Compute the average end volume (in cubic yards - yd') using the figure below: Sta 25+00 2,356 3,336 2,875 2,502 Sta 25+75 107' A₁ 125' 111' A₂ 131' elev = 102.9 elev = 95.4 elev = 102.5 elev = 94.8

Q: Q: A not to scale sketch illustrating a theodolite measuring the top of a shed shown below with the…

A: Given data in question  Slope distance 264.948 m Horizontal angle 215°52`28`` Vertical angle…

Q: Station 12+62 (elevation = 1062.14') Station 27+10 (elevation = 1120.90') Compute the slope of the…

A:

Q: The following data were obtained by stadia observation: zenith angle = 81° 50', s = 2.50 ft. The…

A:

Q: A drawbridge is being raised by a cable El. The four joint loadings shown result from the weight of…

A:

Q: What is the correct way for me to report (50kN)(60nm)

A: Correct way to represent kilonewton (SI unit of force measurement) is kN.so, 50 kN is correct.

Q: Problem #4 Compute for the resultant of the given Parallel system and its relative position from…

A: Determine the resultant of the load and it's relative position from point A.

Q: To edit and save, sign in with a subscription. • Solve this frame using Slope-Deflection Method. •…

A:

Q: Find intermidiate elevation

A: ###Finding Elevation of Intermediate Point C ###

Q: NE 320 SUUNTO MS 00 90 SO YO CO 00 MN

A: It is quadrant bearing compass by the observation of the readings.

Q: (b) The data from a levelling survey are shown in Table Q2. Using the rise and fall method,…

A: reduced level - Height of point from means sea level is called R.L. Benchmark - its is the fixed…

Q: Find x and y

A: We will divide the given C-section into three sections as shown in the figure:

Q: 3. Complete the calculations tabulated below. Perform a check on the ending elevation of BM 3055.…

A: Solution:- The complete calculation is shown below in the table.

Q: Problem Statement Based on Problems 10-32/33 from the textbook. Determine the moment of inertia of…

A: Given,  a = 145 mm b = 95 mm Diameter = 150 mm

Q: Convert to degree minutes and seconds (DMS): -132.8043°

A: Surveying Degree Minutes Seconds

Q: Problem 2: The difference in elevation between observed points A and B is 25m and the horizontal…

A:

Q: 5.11 for the element Shown the feger Arome the Shear Stress is (+) clocbuse to a sing MOHRS CIBELE,…

A:

Q: 2.87 m 2.87 m 17.00 kN 17.00, kN 14.00KN/m Toucere to eet I I 4.10 m 4.10 m

A:

Q: 3.24 Refer to the 15-ft high embankment shown in Figure 3.8. Embankments are generally constructed…

A: Given information:

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.