NO AI. Thank You Calculate the required current for a 1-phase load of 1MW, VLN =120V, PF = 0.95 lagAmpsCalculate the required current for a 3-phase load of 2MVA, VLN =208V, PF = 0.85 leadingAmps

Answered: Image /qna-images/answer/d42974fb-d25d-49ff-911f-6690f4563191.jpg

Answered: Calculate the required current for a…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

a resistor and and capacitor are connected in parallel to a 277 v 60 hz power source. the resistor has a value of 50 ohms and the capacitor has a value of 40 uf what is the circuit power factor.
3. The secondary voltage can rise above its rated value when the load is a. resistive. b. capacitive. C. inductive. d. an RL series combination.
In general, the greater the absolute value of the impedance in a circuit:A. The greater the flow of alternating current.B. The less the flow of alternating current.C. The larger the reactance.D. The larger the resistance.
Please address the question in the attached photo. Thank you.
Determine the waveform on the load: a) If this were a resistance b) If this were a capacitor
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?
A moving coil ammeter and a moving iron ammeter are connected in series with arectifier across 110V (r.m.s.) AC supply. The total resistance of the circuit in theconducting direction is 60 ohm and that in the reverse direction may be taken asinfinity. Assuming the waveform of the supply voltage to be sinusoidal, calculate thereadings in each ammeter
a capacitor and a resistor are connected in parellel to a 120 v 60 hz line the resistor has a resistance of 40 ohms and the capacitor has a capacitance of 132.6 uf what is the total current flow through the circuit. what is the impedence and the power factor and how many degrees out of phase are the current and voltage out phase with eachother.
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Calculate the required current for a 1-phase load of 1MW, VLN =120V, PF = 0.95 lag Amps Calculate the required current for a 3-phase load of 2MVA, VLN =208V, PF = 0.85 leading Amps