The offset slider-crank mechanism is driven by the rotating crank 2. Ro = 20 mm, R₂ 50 mm, R3 = 140 mm Write the loop closure equation. Solve for the position of the slider 4 as a function of 0₂. У, A O 2 B 3 4 C X

Q: 4.2 As shown in the figure below. Try to get the numerical solutions (0₁, 0₂, 03) of one of above…

A:

Q: can you help me to do the position analysis of this mechanism and find the mathemetical expressions…

A: Given:To find:Draw the position analysis and find the angle values.

Q: The figure below shows a four- par linkage. If a=5m, b=7m, =9m, d310m, 0=60°, p-10°, a=30° and…

A: Solution given,Q= 5m, b=7m, c=9m , d= 10m ,θ=60, ∅=10°W2= irad/sTransmission angle : Angle b/w…

Q: ▸ An incompressible Newtonian fluid flows between two parallel plates (distance b). The bottom plate…

A:

Q: Given the following dimensions for this four-bar linkage mechanism, determine 03 and 04. 0₂04 = 100…

A:

Q: V = 100 fps, u = 40 fps, alpha= 30°. Determine beta.

A:

Q: F1 E F A D В F2

A:

Q: iven A and b to the​ right, write the augmented matrix for the linear system that corresponds to the…

A: GivenAx=bA=13-3-3-22522b=-714-6

Q: For the linkage shown in the figure below, answer the following. Assume Link 2 is the driving link…

A: It is asked to specify the configuration of the mechanism shown below. Also draw the circuit with a…

Q: For the beam shown determine the slope and deflection equations for 0<x< L using the…

A:

Q: The figure below shows the positions of the Centers of mass of the three disks on a rotating shaft.…

A:

Chemical and Phase Equilibrium

Phase diagrams or equilibrium phase diagrams are the graphical representations that show the phase transformations of the constituting elements with respect to the pressure, temperature, and compositions. The diagrams show the conditions that limit the different phases, namely solid, liquid, and gas. The diagram can also be utilized to verify the relations between the state variables. Most of the phase diagrams are temperature-pressure phase diagrams, with the variable parameter as the composition. Usually other variables such as solubility and pressure parameters are not indicated in the phase diagram. For a one-component system (unary phase diagram), the phase diagram is generally a function of temperature and pressure as the state variables, or temperature and volume. However, for a binary system (two-phase) having two components, the phase diagram is a function of temperature and composition as the state variables only. Coexisting of the different phases of the constituting elements is indicated in the phase diagram. A ternary phase diagram can be characterized by consisting of three phases in equilibrium.