Calculate the interior angles for the following data given Table Q4, and also draw a neat sketch of the traverse. Apply necessary check in your calculations and correct them if required.  Table Q4 Line Fore Bearing AB 150°15' BC 20° 30' CD 295° 45' DE 218° 0' EA 120° 30'

Q: Two intersecting lines A-B and C-D have azimuths A-B= 45deg. 33' 45", C-D= 309deg 11'20". What is…

A: The azimuth of line AB is 45deg 33'45" and the azimuth of line CD is 309deg11'20", Line AB and CD…

Q: 1. Using the information below, determine the following: a. Sketch of the traverse (label properly)…

A:

Q: Please explain how to find the bearings/azimuths. (Why is it addition or substraction?)

A: Bearings  Horizontal angle measured for any line with respect to North -South direction is called…

Q: Compute Bearing and length of side DA for the closed traverse shown. Formula: Side AB BC CD DA Sum…

A: Length and bearing of the sides is given . Latitude and departure are also given .

Q: Compute the bearings of all lines for a closed traverse ABCDEFGHA that has the following balanced…

A:

Q: Q5).The following angles and distance were measured in the closed loop traverse (ABCDEFA), Draw the…

A:

Q: 4. Compute and tabulate for the following closed polygon traverse: a. Azimuths b. Bearings Include a…

A: To find the azimuths and bearings of the closed traverse and to include a sketch for the same.

Q: please answer this, will give upvot thanks

A:

Q: An instrument is set over point “A" with a 5.45 ft. H.I. A vertical angle of -9°35'17" and a slope…

A:

Traverse Survey

Traverse surveying is a popular method of surveying. Traversing is that type of survey where several connected survey lines form a framework and the directions and lengths of the survey lines are measured with the help of a tool to measure angles and tape or chain respectively. Traverse networks involve placing survey stations in a queue or trail and using pre-tested points as a basis for looking at the next point. This type of surveying is different from Tacheometric surveying, where only angles are measured and the process of chaining is reduced.