Calculate the maximum Vu and Mu in the beam shown below: 2m P(D)=20 KN P(L)=10 KN 4m 3. B

Q: Compute the value of EIy at 2.5 m from the left support.

A:

Q: A 7-m simple beam is carrying a uniform load of 25 kN/m over the entire beam with two-point loads of…

A:

Q: In a plate girder subjected to a bending moment of 200 kNm, the width and thickness of flange are…

A:

Q: 1. Determine the resultant of the distributed loading acting on the beam shown. 1(A) 1(B) w N/m 4…

A: To find the resultant of the distributed loading acting on the beam shown.

Q: There is a P = 188 KN load applied in the mid-span of the below simply supported beam with the given…

A:

Q: PROBLEM NO. 2. A simply supported beam with overhang is loaded as shown. The beam has a…

A:

Q: force water. Determine the force & angle on gate AB.

A:

Q: From the beam shown. Let P = 30 kN, Q = 2 kN/m, L =6m. PKN L/3 m QkN/m Lm Determine the following;…

A:

Q: 4. Calculate the maximum value of load P that will cause bending stress of 20 MPa in the beam below.…

A:

Q: Find the spring force if EI= 2*108 kN.cm² and the Flexibility of the spring P = 0.125 cm/kN. 2kN/m a…

A: Given a beam 'a b c' as shown in figure with EI = 2 × 108 KN- cm2  Flexibility of spring = 0.125…

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.