Coal fired in a furnace analyzes 16.6% VCM, 16% ash, 61.4% FC, 6% M, 1.2% N, and 1.8% S with a calorific value of 26.75 MJ/kg. Analysis of the refuse shows 44% ash, 8% VCM, 34% FC and 14% H2O. Partial orsat analysis of the stack gas shows 10.77% CO2, 1.62% CO, and 0.81% H2. Air supplied is at 27 oC, 765 torrs with 80% RH. Calculate: a. % C and % VCM lost in the refuse b. % excess O2 c. m3 air/kg coal d. Orsat analysis of the stack gas

Q: A combustion reactor is fed with 65 kg/mol/h of air. Calculate the percentage of excess (02) air and…

A: The complete combustion of compounds produces carbon dioxide and water. As combustion occurs with…

Q: In a coffee-cup calorimeter, 23.8 g sample of solid KBr is dissolved in 100.0 g of water at 15.0 °C.…

A: mass of KBr= 23.8gmass of water=100gso mass of te solution=123.8gT1= 15°CT2= 7.9°CCS=…

Q: When 23.6 g of calcium chloride, CaCl2, was dissolved in water in a constant-pressurecalorimeter,…

A: Given that, Mass of CaCl2 = 23.6 g,  molar mass =111 g/mol Hence, moles of CaCl2 is calculated as:…

Q: Differentiate the evaporation and drying processes Determine the boiling point rise of a 20% NaCl…

A: Difference between evaporation and drying Evaporation means removing a part of solvent from a…

Q: A combustion efficiency test done on a gas-fired boiler indicated that the stack temperature is…

A: Boiler is gas fired type.Stack temperature = 7500FCO2 content in flue gas = 7%Part a) Excess…

Q: 3. A ternary blend of gasoline (90% octane no), alcohol (75% ethanol, 25% methanol) anc benzole (75%…

A:

Q: A continuous single-effect evaporator concentrates 9072 kg/h of a 1.0 wt% salt solution entering at…

A: Introduction:- The heat exchanger for boiling the solution and the specific features for separating…

Q: A) What factors might lead to failure of the reactor and/or rupture disk?  B) Associate each factor…

A: Silane SiH4 analogues to methane with silicon. This is used in decomposition of silicon with…

Q: The air conditioning process in the humidifier, air at a dry bulb temperature of 40 ° C and RH of…

A: Initial dry bulb temperature of the air, Tdb1 = 40°C Initial relative humidity of the air, RH1 = 40%…

Q: Air at 35 'C and RH 45% is flown into the heating coil so that the temperature of the dry balls is…

A: Given that, The initial temperature of air T1 =35oC Relative humidity of air RH = 45% Dry bulb…

Q: Problem 3. Glass comprises Na:O 7.65%, MgO 10.57%, ZnO 7.25%, Al2O3 1.19%, B2O3 7.43%, and SİO2…

A: The mole percent of the compounds present in the glass is to be calculated.

Q: a) Describe octane number b) Butanes is one of the low boiling products present in crude oils and…

A: Answer a) The octane number (ON) is describe as knock resistance of gasoline. The Octane number is…

Q: After the addition of 24 g of ethanol (C2H5OH) to 1 kg of water, the freezing point of the solution…

A: 24 g of Ethanol (C2H5OH) dissolve in 1 kg of water. Freezing point of water at normal pressure= 0°c…

Q: Determine the amount of theoretical oxygen and theoretical air needed to burn. ( a.) 60 kg of butane…

A:

Q: e air has a dry ball temperature of 30 ° C and a wet bulb temperature of 22 ° C is initially heated…

A:

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the…

A: Given thatfeed contains solid = 15 %wt water = 85 % wt heat is added and water is evaporated residue…

Q: An alloy containing 30 down under equilibriur temperature. Determi eutectic phases in the

A:

Q: Estimate the thermal properties of a food with the following composition: carbohydrate 52.0%,…

A: Note: Since we are entitled to answer only three sub-parts, we’ll answer the first three as no…

Q: Flash vaporization process is used to vaporise 70mole% of feed which contains 65 mole% of benzene…

A: The Flash vaporization process is a type of distillation process in which is added to the feed…

Q: Ultimate analysis "as combustible" or "moisture and ash free" C = 82.88%; H₂ = 5.38 % ; O₂ = 6.48 %;…

A:

Q: A silvery-white, lightweight malleable metal is used in a huge variety of products including cans,…

A: Mass of the aluminum oxide = 8.25 × 105 g Mass of carbon = 7.5 × 105 g Yield of reaction = 35 %

Q: Build the phase diagram for the nickel - copper alloy. Temperature of Crystallization , C Initial…

A: The phase diagram is a graphical representation of the physical states of a substance under…

Q: A tray distillation column tower is to be designed to distill 550 Ibmol/h of a binary mixture of 50…

A:

Q: Coal fired in a furnace analyzes 16.6% CM,16% ash, 61.4% 6% M, 1.2%N and 1.8%S with a calorific…

A: The coal's combustion gives residue and stack gas. The combustion occurs due to air. The combustion…

Q: 100 k/moles of Heptane is burned with 40% excess air. Seventy percent reacts to form CO₂ and the…

A: Given data: Number of moles of heptane = 100 kmol Heptane reacts to form CO2 = 70 % Heptane reacts…

Q: calculate the GCV and NCV

A:

Q: Considering the very slow cooling (i.e. equilibriumcooling) of a 1.5 wt% C alloy; a) Draw schematic…

A:

Q: For an industrial process where a large amount of heat is required, a large combustion chamber is…

A: Dear User! The question does not state the relative composition of benzene and methyl alcohol in the…

Q: Butane is burned with 80% of theoretical air. Calculate the composition of gases leaving, assuming…

A:

Q: A drier is to be designed to reduce the water content of copra from 180% to 10%. The available air…

A: Hello ! This is a question with multiple subparts. As per our policy, we have answered the first…

Q: A solution containing 50 weight % methanol and remaining water at 300 K is admitted to a…

A:

Q: A solder batch is made by melting together 71 g of a 40:60 Pb-Sn alloy with 56 g of a 60:40 Pb-Sn…

A: Total mass of Pb = 71*0.4 + 50*0.6 = 58.4 g Total mass of Sn = 71*0.6 + 50*0.4 = 62.6 g Wt% of Sn =…

Q: The air has a dry ball temperature of 32 ° C and a wet bulb temperature of 24 ° C is initially…

A: Initial dry bulb temperature of air, T1=320CFinal dry bulb temperature of air, T2=800CInitial wet…

Q: Calculate the formation volume factor for the gas given below for use at 5000 psig and 194 °F.…

A: Given data: A sample of hydrocarbon gas is given and the composition of hydrocarbon also given.

Q: Pyrite Fines containing 85% FeS2, and 15% gangue are charged to a burner. An analysis of the cinder…

A: Given that, The mass composition of Pyrite fines FeS2: 85% Gangue: 15% The mass composition of…

Q: A 100 mol liquid mixture contains 50 % Benzene, 30 % Toluene and 20 % Xylene on a mole basis. On…

A: Given, initial moles of mixture is 100 mol. mole% of benzene is 50% mole% of toluene is 30% mole% of…

Reactive Processes

Reactive processes are the processes in which any reaction occurs. The reactions can be any combination reaction, decomposition reaction, combustion reaction, oxidation reaction, reduction reaction, neutralization reaction, displacement reaction, or double displacement reaction.