Situation 2 | Beam ABCDEFG below is subjected to multiple loads as show. The total length of the beam is 10m. Analyze the beam completely. 6 kN 10 kN 3 kN/m 2 kN 5 kN-m G 3000mm. 1000mm 1000mm. 2000mm. 1000mm. 2000mm. 3. Determine the shear ation for segment B-C. ** 4. Determine the moment equation of segment C-D.** 5. Determine the maximum negative moment.* 6. Determine the maximum positive shear.* 7. Determine the maximum positive moment.*

Q: a 9 kN/m 75 mm 150 mm В |C a Sección a - a E DA 2 m 2 m 3 m 3 m

A:

Q: Draw the shear and moment diagram for the beam shown below by choosing the reaction at the interior…

A:

Q: Consider pin A, which is used in a single shear connection. Use the ultimate shear strength, the…

A:

Q: STATICALLY INDETERMINATE BEAMS Using Double Integration Method and/or Moment Area Method, answer -4…

A:

Q: 2. Determine the reactions at supports A and B. 700 Ib/ft 500 Ib/ft 6 ft 9 ft 6 ft 6 ft 8 ft

A: Consider the following free body diagram: Consider member BD as follows:

Q: * Ignore Internal Strain Energy due to axial load and shear. A (pinned) 15 ff 2 k/ff V C (hinge) V…

A:

Q: Determine the force in member CG for the truss using the method of joints. 133 kN 67 kN B F G -4 at…

A: Given Data  Find the force in member CG (FCG) using method of joint.

Q: A cross section of truck frame is shown. Determine the location of the shear center O due to 1-kip…

A:

Q: RCES and DRAW THE SHEAR TELYOF the following beam COMPUTE THE MAXIMUM BENDING STRESSIN…

A: support reaction: ∑MB=0RA×3+4×3×32-12×4×3×33=0RA=-4 KN∑FY=0RA+RB-4×3-12×4×3=0-4+RB-4×3-12×4×3=0RB=22…

Q: The electric power transmission tower supports two wires that apply 18 kN vertical forces, and the…

A: Member DE is zero force member.

Q: Calculate the shear force V (in lb) and bending moment M (in lb-in.) at a cross section just to the…

A: Given:- To find:- Shear force and bending moment at just right of 810 lb load

Q: В 10in 10in D 1.5in 2in

A:

Q: The shear force diagram of a beam is shown in the figure. Draw the bending moment and load diagrams.…

A: Given data: Shear force diagram:

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.