Calculate the number of bars along the short direction side band width

Q: 4. A 4m x 8m rectangular footing will be placed on ground surface as shown in the figure below. The…

A:

Q: A footing carrying a load of 1500 kN. Depth of Footing is 3 m. maximum tolerable settlement is 45 mm…

A:

Q: A footing 2.25 x 2.25m is located at a depth of 1.5 m in a sand, the shear streng parameters to be…

A: Given : Footing size = 2.25 X 2.25 m Depth = 1.5 m To Find : Ultimate bearing capacity : A) if the…

Q: Design an isolated rectangular footing: P(dead load) = 225 kN P(live load) = 130 kN Qa = 180 kPa Df…

A: Given Data:D.L =…

Q: A column is supported on a footing as shown in the figure below. The water table is at a depth of 10…

A: Given- Water table at a depth of 10 m, Size of footing- 1.5 m × 3 m, Depth of footing Df=1 m, Unit…

Q: A 3.5 m square footing is proposed to be used to support a 521 mm x 376 mm RC column loaded with 675…

A: Given data:- Square footing size = 3.5m x 3.5m column size = 521 mm x 376 mm Dead Load = 675 kN Live…

Q: Q#3:…

A: The allowable safe bearing capacity is given by: Where,

Q: The average correcte N60 = 7 in the effective zone for a square footing (1m x 1m) located at a depth…

A: If the soil support of the continuous foundation yields due to the load imposed by the foundation,…

Q: Design a square pad footing with an overall depth of 600mm, cover to the reinforcements 50mm with…

A:

Q: Question Attached

A: Given:- To find:- Ultimate and Allowable bearing capacities

Q: A rectangular footing of B=3 and L=6 rests at the depth of 2 m below the ground level. The stress…

A: Based in the given data, we can use the stress increase due point load equation of Boussinesq's.…

Q: A 3.44m x 4.49m footing has a 370 mm column at center with the loads P = 597 kN and My=102.7 kN-m…

A:

Q: QI/ for the (3m*2m) footing shown in fig. below find the column load (v) that can be carried by the…

A: Given: Size of footing = 3×2 m ϕ=20°e=0.8Gs=2.7 c=30 kN/m2 γ=19 kN/m3 Factor of safety = 3 Depth of…

Control Survey and Geodetic reductions

Control surveys or survey controls are used to establish reference points as a basis for various construction activities. Vertical and horizontal control points are to be established in a control survey to increase accuracy. After establishing the control points, all other types of surveys such as topographic, right-of-way, aerial mapping, construction layout, boundary surveys, and utility mapping can be worked upon so that control networks can be formed. The place from which the observations are made is called a survey station.