Vjet Ajet Pjet ZA Tank Cart Cable

Q: uation and graphical representation and compare the results (take 45o increment ,N= 3000 r.p.m).

A:

Q: A frictionless convergent-divergent channel is used to accelerate the airflow emanating from the…

A:

Q: = 1000 kg/m³) flows through a nozzle, 10 cm and velocity v = Water jet (Pwater with diameter Do…

A:

Q: A nozzle of 50 mm dlameter delivers a stream of water ai 20m/sec perpendicular to a plate that moves…

A:

Q: (E) A uniform stream of fluid with speed U at infinity flows two-dimensionally and irrota- tionally…

A:

Q: A jet impinges on a splitter block. The incoming jet is horizontal and has a flow rate of Q1 = 8000…

A:

Q: Force developed on the plate ?

A: Given: Velocity,v=68 m/sFlat plate moving away from it at,u=58 m/sThe cross-sectional area,A=0.02…

Q: A horizontal jet of water issues from a nozzle 7.5 cm diameter under an effective head of 67.5 m and…

A: Given data: The diameter of the nozzle, d = 7.5 cm. The effective head, h = 67.5 m. Calculate the…

Q: jet of alcohol strikes the vertical plates shown in the Figure 2.  A force F=425 N is required to…

A: ForceF=425ND1=5cmD2=2cmP2=101kPaAlcohol SG=0.79 To-Determine:- 1) The mass flow rate of alcohol.2)…

Q: A jet of velocity V strikes a vane that moves to the right atspeed Vc, as in Fig.  The vane has a…

A: Given data: *The velocity of the jet is V. *The velocity of the vane is Vc. *The vane has a turning…

Q: cross section S with velicity q1 and making an a

A: Liquid jet has cross-section area= S Velocity =q1 Angle =α

Q: A jet of water strikes a splitter and splits into two streams of equal velocity but unequal…

A: Consider the diagram shown below for the given system. (a) From the conservation of mass, the…

Q: 200 r.p.m. with the wing An impeller rotating at dimensions (b₁ = 1.5 in., b₂ = 1.0 in., D, 5 in.,…

A:

Q: A very popular toy on the market several years ago was the water rocket. Water (at 10°C) was loaded…

A: Given Pressure inside the rocket , Pi = 100 KPa exit area is on tenth of the inside area .

Q: Q5/ A centrifugal pump impeller runs at 1500 rpm & has internal & external diameters of 0.2 n & 0.4…

A: A centrifugal pump is a mechanical device that moves a fluid by transferring rotational energy from…

Q: The entrance flow between two parallel plates (gap h) has a velocity that varies linearly at the…

A: The mass flow rate () remains constant throughout the flow, given by:where is the cross-sectional…

Q: Q4: Find the force required to hold the blade in position, if the jet weight (100kg) and discharge…

A:

Q: (c) A jet of water (at 10°C) of diameter 2.5 cm flows freely in the atmosphere in a horizontal plane…

A:

Q: The water (density =1000 kg/m3) leaves the nozzle (area of the nozzle%3D0.01 m ). Assuming steady,…

A:

Q: To avoid the bulky tower and impeller and generator inthe HAWT of the chapter-opener photo, we could…

A:

Q: A horizontal pipe ends with a nozzle that discharges to the atmosphere. The pipe has adiameter of…

A: The objective of the question is to find the diameter of the nozzle required to obtain a jet with a…

Q: If a jet is inclined upward 30O from the horizontal, what must be its velocity to reach over a 3-m…

A: Consider the diagram as shown below for the given system.

Q: The water jet -13.5 cm in the figure strikes normal to a fixed plate. The velocity of the jet is -8…

A: Write the given data. Dj=13.5 cmVj=8 m/s

Q: A turbine (see the figure of Example IIIa.3.21) is located at an elevation H1 from the surface of a…

A:

Q: Q4: Find the force required to hold the blade in position, if the jet weight (100kg) and discharge…

A:

Q: Air flows at a rate of 0.85 m3 /s through a horizontal round duet, which is reduced in diameter from…

A: Given:- Air is flowing through a horizontal round duct.     volume flow rate of air θ=0.85 m3/s…

Q: Do the ODE of it

A: Given: Radical flow turbine  Absolute velocity at inlet = V1 Outer radius at inlet = l1 inner radius…

Q: As given Woter entering in the figure a turbine whed ot V= 5mls 5cn 3cm axially eneges through 20…

A:

Q: The cross-sectional area is 25 square centimeter of water jet under the velocity of 35 meter per…

A:

Q: The plate is circular and 50 cm in diameter. The jet (D) is 10 cm and the hole (d) is 5 cm in…

A:

Q: 5. In this a fire fight system of ship water has speed N m/s. hose is in equilibrium Calculate the…

A:

Q: A large commercial power washer delivers 21 gal/min ofwater through a nozzle of exit diameter…

A: Given: Q=21 gal/mind=13 inDensity of water is taken asρ=1.94 slug/ft3 The mass flow rate is…

Q: Suppose that there is a 4-cm water jet with a velocity of 15 m/s which hits a vertical plate with a…

A: Given data: *The diameter of the jet is d=4 cm. *The initial velocity of the water jet is u=15 m/s.…

Q: 50 kg Q6) A water jet hits horizontally a 50-kg block with a velocity of (20 m/s), see the figure.…

A:

Q: A converging elbow tirms water to a nozzle in a vertical plane, The elbow cross section diameter is…

A: Internal pressure and fluid movement may cause unacceptable stresses and tensions in a piping…

Q: Q4. ajExplane the magnus effect in the potential fow b) A cylinder woith 50 cm in length, is under…

A:

Q: A water jet of diameter 3 cm is striking on a inclined. The velocity of the water is 56 m/s.…

A: Draw the diagram of the jet along with the inclined plate.     Write the diameter of the jet. d=3…

Q: Problem9 The entrance flow between two parallel plates (gap h) has a velocity that varies linearly…

A: In a laminar flow between two parallel plates, the velocity profile is symmetric about the mid-plane…

Q: Q3-A isentropic nozzle is supplied with air from large reservoir, where the T-1000 °C and P=10 bars.…

A: A nozzle is a mechanical device used to enhance the velocity of a flow by reducing the associated…

Q: A long cylinder of diameter, 2R rotates with angular velocity, w while being submerged in a large…

A: To find: (A) Assumptions for the flow

Q: Q1: A square plate of weight 1500 N is hinged on its top edge about a horizontal axis. If a free…

A:

Q: Jet Path A water jet hits a wall and splits into two streams as shown above. The jet carries 3 kg of…

A: Solution:Given data: m1=3 kg/s                    A2= 2 x 10-3 m2                    V2=V3=1…

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.