6 A circuit is constructed with a resistor, twoinductors, one capacitor, one battery and aswitch as shown. The value of the resistance isR1 = 299 Q. The values for the inductances are:VL1 = 208 mH and L2 = 181 mH. The capacitanceis C = 97 µF and the battery voltage is V = 12 V.The positive terminal of the battery is indicatedwith a + sign.L2b1) The switch has been closed for a long time when at timet = 0, theswitch is opened. What is UL1(0), the magnitude of the energy stored ininductor L1 just after the switch is opened?1.664*10^(-4)Submit+)2)What is wo, the resonant frequency of the circuit just after the switch isopened?162.79radians/s Submit3)'What is Qmax, the magnitude of the maximum charge on the capacitorafter the switch is opened?245.7uc Submit4)What is Q(tj), the charge on the capacitor at time t = t1 = 3.13 ms. Q(tj)is defined to be positive if V(a) – V(b) is positive.|-119.71µC Submit5) What is t2, the first time after the switch is opened that the energystored in the capacitor is a maximum?9.64ms Submit6) What is the total energy stored in the inductors plus the capacitor attime t = t2?J Submit

NOTE : “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Answered: circuit is constructed

Engineering

Electrical Engineering

circuit is constructed

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Subject: Business process reengineering c) What is the benefit of spidar diagram & where it use…

A: perceptible conceptualize diagram support by systemize conception and notion reasonably to look a…

Q: 1. For the goven circuil, greph i, 14) Iov 602 1202 gl4):8 sine 377€ VoHto

Q: application of density for engineer

A: According to the question we have to discuss the application of density for engineers.

Q: A ball is drawn at random from box balls, bux 4) white bulls cuntaining (6)ved and (5)' blue biatls…

Q: A 5,000 square foot office area has 90 fixtures each with two lamps. The lumen output of each lamp…

A: It is asked to calculate the number of fixtures required so that the new lights provide the same…

Q: Which of the following statement is true? a. Angle between load voltage and load current in a pure…

A: Solution:- Let's consider a capacitor C connected to load with capacitance C.C is connected as load.…

Q: 24V 623 82 20V

Q: Find every thing on the chart and show work for each step

Q: Select a problem & solve it in Mason Method.

A: Example problem: Consider a Signal Flow Graph of a system as below. To Find: Transfer function…

Q: With the use of a table, with no more than 5 points, make a comparison between the characteristics…

A: In the following section, the comparison between the characteristics of a carbon composite flywheel…

Q: List 3 different concepts of Electricity(gravity) not hydro generation using weights design. Each…

A: Concept 1: Piezoelectricity Generation Introduction: Piezoelectricity is a concept that…

Q: Discuss advantages of per units representation

A: Advantages of per unit representation

Q: 3. RIS) 2. 6. 3.

Q: Find Vo IkA 3k 24 A Ans; 36V

Q: Q.1: / (A) Fill in the blanks with appropriate words of the following choose only five: 1. The…

A: (1): The magnetizing curve can be analyzed as diamagnetic, paramagnetic and ferromagnetic.…

Q: . Explain the environmental impacts of Hydropower plant?

Q: Using a neatly and labeled drawn sketch, show the typical circuit arrangement of a monopolar…

A: It is asked to show the typical circuit arrangement of a Monopolar arrangement with ground return…

Q: Please plot Root Locus for G(S)=[7/S^2].

Q: Which of the following statements regarding the cost structure of a wind farm are true? Select one…

A: Here we need to discuss Which of the following statements regarding the cost structure of a wind…

Q: Hau/ Find the hansler lunchion Vs)NG) fr the Cireuit shown below e- 152 VO 1H 1H VICA

A: In this question, We need to determine the transfer function of the given circuit. We are solving…

Q: iii. Is the copper losses inside a power transformer feeding certain load: (a) Increased with the…

A: Copper losses are directly proportional to the reactive power consumption. As reactive power…

Q: 2. Syngas enegy content is about....... a. Two time of natural gas b. Half of natural gas c. No…

A: Different ratios of carbon dioxide and hydrogen monoxide are combined to form synthesis gas, often…

Q: in conventional flow. the electron flows from positive side of the source to the negative side of…

Q: 2-2 kn 10 RL =IK 4.7Km find InotoA and RooRton and V norten

Q: Could you please help me out with these questions? Thank You A typical 9 m hydro pole weighs…

A: Effect of biological system:

Q: Q. 16. The best gas mixture for circuit breakers of the following is: C. Air and Sf6 DON₂ and…

A: Answer is option B SF6 and N2 is the best gas mixture for circuit breakers. SF6 is a highly…

Q: Discuss FOUR (4) advantages of per-unit system.

Q: necessary equations.) ww 352 252 Gov.

Q: What is a typical voltage used for capillary zone electrophoresis? a. 2.5 MV b. 250 kV c. 250 MV d.…

A: capillary zone electrophoresis

Q: c) What is product life cycle in relation to automobile vehicle?

A: Product Life Cycle Management is well known in all manufacturing segments and is not different for…

Q: ) Wind farm consist of ten wind turbines with nominal capacity of 2MWper turbine, has a total of 20…

A: Capacity factor =Average load / installed capacity. Average load = no. Of units produced / no. Of…

Q: High humidity in a production environment can cause adhesion problems. However, low humidity…

A: OPTION (b) is correct answer

Q: 2. Noise can be reduced through: a. Increasing So. b. Increasing Si. c. Both (a) and (b). d. Note…

A: Given Noise can be reduced through

Q: Mention Factors determining the size and the direction of the generated emf

A: Factors determining the size and the direction of the generated emf are follows-

Q: The advantages of splitting vertically and horizontally varies. Describe them.

A: We need to tell about advantages of splitting vertically and horizontally varies.

Q: A. Discuss the importance of power electronics interfaces in microgrid installations B. With the aid…

A: (A) Importance of power electronics in microgrid installation : The main power electronic device are…

Q: 2l. In the open cirouit test, if is safes practice to open the high voltage side· F. or R.2.in oder…

Q: 3c. Fill out the table with values for the charge on C and time rate of change of the current…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

A circuit is constructed with a resistor, two
inductors, one capacitor, one battery and a
switch as shown. The value of the resistance is
R1 = 299 Q. The values for the inductances are:
V
L1 = 208 mH and L2 = 181 mH. The capacitance
is C = 97 µF and the battery voltage is V = 12 V.
The positive terminal of the battery is indicated
with a + sign.
L2
b
1) The switch has been closed for a long time when at timet = 0, the
switch is opened. What is UL1(0), the magnitude of the energy stored in
inductor L1 just after the switch is opened?
1.664*10^(-4)
Submit
+)
2)
What is wo, the resonant frequency of the circuit just after the switch is
opened?
162.79
radians/s Submit
3)
'What is Qmax, the magnitude of the maximum charge on the capacitor
after the switch is opened?
245.7
uc Submit
4)
What is Q(tj), the charge on the capacitor at time t = t1 = 3.13 ms. Q(tj)
is defined to be positive if V(a) – V(b) is positive.
|-119.71
µC Submit
5) What is t2, the first time after the switch is opened that the energy
stored in the capacitor is a maximum?
9.64
ms Submit
6) What is the total energy stored in the inductors plus the capacitor at
time t = t2?
J Submit

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which negative environmental impact is NOT present in wind energy? O a. all of these O b. water use O c. thermal pollution O d. chemical pollution
Bus bar system with the simplest design is. single bus bar O single bus bar without sectionalization single bus bar with sectionalization duplicate bus bar
the correct Ans is mentioned with the question then why you provide wrong solution. please solve it correctly
The levelised cost of electricity (LCOE) is often used to compare the costs of electricity production from different types of electricity generation plant. Carefully describe the significance of the LCOE and give one advantage and one disadvantage of using this metric to compare plants.
A suspension string has 3 units. Each unit can withstand a maximum peak voltage 11kB. The capacitance of each joint and metalwork 20 % of the each disc. Fin the (a) maximum line voltage for which the string can be used. (b) String efficiency.
Find the current iy ANSWER:______________mA
Define the string efficiency and calculate its value for a string of three insulator units 33 kV overhead line if the capacitance of each unit to the earth and line be 20% and 5% of the self-capacitance of the unit. Drive any formula that might be used.
4. a) Describe briefly the basic parts of power conversion in wind energy systems write with computer please
1. What are the five basic ideal, electronic component models used to model all other electronic devices? 2. What is the formula for each of the five, ideal models that expresses the relationship between voltage across and current through the device? 3. What is the phase shift between the voltage and the current introduced by each of the five, ideal component models?
The following are the data for three units in a plant. Unitl →C = 5610+ 79.2P, + 0.01562P² R/hr,P< 600MW Unit2 → C, = 3100+ 78.5P, +0.0194P, R/hr,P, < 400MW Unit3 → C, = 936+95.64P, +0.05784P? R/hr, P, < 200MW Obtain the priority list by considering the following demand range 1000MW < P, <1200MW ={ 400MW < P, <1000MW P, < 400MW
Q5(a) i) Explain the major difference between IT and TT earthing systems using sketches with labels. ii) Describe the major difference between TN-C-S system and TN-S earthing systems using sketches with labels.