basket weighs 80.0 N. a) When the bear is at x = 1.00 m, find the tension (in N) in the wire supporting the beam and the components of the force exerted by the wall on the left end of the beam. b) If the wire can withstand a maximum tension of 875 N, what is the maximum distance (in m) the bear can walk before the wire breaks?
Problem: A 80 kg construction worker is sitting 2.0 m from the right end of a 1450 kg, 6.0 m long beam. What is the tension in the cable attached at an angle of 30 deg. from the beam? (A) Pictorial Representation (B) Physical Representation
17 kg uniform store sign is held from a uniform horizontal beam as shown. There is a cable attached to the right edge of the beam and is secured to the wall, 250 cm above where the beam meets the wall. The sign is symmetrically suspended by two cords, the left cord being 80 cm from the wall, and the cord on the right being at the right edge of the beam, 200 cm from the wall. a. What is the tension in the left and right cords that hold the sign? b. What is the tension in the cable? c. What is the horizontal component of the force that the wall exerts on the beam?
35.0° Dinysics Demos SuDDly Co. The pole is held horizontally by a massless wire under 305 N of tension, connected at a 35° angle. A 8 kg sign hangs from the end of the 4 meter pole. The pole has mass 4 kg. How far away is the wire is attached from the wall? Answer in meters to 3 sig figs.
Problem 5: Fr Fm Bone -Muscle 100 30 cm W 4 cm 40 cm A simplified model of a human arm holding a weight is shown on the right. The length of the forearm is 40 cm and it has a mass of 1.7 kg. The bicep muscle is attached 4 cm in from the elbow joint and makes an angle of 73° with the forearm. The weight in the person's hand has a mass of 5 kg. a) What is the magnitude of the force provided by the bicep muscle needed to keep their arm at rest? b) What is the magnitude and direction of the force acting at the elbow (F;) in that same case?
A 2.99 m long ladder that has a mass of 5.84 kg leans against a frictionless wall. The coefficient of static friction between the ladder and the floor is 0.589. What is the maximum angle that the ladder can make with the floor without slipping if a 87.6 kg person stands half-way up the ladder? θ = °
3: #3 4. A 115 kg scaffold is 6.60 m long. It is hanging with two wires, one from each end. A 600 kg box sits 1.70 m from the left end. What is the tension in the right hand side wire?(g = 9.8 m/s²) X 4929 Newtons E D 80 F3 C 5. An object weighing 255 N is supported by a uniform 135 N horizontal beam as shown in the figure. The length of the 4 R F F4 V do 50 % T F5 G ^ 6 B tv MacBook Air Y H & 7 N AA F7 U J * 00 8 M DII F8 1 K DD F9 О F10 P 10 zoom C { + ISOIT P by m 04 M vamies or roe puffer F12 delete 1 EL