Answered: Cast Iron The combined bar as shown in… | bartleby

Related questions

Question

Cast Iron
O The combined bar as shown in the figure is made up of steel bar
with the diameter and length of 60 mm and 3 m respectively and is coated by a
5 mm thick cast iron. When load P is applied, this combined bar is compressed
to a total of 2 mm in the length of 3 m. Determine the value of load P, if the
moduli of elasticity are 200 GPa for steel and 100 GPa for cast iron.
-Steel Bar

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

1 iron 40 cm steel 70 cm Henry has a rod that is made out of 2 parts. An iron and steel section. The iron section is 40cm long (Y₁=9.1 x 10¹⁰ N/m²). The iron piece is attached to a steel piece that is 70 cm long (Y,=7.0 x 10¹0⁰ N/m²). The rod has a uniform cross sectional diameter of 3.40 cm. Determine the total compression (in mm)when henry uses a compressive force on the rod of magnitude F=6000N. Look at the image provided to get a better understanding.
Q2- A biological tissue underwent tensile tests, subjected to the axial load P. a) Determine the average normal (ơ) and average shear stresses (t) acting over area section shown below(A'), which is oriented at angle 0 from the horizontal, as a function of 0 and vertical cross section A. b) Determine angle 0 where o=3 t. (24 points) A'=A/sin0 P 01 A (Results: o =- (sine)²,t = - sin0 cose,0 = 71.56°) %3D A А
A sample of a new plastic 100 cm in length 1.0 cm in width, and 0.1 cm in thickness was subjected to a force of 20 If it is stretched to 100.1 cm long, what is its Young’s modulus in psi unit? (1 psi = 6895 N/m2)