Calculate the flow rate, jet velocity, and the reaction force for each deflection angle. Plot this theoretical reaction force against jet velocity. 2. For each deflection angle, plot the actual balancing weight against the theoretical reaction force; does the plot suggest a 45° linear relation?

Q: A coating experiment is conducted on a flat photographic film.

A:

Q: A 2.8 m3/s water jet hits a stationary splitter, such that half of the flow is diverted upward at…

A:

Q: Find the location of the stagnation point for the flow due to a vortex +T at (2a,0) and a vortex -…

A:

Q: For the sprinkler shown, find a. the torque required to hold it steady, and b. the rotation rate in…

A:

Q: .A 45° reducing pipe-bend (in a horizontal plane) tapers from 600 mm diameter at inlet to 30 mm…

A: Diameter at outlet will not be 30mm because if the diameter is 30mm pressure becomes negative at…

Q: In Fig. there are 125 ft of 2-in pipe, 75 ft of 6-inpipe, and 150 ft of 3-in pipe, all cast iron.…

A:

Q: Water flows from a reservoir through a pipeline as shown in the following diagram. The flow is…

A:

Q: A jet of water of 20 mm diameter and making an angle of 45 degree with the horizontal es a curved…

A:

Q: Give detailed information about industrial systems developed using momentum analysis with examples…

A: GIVEN :- Give detailed information about industrial systems developed using momentum analysis with…

Q: 3.2 Perhaps you have felt the end of a garden hose exert a backward force on your hand if (and only…

A: Solution: Given Data: Q=1 L/s=1000 cm3/sA=1 cm2a=0.5 cm2   Note: Dear Student! As per our…

Q: Water flows steadily and smoothly along a horizontal pipe through a contraction and out into the…

A:

Q: A horizontal axis wind turbine is installed at a location having free 3 m/s. The 75 m diameter rotor…

A:

Q: 0.85) discharging Determine the kinetic energy flux of 0.02 m³/s of oil (sp. gr. through a 50-mm…

A:

Q: Consider the pipe shown in the figure below. The nozzle's center line is 0.3 m above the flange…

A:

Q: A standard cylinder receives 10 gpm from a pump at 2000 psi. The cylinder bore is 3 in. and therod…

A:

Q: 5. A projectile is fired into the air from the top of a cliff of height h= 204 m above a valley. Its…

A: Given data Height of cliff =204 m Initial velocity =64.8 m/s Angle =610

Q: A centrifugal fan with backward curved blades has an impeller overall diameter of 320mm and rotates…

A:

Q: An 8 m/s wind enters a wind turbine rotor with a diameter of 36 m. Assume the air density 1.2 kg/m3…

A: The objective of the question is to calculate the power of the incoming wind, the maximum power that…

Q: Do the ODE of it

A: Given: Radical flow turbine  Absolute velocity at inlet = V1 Outer radius at inlet = l1 inner radius…

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.