1) Properties of soil and concrete Osal 4m 9 = 30° Cohesion =0 Coefficient of base friction = 0.50 Soil's ultimate bearing copacity= V25 k 2m %3D 12 0.0 use Rankine's theovy Considering no evosion and future excavaton would happen in the Soil a) Detemine the location of the active force from the boase. 67 Determine the total normal force reachion of soil at the bose. c) Determine FS SIDING. d) Determine FSarturning o e) Determine PSpcoing. C-

Q: Write down the the Coulomb equation for the force resulting from the passive pressure Pp of a…

A: Cohesionless soil:

Q: Please solve this Shear strength test

A:

Q: 8. Choose from the following, the coulomb suggested a solution to this equation r= o • A. tf = C-G…

A:

Q: of the vertical stress is equal to 0.00. using the Boussinesq and Westergaard equations. For the…

A:

Q: A vane shear test was performed on saturated clay layer at the site and it is noted that a torque of…

A:

Q: Figure 3 shows the stresses at failure for a point in a soil mass. Note A.U. (a) Draw the Mohr…

A: Given ;

Q: The table below contains data from 2CU triaxial stress on usimilar upe cimens Specimen no cell…

A:

Q: If both the major and minor principal stresses for a soil element are known, as well as the strength…

A: The Mohr's circle is a graphical representation of the state of stress at a point in a material. It…

Q: Water is flowing through a soil as shown in the figure. Pressure head at C (i.e. uc) is 9m.…

A:

Q: A cone penetration test result of a deposit of normally consolidated dry sand are given below.…

A: Unit weight of sand = 100 pcfCone penetration data is given for various value of depth

Q: If both the major and minor principal stresses for a soil element are known, as well as the strength…

A: The Mohr's circle is a graphical representation of the state of stress at a point in a material. It…

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.