Compare between Disk brake and drumbrake based on the following Ractors.brake factorlucerporabion af parking brake features.Consis reucyln tolgue perfannce.Athuation ekfeatAll wheel drive vehides.

Answered: Image /qna-images/answer/510cc60c-6504-40c4-948d-6fe19d03414d.jpg

Compare between Disk brake and drum brake based on the Pallowing factors. brake factor lucecporabion of parking brake features • Consisteucy in tolque pedarmuce. Atnsetion effeab All wheel drive vehides

Compare between Disk brake and drum brake based on the Pallowing factors. brake factor lucecporabion of parking brake features • Consisteucy in tolque pedarmuce. Atnsetion effeab All wheel drive vehides

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The advantages and disadvantages of disc brake systems are being discussed. Technician A says that…

A: 1. B) B only Technician B says that reduction of mechanical fade and gas fade is an advantage of…

Q: what is the disadvantage of dynamic brakes when compared to mechanical brakes?

A: Mechanical brakes uses the application of friction in order to slow the vehicle or completely stop…

Q: In a typical drum brake, which component provides afoundation for the brake shoes and…

A: Given Data : Typical drum brake

Q: Asbestos has not been used in brake linings or pads since 2003. a. True b. False

A: Under federal law, asbestos brake production is supposed to stop in 1993 and auto manufacturers are…

Q: SHL P Type here to search <-CFD-Hue Pape cice E Ⓒ1038 Question 11 S ACal Can X A Which of the…

Q: An ABS modulates brake pressure. What does this mean

A: In normal braking system when we apply brakes then the wheel gets locked and wheel starts skidding.

Q: Technician A says that a malfunction of the ABS causes the control module to shut off or inhibit the…

A: The system will be shut down if any malfunction is monitored in the ABS because the control module…

Q: Explain the operation of an integral drum brake parking brake.

A: The integral brake is a parking brake that is on the inside of a disk brake system. Cables are used…

Q: Which of the following is not a factor in determiningthe effectiveness of a brake system?a. Heat…

A: Given Data : Effectiveness of brake system

Q: Explain the operation and maintenance considerations for the foot brake assembly from the Harrison…

A: Given Foot Brake To find Operation Maintenance

Q: A close-coiled helical spring has stiffness of 10 N/mm. Its length when fully compressed with…

A: Springs are one of the flexible machine elements, which gets deformed when load is applied to it and…

Q: Required Informatlon The figure shows an Internal rim-type brake having an Inside rim diameter of…

A: Write the given data. r=300 mm2=150 mm R=125 mm b=40 mm a=125 mm F=1.8…

Q: When examining disc brakes: Technician A visually inspects the rotor and says that the rotor can be…

A: Technician A is correct.

Q: Name the two methods of attacking brake lining materials to the brake shoes.

A: Given Data : Break lining materials Assumptions made in solution : In solution, it is assumed that…

Q: caliper failed due to static load or cyclic load?

A: Brake calipers is failed due to cyclic load.

Q: if you read the scan codes on the vehicle and U0121 was standa for lost communication with antilock…

A: Solution::: == The U0121 code stand for Data bus: anti-lock brake system (ABS) control module - no…

Q: Technician A says that a malfunction of the ABS causes the control module to shut off or inhibit the…

A: Automobile

Q: When replacing brake pads on a vehicle: Tech-nician A works on one wheel before beginning work on…

Q: A short-shoe drum brake having f= 0.25, a = 1.0 m, b = 0.4 m, c = 50 mm, and r= 0.3 m is to absorb…

Q: What is likely to happen if tyres of a different rolling diameter are used on the front and rear of…

A: Questions: What is likely to happen if tyres of a different rolling diameter are used on the front…

Q: A P195/75R14 tire classification includes both metric and English standard measurements. True…

A: The standardization of the tires are required because of replacement again and again.

Q: Wheel speed sensors provide different output, name the different types of sensors and describe their…

A: Wheel speed sensor: It is sensor is a type of tachometer that is used to measure the rotational…

Q: When performing the air brake system leakage test, the Certified Inspector must reject the vehicle…

A: Answer = False

Q: Technician A says that the front bearing assembly locknuts for RWD vehicles are typically heavily…

A: A high torque for maintaining the bearing adjustment is required in the FWD vehicles and not the RWD…

Q: Disc brakes are not as likely to fade during heavy braking as are drum brakes. True OR False?

A: Given Data : Disc Brakes Drum Brakes

Q: The purpose of the master cylinder is to

A: The master cylinder, also known as the master brake cylinder, converts the pressure on the brake…

Q: what is the cause of an extremely hard brake pedal

A: To the left of the accelerator, the brake pedal is positioned on the floor. It applies the brakes…

Q: explain the difference between a passive and active suspension system. in your answer, refer to both…

A: Introduction: Active suspension systems (also known as Computerized Ride Control) include the…

Q: After replacing a vacuum booster, the brakes lock up on a road test. Technician A says there is air…

A: After replacing a vacuum booster, the brakes lock up on a road test. Technician A says there is air…

Q: fferent parts of the brakes system of an off-road bicycle

A: introduction In the marine and seaward industry, plan and hardware setups fluctuate from one…

Q: Describe the procedure for using compressed air to remove a piston from a brake caliper.

A: Sometimes piston sticks in the bore in a disk brake.

Q: The rotating yellow part is

Q: Tech a states That serviceable and seated bearings are the two typical design categories of…

A: Automotive wheel bearings It's allows wheel to roll with minimum friction. There are two categories…

Q: Which of the following is not likely to cause a pulsating brake pedal? a. Loose wheel bearings b.…

A: When a load or side thrust is applied to the bearings, loose wheel bearings allow the rotor to tip…

Q: Unequal SAI angles on the left and right sides of thefront suspension may cause __ .a. tread wear on…

A: All the suspension system involves springs and dampers. As the vehicle travels down the road, all…

Q: Technician A says that a hard brake pedal on a vehicle with disc brakes can be caused by air in the…

A: Option d is correct. Neither A nor B.

Q: When reassembling an overhauled brake caliper: Technician A cleans brake components in dena-tured…

A: reassembling an overhauled brake calliper: Technician A cleans brake components in denatured…

Q: What are the two basic types of brake rotors used on today’s vehicles?

A: Two basic types of brake rotor used in today vehical is, 1. Blank and smooth type of rotor. 2.…

Q: Technician A cleans brake components in denatured alcohol. Technician B cleans brake components in…

A: Technician A cleans brake components in denatured alcohol. Technician B cleans brake components in…

Q: Why is a torsion bar suspension considered as a two-inertia system

A: A torsion bar is utilised in the suspension system of cars to absorb energy. When a bar is…

Q: a small taper on the sides of a wheel rim? Why is an automobile tyre usually black in colour? What…

A: Rims are basically designed for the minimization of dislodging of the tire when they are subjected…

Concept explainers

Clutches, Brakes, Couplings, and Flywheels

The clutch is described as a machine element used to connect or disconnect two shafts together to transmit torque or power. The clutch works on the principles of friction. The clutch is commonly used in automobiles to transfer power from the driving shaft to the driven shaft.

Question

Compare between Disk brake and drum
brake based on the following Ractors.
brake factor
lucerporabion af parking brake features.
Consis reucy
ln tolgue perfannce.
Athuation ekfeat
All wheel drive vehides.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Clutches, Brakes, Couplings and Flywheels

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Besides indicating ABS faults for some systems, the red brake warning lamp on the instrument panel can indicate failure of the ___ brakesystem, application of the ___ brake, or low fluidlevel in the ___.
What type of brake uses the inside of each rear wheel hub and rotor assembly as a parking brake drum?
which of the following statements about drum brakes equipped with star wheel automatic adjuster is correct? a) the adjustment mechanism is located on the primary shoe b)they are set to adjust when the vehicle is moving forward c)the adjustment mechanism is located at secondary shoe d)they automatically adjust when the brakes are not applied
A bike brake consists of two pieces AOB and COD. Draw a physical model and associated FBD for structural element AOB.
After resurfacing a brake drum: Technician A cleansit using hot water and a lint-free cloth. He then usescompressed air to thoroughly dry it. Technician Bcleans the drum using a lint-free cloth dipped in aspecial brake cleaning solvent. She then allows thedrum to dry before reinstallation. Who is correct?a. Technician A onlyb. Technician B onlyc. Both A and Bd. Neither A nor B
why is brake fluid removed from the master cylinder prior to working on disc brakes
Technician A says that some antilock brake systemsuse a lateral acceleration sensor in addition to thewheel-speed sensors. Technician B says that tractioncontrol systems apply one wheel brake to get the vehiclegoing in the direction in which it is being steered.Who is correct?a. Technician A onlyb. Technician B onlyc. Both A and Bd. Neither A nor B
True or False? The name duo-servo drum brake isderived from the fact that the self-energizing force istransferred from one shoe to another with the wheelrotating forward.
When replacing brake pads on a vehicle: Technician A works on one wheel before beginning work on an-other. Technician B uses a minimum of 52 psi of air pressure to force the piston from the caliper housing. Who is correct?
Technician A says power brakes are designed with vacuum-assisted units that use engine vacuum. Technician B says power brakes are designed with vacuum-assisted units that use vacuum developed by an external pump. Who is correct? a. A only b. B only c. both A and B d. neither A nor B Synthetic linings are made of _____ a. fiberglass b. aramid fiber c. both A and B d. neither A nor B All manufacturers recommend a specific sequence to follow when bleeding a vehicle’s brakes. a. True b. False Organic friction material _____ semimetallic materials. a. is quieter than b. is more fade resistant than c. requires higher pedal pressure than d. wears out faster than