Calculate the horizontal force P on the light 13° wedge necessary to initiate movement of the 43-kg cylinder. The coefficient of static friction for both pairs of contacting surfaces is 0.26. Also determine the friction force Fg at point B. (Caution: Check carefully your assumption of where slipping occurs.) Answers: P= FB = i i 43 kg B N N A

Calculate the horizontal force P on the light 13° wedge necessary to initiate movement of the 43-kg cylinder. The coefficient of static friction for both pairs of contacting surfaces is 0.26. Also determine the friction force Fg at point B. (Caution: Check carefully your assumption of where slipping occurs.) Answers: P= FB = i i 43 kg B N N A

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The 100-mm-diameter pulley shown fits loosely on a 10-mm-diameter shaft for which the coefficient of static friction is Determine the minimum tension T in the belt needed to (a) raise the 100-kg block and (b) lower the block. Assume that no slipping occurs between the belt and pulley and neglect the weight of the pulley Choices: A. TMAX = 1075 N, TMIN = 906 N B. TMAX = 1075 N, TMIN = 690 N
A 296-lb block is resting on a rough horizontal surface for which the coefficient of friction is 0.4. Determine the force P (Ib) required to cause motion to impend if applied to the block horizontally. W P
The cross section of a quarter circular concrete block JKL as shown in Figure 5 is located at thebottom of a reservoir. The width (perpendicular to the paper) is 3 m. The specific weight of theconcrete block is 24 kN/m3. The coefficient of friction between the base of the block and thefoundation is 0.43. Determine if the concrete block is stable or not against sliding and overturningif the water is:A. At side XB. At side Y, with the same water level as A.
In the figure shown, each block has a mass of 2-kg.Determine the force P needed to start block B to theleft. The angle of friction for all surfaces in contact is16.7 degrees.
Calculate the horizontal force P on the light 15° wedge necessary to initiate movement of the 30-kg cylinder. The coefficient of static friction for both pairs of contacting surfaces is 0.22. Also determine the friction force FB at point B. (Caution: Check carefully your assumption of where slipping occurs.) P Answers: P= FB = i i 30 kg B N N A
1.1.10 - Show all work please.
Determine the moment of inertia of the cross-sectional area of the reinforced channel about the x-axis. Assume t = 1.0 in., a = 1.8 in., b = 1.6 in., c = 2.2 in. 一一叫 F₁-a- Answer: lx = i in.4 x
just need final answers
1. A typical cross-section of a roinforced concrete T-beam is shown in the figure below. The beam is reinforced with eight 25 mm diameter bars in tension zone. For the purpose of analysis, use the effoctive depth of 575 mm. Use f. = 25 MPa and f, = 420 MPa. Determine øM, 1000 mm T100 mm 8-D25 300 mm 575 mm ww G29
Dont forget to draw the FREE BODY DIAGRAMS ALSO PLEASE! (: