Calculate the density for the given composition of a gas mixture at pressure of 6150 psia and temperature of 102 F Component mole fraction molecular weight Te (R) pe (psia) M. X V Tex9 Pe X Vy methane 0.71 propane 0.23 n-butane 0.06 Ma Ppr z-factor gas density

Q: One mole of methane occupies 22.4 L at STP. Two moles of methane occupy _____ at STP. (A)11.2 L…

A: The volume of methane for 2 moles of gas at STP is to be determined.

Q: practical quantitation of dioxane leaked from the underground storage tank into the aquifer,…

A: GivenPQL for dioxane=1 μg/Lvolume of dioxane leaked=32 gallons=32×0.00378541 m3=0.1211 m3To findm3…

Q: Calculate the solubility of MNCO3 (in mol/L) in the following. Assume the Ksp of MNCO3 = 1.8 x…

A: Ksp=1.8x10-11 MnCO3s⇔Mn2++CO3-2 Ksb=Mn2+CO32- At equilibrium  Mn2+=S CO32-=S a) In water Ksp=S2…

Q: A gas that behaves ideally has a density of 1.92 g dm^3 assuming air behaves as an ideal gas,…

A: Given data: Density of gas = 1.92 g/dm3

Q: The absolute humidity at atmospheric pressure at 30 ° C is 0.019 kg water / kg dry air. Determine…

A: Dry bulb temperature= 30 deg C Humidity= 0.019 kg/ kg of dry air

Q: Assuming ideal gas behaviour, calculate the Specific Gravity at 1,000 psia and 100F.

A: Given Component Yi(mole fraction) C1(Methane) 0.73 C2(ethane) 0.06 C3(propane)…

Q: Moisture content wet basis (MC wb) is the amount of water per unit mass of moist sample.…

A: (According to the guidelines of Bartleby, we can only attempt the first question, you have to post…

Q: 1) Form the following data for CH;CI T(°C) Y (dynes/cm) 10 20 19.5 17.8 16.2

A:

Q: 1) What would be the volume of 20 moles of real gas methane at 100 atm and 0 degrees Celsius. At…

A: The volume at the given conditions is to be found.

Q: Graph type Temperature vs Pressure Length vs pressure Number vs pressure Slope value and units X =…

A: Ideal gas law gives the relation between 4 different parameters of a gas. The 4 parameters that are…

Q: A 1.75 mole of gas at temperature 330 K expands isothermally from an initial volume of 2.0 L to 8.0…

A:

Q: What units must the constant 0.644 have? 2.What should be the value of the constant when all units…

A: The correlation for calculation of heat transfer coefficient for forced convection in laminar flow…

Q: A gaseous organoflourine compound has a density of 0.3655 g/L at 20oC and 190mmHg. What is the molar…

A: Given that, The density of gaseous organofluorine compound = 0.3655 g/L Temperature T = 20oC =…

Q: A 25.5-L glass vessel is to contain 1.42 g moles of nitrogen. The vessel can withstand a pressure of…

A: Assume Nitrogen gas (Given)- Ideal gas Volume=25.5L moles=1.42 g mole P=29000+101325 Pa = 130325 Pa

Q: The volume of a propane cylinder used in joels gas grill is 0.960 l. When filled the cylinder…

A: P=745torr1atm=760torrP=0.9803atmT=25∘C=298KV=0.960LR=0.082atm.L/mol.K

Q: 4- A vessel having a volume of 0.6 m³ contains 3.0 kg of liquid water and water vapour mixture in…

A:

Q: A petroleum sample has a specific gravity of 0.847 at 20°C. If the coefficient of volume expansion…

A: The specific gravity of petroleum at 700C is to be calculated.

Q: A sample of an unknown gas is found to have a density of 2.66 g/L at a pressure of 1.10 atm and a…

A:

Q: T constant Liquid Vapor 0.30 0.40 0.50 0.60 X, or YA- 0.70 0.60 0.50 0.40 -X or Ys Using the data…

A:

Q: Transform the following graph into table values using the information given in the following graph.…

A: To find the points in a graph, select points in the graph and trace the corresponding values in…

Q: For the following hypothetical Eutectic binary system, A and B, determine the melting point of pure…

A: Hypothetical eutectic phase diagram is given as shown below,

Q: Show your complete solution for each problem. Only the final answer in your calculation should be…

A: WE KNOW THAT,  H = U + PV  WHERE,  H = ETHALPY  U = INTERNAL ENERGY  P = 0.005 MPa

Q: A sample of gas has a volume of 725 milliliters at 0.970 atm. What would its volume be if the…

A:

Q: The results of testing a liquefied petroleum gas tank (LPG) for a volume of 2000 standard cubic feet…

A: As per multiple question or multiple subparts guidelines, we are supposed to answer only first 3…

Q: Calculate the dewpoint pressure if T = 600F. Components %mass methane 18.13 ethane 3.74 propane…

A: COMPONENT MASS MOLECULAR MASS MOLE MOLE%(yi) Vapor pressure (mm Hg) at 60°F Methane 18.13 16…

Q: 5. What is the specific volume in ft³/lbm of a substance having these conditions: temperature of 57…

A: Specific volume is ratio of volume of substance and mass of the same substance. This property of…

Q: .. For the given crude oil has the following information: % Vol. 3. 7 20 20 10 10 10 20 a) Draw the…

A: Given data :%Vol.Cumulative Vol% TBP,…

Q: Given a benzene(1)/toluene(2) system at 30oC at the dew point, if the mole fraction of benzene in…

A: Given:  Vapor pressures of benzene = Psat1  = 36.7 torr vapor pressures of toluene = Psat2 = 118.2…

Q: Convert the following with whole solution 1. 23 m^2/s^2  to Btu/slug 2. 25 kPa to mbar to inch Hg…

A:

Q: van der Waals equation.

A: Ideal gas law equation is to study the characteristics of ideal gas. When there is need to study the…

Q: Consider the excess chemical potential of a gas, x= μ- where is the ideal contribution. Show that it…

A: Given The excess chemical potential of a gas μex=μ-μig Where  μig-Chemical potential for Ideal gas…

Q: As pressure approaches zero, the ratio of fugacity to pressure (1/P) for a gas approaches

A:

Q: If 450 kg/hr of equimolar gas mixture contains methane (CH,) and ethane (C,H) is compressed to 5Mpa…

A: Given: The mass flow rate of the mixture is given as m* = 450 kg/h The gaseous mixture is compressed…

Q: (1) Gas compressibility factor. (2) Gas formation volume factor. (3) If a gas well produces 10 000…

A:

Q: Calculate densities in lbm/ft3 of the following substances: A liquid with density of 995kg/m3. A…

A: Given:  A liquid with density = 995kg/m3. A solid with specific gravity = 5.7 Densities in lbm/ft3…

Q: 1) Form the following data for CH3CI T(°C) Y (dynes/cm) pL (g/cc) pv (g/cc) 10 20 19.5 17.8 16.2…

A: To relate temperature with its molecular surface energy by Ramsay-Shields equation. The temperatures…

Q: c) Calculate the volume of natural gas for given data in Table Q1 (c). Table Q1 (c): Natural gas…

A: Write the ideal gas equation as follows: PV = nRT     ...... 1   The pressure, P = 14.7 psia The…

Q: Calculate the pressure exerted by Ar for a molar volume 0.39L at 265K using the van der Waals…

A: The Vanderwaal equation of state is for real gases. One of the parameters explains the interaction…

Q: Kryptonite is dissolved in a solvent discovered in a laboratory, and the resulting solution is…

A: A solution whose shear stress and shear rate data is given τyx×10-3(kg/ms2) -dνx/dy(1/s)…

Q: 3. A 6.55 × 10 −3 M solution of Cd(NO 3) 2 can be made by dissolving ____ grams of the salt in…

A: The concentration of a solution or the amount of substance present in  the solution can be expressed…