Answered: Compute for the resistance, in… | bartleby

Related questions

Question

Compute for the resistance, in nanoohms, of a copper resistor in the shape of a cylindrical shell carrying 8-ampere radial current. The dimensions of the cylinder are measured as
follows: 8.58 cm for the inner radius, 16.74 cm for the outer radius, and 0.49 m for the length.

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Figure a shows a rod of resistive material. The resistance per unit length of the rod increases in the positive direction of the X axis. At any position x along the rod, the resistance dR of a narrow- differential-section of width dx is given by dR = 5.00xdx, where dR is in ohms and is in meters. Figure b shows such a narrow section. You are to slice off a length of the rod between X = O and some position = L and then connect that length to a battery with potential difference V = 5.0V (Fig. c). You want the current in the length to transfer energy to thermal energy at the rate of 6.2 W. At what position x = L in meters should you cut the rod? Keep 2 decimla points in your aanswer. dx 1.0 -x (m)
A material of resistivity p is formed into a solid, truncated cone of height h and radii r₁ and r2 at either end. Calculate the resistance of the cone between the two flat end faces.
A capacitor of 7.99 µF is discharged through a resistor of resistance R. The time constant of the discharge is 5.6 space cross times space 10 to the power of negative 3 end exponent s Calculate the value of R.
What are the expected readings of the following in the figure below? (R = 9.10 Q, AV = 6.20 V) A R Δν 10.0 N + V 5.00 N + 4.50 V (a) ideal ammeter (Give your answer in mA.) (b) ideal voltmeter (Give your answer in volts.) V (c) What If? How would the readings in the ammeter (in mA) and voltmeter (in volts) change if the 4.50 V battery was flipped so that its positive terminal was to the right? ideal ammeter ideal voltmeter V
If R is the total resistance of three resistors, connected in parallel, with resistances R₁, R₂, R3, then 1/2 = 1/₂+1/2+1/3 R R₁ If the resistances are measured in ohms as R₁ = 64, R₂ = 82, and R3 = 42, with a possible error of 0.5% in each case, estimate the maximum error in the calculated value of R. (Round your answer to three decimal places.) .005 x 22
The conductance G of an object is defined as the reciprocal of the resistance R; that is, G = 1/R. The unit of con- ductance is a mho (= ohm'), which is also called the siemens (S). What is the conductance (in siemens) of an object that draws 440 mA of current at 3.0 V?
Subject:- physics
Please asnwer all parts of the one problem: Consider the three resistors R1 = 17 Ω, R2 = 41 Ω, and R3 = 71 Ω in the configuration shown in the figure. A potential difference ΔV = 4.5 V is applied between A and B. Part (a) Calculate the numerical value of the total resistance R of this circuit, in ohms. Part (b) Calculate the numerical value of the current I traveling from A to B, in amperes. Part (c) Calculate the numerical value of I2 traveling through the resistor R2, in amperes. Part (d) Calculate the numerical value of I3 traveling through the resistor R3, in amperes.