Chose the correct data input for 4-1 multiplexer that used to Design the switching network F F(A,B,C,D.E)=Em( 0, 1, 3, 15, 24, 30) * (+d( 6,12,29 10= C'D'E'+CD'E+CDE , 11=CDE , 12= 0 , 13= C'D'E'+CDE' 10= C'D'+C'E , I1= CE , 12= 0 , 13= CD'+CE 10= C'D'+C'DE , 11= CDE , 12= 0 , 13= C'D'+CDE' 7- None of them O 10= C'D'E'+C'E, 11= CDE+CD'E' , 12= 0 , 13= C'D'E'+CDE'

Q: What is the voltage drop across RC, VC, in volts?  (Enter the number, not the units.)

A: Given circuit is -

Q: Does the NEC make suggestions about how to wire a house that will be occupied by handicapped…

A: The NEC is the electrical code that is accepted by everyone belongs to the electrical industry. NEC…

Q: I dont get it. howcan I make sure its in low condition?

A: You have asked that how to make sure it is in low condition.

Q: Numerical answer: A 14-bit DAQ device is used to measure a voltage range of +-8 Volts. What is the…

A: For the given Digital to Analog converter specifications the value of resolution needs to be…

Q: 3. Using Mason's Rule, find the transfer function T(s) = for the system represented in the fugre.…

A: Signal flow graphwe have to find Transfer function

Q: how did you find Rth?

A:

Q: question: Suppose that you want to sort blocks of different heights automatically. How can this task…

A:

Q: HERE IS IT

A: Physical address can be expressed by the following formula:Physical Address = (Segment Address) x 10…

Q: where is the value of 10/sqrt(2) coming from?

A:

Q: Is there a way to clean up this answer by using proper notation

A:

Q: 200 200 20 0.53

A:

Q: in this Lab you will be laying out and installing an emergency service panel. Emergency service…

A: (1)  Legally Required standby systems provide electric power to selected loads during firefighting…

Q: How to convert 22 mW of power into the units of dBm

A: In this case, 22 mW of power is to be converted into its equivalent power in dBm.

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.