CH3CH2OH + D½O → CH3CH2OD + HOD What is the best way of showing that this reaction has occurred? A. By testing the product with phosphorus pentachloride and not getting steamy fumes. B. By determining the mass spectrum of the mixture and showing peaks at m/z values of 20 and 46. C. By fractionally distilling the mixture and determining the amount of CH3CH2OD using a Geiger counter. D. By determining the mass spectrum of the mixture and showing peaks at m/z values by 19 and 47.

CH3CH2OH + D½O → CH3CH2OD + HOD What is the best way of showing that this reaction has occurred? A. By testing the product with phosphorus pentachloride and not getting steamy fumes. B. By determining the mass spectrum of the mixture and showing peaks at m/z values of 20 and 46. C. By fractionally distilling the mixture and determining the amount of CH3CH2OD using a Geiger counter. D. By determining the mass spectrum of the mixture and showing peaks at m/z values by 19 and 47.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Use equations to explain the prominent peaks at m>z 74 and m>z 87 in the mass spectrumof 2-methylpentanoic acid
CI NH 'N' chloroquine CI NH LHO N. N: hydroxychloroquine 5. You attempted to separate chloroquine and hydroxychloroquine using paper chromatography. You used a mixture of benzene and pyridine as your solvent. What results can you expect? O Two bands: hydroxychloroquine will have a higher Rf than chloroquine One band: Both will have equal Rf Four bands: The enantiomers of each analyte will appear as separate bands Two bands: chloroquine will have a higher Rf than hydroxychloroquine
Absorbance Beer-Lambert's Law (Spectrophotometry) #2 To spectrophotometrically determine the mass percent of cobalt in an ore containing cobalt and some inert materials, solutions with known [Co"] are prepared and the absorbance of each of the solutions is measured at the wavelength of optimum absorbance. The data are used to create a calibration plot, shown below. 0.80 0.70- 8 0.60- 0.50- 0.40- 0.30 0.20- 0.10- ++- 0.015 Concentration (M) A 0.6 g sample of the ore is completely dissolved in concentrated HNO3(aq). The mixture is diluted with 2+ water to a final volume of 50.00 mL. Assume that all the cobalt in the ore sample is converted to Co'(aq). a. What is the (Co] in the solution if the absorbance of a sample of the solution is 0.74? b. Calculate the number of moles of CoT(ag) in the 50.00 mL solution. 2+ C. Calculate the mass percent of Co in the 0.630 g sample of the ore.
6. Which compound has the greater ? (300 nm is a greater than 250 m.) .0 and "NH 10 and b. NH, 01-0 and
Consider the following errors that could be made when running TLC. Indicate what should be done to correct the error.a. A two-component mixture containing 1-octene and 1,4-dimethylbenzene gave only one spot with an Rf value of 0.95. The solvent used was acetone.b. A two-component mixture containing a dicarboxylic acid and tricarboxylic acid gave only one spot with an Rf value of 0.05. The solvent used was hexane.c. When a TLC plate was developed, the solvent front ran off the top of the plate.
Mass specrum
Can you explain mass spectrometry? Can you explain how to fill it?
In an experiment of Reverse Phase chromatography using C-18 stationary phase and a mixture of methanol/ethyl acetate/acetic acid, a researcher tried to separate the 3 compounds shown below. Which compound would have the lowest Rf and which the highest Rf in this experiment? Explain your answer and show any relevant structures.
3. Dibromocholestanol was analyzed by mass spectrometry using the electron impact (El) ionization technique. The following peaks were observed with relative intensities of ~1:2:1 Low Resolution MS (EI) m/z= 544, 546, and 548 Identify the peaks in the molecular ion pattern and which combination of isotopes produces these peaks: [M]: m/z = formula: [M+2]+: m/z = [M+4]+ : m/z = formula: formula:
In a GCMS experiment, a compound shows a 1:1 height ratio of its M peak at 122 mass units and its M+2 peak at 124 mass units in the mass spectrum. Which of the compounds below is consistent with this data? Br CH3CH,OCH,CH,CH,CI None of the other choices, that are listed here, is correct. .CI Br
Which of the following is consistent with the principles of green chemistry when comparing different methods for synthesizing a target compound? (Note: %AE is percent atom economy). large %AE and large E-factor large %AE and small E-factor small %AE and small E-factor small %AE and large E-factor
After submitting a sample for mass spectral analysis you are given the following spectrum: 100 80 - 60 40 20 – 10 20 30 40 50 60 70 80 m/z You know that your sample is either 3-pentanone or 3-pentanol. OH 3-pentanone 3-pentanol Part A: How could you use the mass spectrum above as your only means to determine if your sample is either 3-pentanone or 3- pentanol? Note that the spectrum above lacks a molecular ion. Part B: What is the identity of the sample which provided you with spectrum above: 3-pentanone or 3-pentanol? Relative Intensity