combustion of a fuel sample is a bomb calorimeter increases the temperature of the entire system by 5.10 celsius if the calorimeter contains 1600g of water, but only by 4.00 celsius if the calorimeter contains 2100g of water. what is the hear capacity of thr dry bomb calorimeter assembly? Assume that the specific heat capacity of water is 4.818Jg^-1C^-1

Q: Q4) Write the relation between melting point temperature of ice with pressure? At 1 Atm, water melts…

A: Melting point is the temperature required for the solid to change its phase from solid to liquid.…

Q: Problem 2 Carbon tetrachloride (p = 1590 kg/m³, n = 0.969-10° Pa-s) flows at a rate of 18 m/h in an…

A: To find the type of flow through the tubes.

Q: Ice with a mass of kg 0.35 and at a temperature of C 0 is heated until all is melted. Find the…

A: Given  Mass of ice (m) = 0.35 kg Latent heat of ice( Lf) 334×103 J/kg Temperature of ice = 0 oC…

Q: The correct answers are shown. Please show me the steps to calculate these specific answers.

A: Step 1:  Step 2:  Step 3:  Step 4:

Q: An ideal Rankine cycle as shown has a boiler pressure of 3 MPa and a condenser pressure of 8 kPa.…

A:

Q: An isochoric process, also called a constant-volume process, an isovolumetric process, or an…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which…

Q: For a multicomponent distillation column, the distillate product was found to have a bubble-point…

A: Consider a multicomponent column in which the distillate was found to have a bubble point pressure…

Q: We experimentally investigated the dependence of cooling rates of ductile cast iron during the phase…

A: Rule to determine whether there is a statistically significant linear relationship that exists or…

Q: Show that h,dx h 2hx=L 3DL dx 0,

A: When a fluid flows over a cod or heated surface (plate), temperature field is set up in the region…

Q: 4. A double window is constructed by two layers of glass separated by a layer of dry stagnant air…

A:

Q: An ice cube is transferred from the refrigerator into boiling water at atmospheric temperature. What…

A: Introduction A quasi-static process is a thermodynamic process that happens slowly enough for the…

Q: ou oversee cooking a 30-lb turkey that is initially at 20 ̊C by exposing it to the 200 ̊C…

A: Step 1:Step 2:Step 3:Step 4:

Q: spherical tank with a diameter of 10 cm should be maintained at a constant temperature of 1°C, and…

A:

Q: Steady-state temperatures at selected nodal points of the symmetrical section of a flow channel are…

A: Given, The convection coefficient, hi= 500 W/m2.K ho= 250 W/m2.K

Q: what will happen to the work and heat of the system, will it be >0,

A: Heat and work in thermodynamics involves the transfer of energy from one system to another. In…

Q: 23–79C Under what conditions can a counter-flow heat ex- changer have an effectiveness of one? What…

A: Heat exchanger is equipment which is used to heat transfer between fluids. Heat exchangers are used…

Q: b. A thermostatic mixing valve is set to blend hot water at 60 C with cold water at 8 °C in…

A:

Q: Find and reference a semi-empirical correlation for convective heat transferfrom the literature.…

A: The objective of the question is to find a semi-empirical correlation for convective heat transfer,…

Q: An air conditioner (AC) is a cooling device in which the inside of the house can act as the cold…

A: Given Data :  Power (P) = 1.70×103 W = 1.70×103 JouleSecond   ; because →1 watt = 1 JouleSecond for…

Q: Q3. A Carnot system operates between temperatures 500 "F and 100 °F. Its efficiency may be increased…

A:

Q: 1-a Sub-cooling of the liquid can takes place either inside or outside the condenser, discuss in…

A: Sub-Cooling is the process of cooling the condensate further below its saturation temperature. It is…

Q: 1. A cylindrical nuclear fuel element (k=34 W/m-K) has the following dimensions: D= 6 cm and L=40…

A: Given: Thermal conductivity of cylindrical nuclear fuel element (k) = 30 W/m-K Diameter (D)= 6…

Q: A 0.42 mở rigid tank contains refrigerant-134a initially at 160 kPa and 40 percent quality. Heat is…

A: Given A rigid tank V=0.42m3 Refrigerant-134a P1=160kPa x= 0.4 P2=700kPa Find Total amount of heat…

Q: [1] Repeat Example 9.1 (pages 330-331) but with the following exceptions: refrigerated space is…

A: Temperature Of refrigeration space = -15 C Temperature of cooling water = 19 0C Efficiency of the…

Q: Q 3) A) What is the physical significance of the two constants that appear in the van der Waals…

A: Since you have posted multiple independent questions in the same request, we will solve the first…

Q: 4. The right figure shows a simple combustion calorimeter. The sample is ignited electrically. After…

A: The water and the calorimeter each gained energy from the combustion. We will find out how much…

Q: A client has an airstream that is 150 ºC and at 1 atm of pressure that contains 50,000 ppm of…

A: Given data: Concentration of heptane in air stream = 50,000 ppm Heptane removed = 40 %

Q: A 8.7 kg of lead initially at 210∘C is dropped into an insulated basin containing 21.9 kg of water…

A: Given Information: Mass of lead dropped in the water basin, mL = 8.7 kgInitial temperature of the…

Q: Btu W to Convert 26.4 hr ft °F m K

A: Writing the Unit conversion formula, 1 Btu = 1055.06 J 1 hr = 3600 s 1 ft = 0.3048 m 32°F = 273.15 K…

Q: Please help me with this question

A: In chemical processes, the operating pressure and temperature are crucial parameters for optimizing…

Q: The properties of mercury at 300 K are: Density: 13529 kg/m³, cp = 0.1393 kJ/kgK, dynamic viscosity…

A:

Q: Convert a thermal conductivity of BTU 0.03- to s. K.m °hr. °F.ft Given: 0.03- BTU hr.F.ft Required:…

A: ⇒1 btu=1055.056 J⇒1 hr=3600 sec⇒∆°F=∆K⇒1 ft=0.305 m⇒thermal conductivity, K=𝓠.∆xA.∆T

Q: Example 2.4 Air is in a rigid tank of volume 1m' at initial pressure of 500kPa and temperature of…

A:

Q: W 4540 W/m²K. The fuel material has k= 33.9 W/m K. For the situation described, evaluate the…

A:

Q: At very high temperatures, which heat transfer mechanism is dominant? Explain.

A: Hi and thanks for the question. Since you have posted multiple questions and have not specified…

Q: 2-37 Water is being heated in a closed pan on top of a range while being stirred by a paddle wheel.…

A: Given  Heat transfer to water Qin = 30 kJ Heat loss to surrounding Qout =  5 KJ Work done by paddle…

Q: You oversee cooking a 30-lb turkey that is initially at 20 ̊C by exposing it to the 200 ̊C…

A: Setting Up the Model and Calculations ( b, c) b) Time to Cook (Center Reaches 90°C)We use FindRoot…

Q: Building in Nassiriah city is air conditioned with the following assumptions: Sensible heat load…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…