concrete lined rectangular channel 5.5 m wide carries water at a rate of 10 m3 /s. Calculate the minimum specific energy in meters if the channel bed is having a slope of 1 in 2000. Take Manning’s constant N = 0.01. a. 0.696 b. 1.044 c. 0.216 d. 2.613

concrete lined rectangular channel 5.5 m wide carries water at a rate of 10 m3 /s. Calculate the minimum specific energy in meters if the channel bed is having a slope of 1 in 2000. Take Manning’s constant N = 0.01. a. 0.696 b. 1.044 c. 0.216 d. 2.613

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The area within the contour line at the site of reservoir and the face of the dam are as under -…

A: Area of contour line at the reservoir and the face of the dam:-S.No.contour…

Q: At a section in a channel expansion, the velocity over 25% of the cross-section is zero and it is…

A: Velocity over of cross section is zero.The remaining area has uniform velocity.To find: Momentum…

Q: 1. COMBINED CORRECTIONS. A line was determined to be 2395.25 m when measured with a 30-m steel tape…

Q: 3. The figure shown is a frustum of a cone with an orifice in the bottom of 0.20 m². If the water…

Q: 13 KN 27 KN/m 86 KN/m 1.71 m 3.79m B. 6.53 m 3.42 m

A: Step 1

Q: A hemispherical tank diameter 4m contains water up to a height of 2.0m. An orifice of diameter 50mm…

Q: Who prepares the Daily Construction Report?

A: Sight engineer should maintain the construction dairy. He will see all the requirements in the site.

Q: Water is flowing through an inclined aquifer (a=10°) as shown in the following figure. The depth of…

Q: Q:- Find the forces exerted by water on a Im width of The surface of the dam shown in figure and the…

Q: 11.10 (A/B). A load of 2 kN falls through 25 mm on to a stop at the end of a vertical bar 4 m long,…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: A rectangular tank 3 m long, 1.40 m wide and 1.80 meter high contains oil with specific gravity of…

Q: w A В 1.2 m 3.6 m 0.8 m

Q: The stream channel and floodplain shown has overbank Manning's n of O.10 and channel n = 0.030. The…

A: We are required to calculate the energy coefficient

Q: A laminar flow flows around the plate as shown in the figure. puox Recr. = 5x105 showing the…

A: Given data:- Critical Reynolds number showing the transition from laminar flow to turbulent flow;…

Q: 35 KN 60 KN/m 37 KN/m 3.60 m A 6.74 m 1.59 m B

Q: ne pressure p, in а. 37.0 b. 40.0 C. 45.2

A: Pressure at p is writing pressure equation as shownP+γw(30cm)-γHG(30cm)=Patm

Q: A horizontal reducing bend deflected at 110° has a diameter of 250mm upstream and 100mm downstream.…

A: Given Specific Gravity of fluid= 0.90

Q: A cylindrical water tank has a height of 6 m and a radius of 4 m. How much work is required to empty…

Q: 27. An open tank contains 5.7 m of water covered with 2.8 m of kerosene (y = 8.0 kN/m³). Find the…

A: Given:Height of water in the tank=5.7 mHeight of kerosene in the tank=2.8 mspecific weight of…

Q: The bottom width of a trapezoidal canal is 2.5 m and its sides are both inclined at 60° with the…

Q: 1. COMBINED CORRECTIONS. A line was determined to be 2395.25 m when measured with a 30-m steel tape…

A: Given data, L = 2395.25 m NL = 30m Pm= 4kg T = 35 °C Ts = 20°C Ps = 5kg A = 0.03 cm² C =…

Q: 17. An open cylindrical tank 4 m in diameter and 10 m high contains 4 m of oil sg = 0.9. An orifice…

A: The objective of the question is to calculate the time required to discharge all the oil from a…

Q: The rectangular channel shown in the following figure has a width of 11 ft and transports water at…

A: The total of the kinetic and potential energies per unit weight of the fluid determines the specific…

Q: 17. An open cylindrical tank 4 m in diameter and 10 m high contains 4 m of oil sg = 0.9. An orifice…

Q: SITUATION. A closed cylindrical tank with 0.60 m diameter and 1.0 m height is fully-filled with…

Q: energy line is 2, calculate the value of slope of energy line if the length of back water curve is…

A: To find : Slope of energy line.

Q: A reservoir contains water has a vertical circular orifice 25.2mm diameter and is first plugged up…

A: Given : H = 2.785m QL = 141 lt/min = 2.35 × 10-3 m3/sec Cc, Cv, and Cd are the hydraulic…

Q: The dam shown in the diagram at the right is constructed of a homogeneous clay material with a…

A: Given Hydraulic conductivity= 1×10-6 m/s

Q: For the given frame below, determine the following: v in kN.m 1. Determine the fixed end moment at…

Q: A water reservoir of 300 (Height) x 300 (width) x 500 (depth) m has its free surface at 250 m above…

A: Height of reservoir = 300m Width = 300m Depth = 500m Dia of orifice = 500mm Coefficient of…

Q: A rectangular pontoon is 5 m long, 3 m wide and 1.40 m high. The depth of immersion of the pontoon…

Q: The rectangular channel shown in the following figure has a width of 10 ft and transports water at…

A: Given data,width =10 ftQ=19,229 ft3/minelevation of the channel bed drops by 0.75 ftFINDspecific…

Q: Figure P8.19 shows a pipeline through which water flows at a rate of 0.06 m3/s. The pipe is 3000 m…

A: The given figure is shown below:

Q: For the system below, EI is constant. If x = 9.48 m from point A, determine the value of EI(Δ) ?…

A: Step 1

Q: SITUATION 2 Consider a 200-ft-high, 1200-ft-wide dam filled. 3. Determine the hydrostatic force on…

Q: lop a head h = plem. (a) What s operating at %3D

Q: 9. The depth and widths of a trapezoidal channel section are 2m and 4m respectively and the side…

A: calculate the rate of change of depth

Question

A concrete lined rectangular channel 5.5 m wide carries water at a rate of 10 m3 /s. Calculate the minimum specific energy in meters if the channel bed is having a slope of 1 in 2000. Take Manning’s constant N = 0.01.

0.696

1.044

0.216

2.613

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the pressure in a vessel of mercury (sp.gr. = 13.6) at a point 300 mm below the surface in kPa. a. 40.02 kPa b. 46.68 kPa C. 40.86 kPa O d. 42.02 kPa
A cylindrical tank with a large diameter is filled with water to a depth D = 0.416 m. A hole of cross-sectional area A = 7.83 cm? in the bottom of the tank allows water to drain out. (a) What is the rate at which water flows out, in cubic meters per second? (b) At what distance below the bottom of the tank is the cross-sectional area of the stream equal to one-half the area of the hole? (a) Number i Units (b) Number i Units
Question 22 of 23 A rectangular channel 9 m wide carries 7.65 m3/s when flowing 0.90 m deep. What is the critical velocity? Select the correct response: 3.87 3.41 2.03 4.15
7
9.14 If the upstream velocity of the flow in Problem 9.13 is U = 1.5 m/s, determine the kinematic viscosity of the fluid. 9.15 Water flows past a flat plate with an upstream velocity of U = 0.02 m/s. Determine the water velocity a distance of 10 mm from the plate at distances of x = 1.5 m and x = 15 m from the leading edge.
Determine volume of solids in cm3. a. 9.77 b. 53.6 c. 20.0 d. 18.23
3 m water 8 m Pconerete= 2200kgm* wwww 6 m The dam shown in the figure is built of concrete having a density of 2200 kg/ m3 and rests on a solid foundation. Determine the minimum coefficient of friction between the dam and the foundation required to keep the dam from sliding at a water depth of 6.8 m. Assume that the dam is 100 m into the page. Your Answer:
Water flows at 2 m / s in a 3 m wide 2.5 m deep rectangular channel. There is a 1.10 m elevation on the downstream side of the channel as seen in the figure. Above the elevation, the channel widens to 3.75 m as shown in the figure If b2 = 3.75 m, what should be the maximum value of Δz to prevent suffocation? Draw the specific energy depth curve.
Water of density ρ flows in an open channel of constant width w with an initial depth of H1. At some point, the bottom rises smoothly to a height H3 and the depth of the water decreases to H2, as shown in Figure P10.18. If the upstream Froude number F1 = 0.4, and the downstream Froude number F2 = 1.0: (a) Find H2/H1 (this is a number). (b) Find H3/H1 (this is a number). (c) Find the force Fx exerted by the water on the step in the horizontal direction. Express the result in terms of the non-dimensional force coefficient using ρ, g, w, and H2 (this is a number). Show all your working, and state all your assumptions. Viscous forces can be neglected.
For the system below, EI is constant. If x = 3.16 m from point A, determine the value of EI(Δ) ? If x = 8.43 m from point A, determine the value of EI(θ) ? If x = 6.41 m from point A, determine the value of EI(Δ) ? If x = 5.70 m from point A, determine the value of EI(θ) ?
Problem 4. A 2-mm-diameter tube is used to siphon water at 20° C from a tank. When the tube length is 1 m, is there a value for H that exceeds the limit for laminar flow? If the maximum H = 75 cm, what would be the maximum flow rate? Neglect losses due to curvature and entrance effects. L=1m,d=2mm Water at 20°C H
Pls answer in 3 decimals