*:Characteristic impedance of a transmission line is reciprocal of admittance of a transmission line impedance which is a constant at any point on the transmission line impedance Z of a transmission line none of the mentioned

*:Characteristic impedance of a transmission line is reciprocal of admittance of a transmission line impedance which is a constant at any point on the transmission line impedance Z of a transmission line none of the mentioned

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.27MCQ: In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission...

See similar textbooks

Related questions

Q: c. Inductances of the three phases of a transmission line are generally not equal. d. It is…

A: (c) Inductances of the three-phase transmission lines are generally not equal: The inductances of…

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A: We will find out the characteristics impedance for given transmission line with give open circuit…

Q: 1)Write the Installed Generation Capacity of Sultanate of Oman with current energy share of…

A: (1) Total Installed Generation Capacity of Sultanate of Oman is 9000 MW. Out of which renewable is…

Q: 1) A 60-Hz, ...-km, three-phase overhead transmission line has a series impedance z = 0.8431L79.04…

Q: A three-phase transmission line at 60 Hz has its conductors in an asymmetrical triangular…

Q: Q1/ Explain in detail VOLTAGE DROP / RISE IN TRANSMISSION LINE With mathematical examples

Q: 3. If a transmission line with an impedance characteristic of 50 ohm is connected to a load with an…

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A: Frequency = 1.5 kHz Length of transmission line Zoc = 800∠-50° Ω Short circuit impedance Zsc =…

Q: The A and C constants of a medium length transmission line is 0.936 + j0.016 ohms and (-5.18 + j914)…

A: Basic problem on transmission line in power system.

Q: Question 1) A 154 kV transmission line has a length of 100 km. The line and the conductors are given…

A: Concept: In bundled conductors, GMD and GMR increased, reducing inductance hence decreases inductive…

Q: A three-phase short transmission line has resistance and reactance per phase 40 and 6 2,…

Q: A 275kV, 50HZ three-phase transmission line is 110 km long. The line is supplying a three-phase load…

Q: 1. A 3 phase, overhead transmission line has a total series impedance per phase of 200 ohms and a…

A: The Performance calculations of long transmission lines need is based on various parameters of which…

Q: 2. A three-phase 60-hz transmission line has its conductors arranged in a triangular formation

Q: A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that…

A: The diameter of ACSR Rook is given as 0.977 inc The capacitance to neutral is given as Cn=2πk0lnDr…

Q: Which of the following parameter/s is represented as connected in shunt in the equivalent circuit…

A: Any transmission line is represented by four components namely Resistance, inductance capacitance…

Q: 4. A single phase, 60Hz, 20-km short transmission line supplies a load of 700 MW at 0.95 lagging pf…

Q: A 220-kV, three-phase transmission line is 40 km long. The resistance per phase is 0.15 N per km and…

Q: The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412…

A: Inductance: It is a passive two-terminal electrical component and measured in Henry (H). When…

Q: What is the percentage voltage regulation of short transmission line if its sending end and reciving…

Q: Q1. What are the negative effects of each of the following: 1. What are the negative effects of…

A: Corona- The complete disruption in dielectric strength or insulation of insulating material (air)…

Q: A transmission line section shows an input impedance of 36 2 and 64 respectively, when short…

A: Given a transmission line has, Short circuit input impedance, Zsc=36 Ω Open circuit input impedance,…

Q: Discuss three negative effects that result from the effects of the construction of a transmission…

A: The objective of the question is to discuss the negative impacts that can occur during and after the…

Q: As an electrical power system engineer, you must deal with the representations and performances of…

Q: A single phase, 60Hz, short transmission line receives 700 MW at 0.95 lagging pr at 327.8 KV from…

Q: The ABCD constants of a three-phase, 345-kV transmission line are A = D = 0.98182 + j0.0012447 B =…

A: In this question, The ABCD constants of a three-phase, 345-kV transmission line are A = D =…

Q: A 400 km long, 50 Hz transmission line having series resistance and inductance of 0.12/km and…

A: Given: A 400 km long, 50 Hz transmission line have Resistance, R=0.1 Ω/km Inductance, L=1 mH/km…

Q: A/1/2 section of a 600 22 transmission line, short circuited at one end and open circuited at the…

A: According to the question, for the given diagram of the transmission line as shown belowThe…

Q: 17.) A single-circuit three-phase transposed transmission Iine is composed of four bundled ACSR…

A: A single circuit three-phased transposed transmission line as seen in the figure is composed of four…

Concept explainers

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.

Question

* :Characteristic impedance of a transmission line is
reciprocal of admittance of a transmission line
impedance which is a constant at any point on the transmission line
impedance Z of a transmission line
none of the mentioned O

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is 8002-50° and the short-circuit impedance is 413-20°. Determine the characteristic impedance of the line at this frequency.
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground
Any help
Kindly do it fast will upvote
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
q11
Q-7 b, A transmission line has equal voltages at the two ends maintained constant by two sources a third source is to be provided to maintain constant voltage equal to the end voltages either at the mid-point or 75% of distance from the sending end then the maximum power transfer capabilities from sending end in original case and the other two cases will be in the ratio?
Which of the following parameter/s is represented as connected in shunt in the equivalent circuit for Transmission Lines? O A. RESISTANCE WITH THE INDUCTANCE O B. CONDUCTANCE ONLY OC. CONDUCTANCE AND CAPACITANCE O D. CAPACITANCE ONLY
Answer Step by step communication sys
One circuit of a single-phase transmission line is composed of three solid 0.12" radius wires. The return circuit is composed of two 0.15" radius wires. Find the inductance of the complete line in mH/mi. The distance between wires are 40" horizontally and 25" vertically. A. 2.54 mH/mi B. 2.478 mH/mi C. 2.488 mH/mi D. 2.567 mH/mi Provide Clear Explaination
PLEASE SHOW COMPLETE SOLUTION.