Briefly explain the difference between a compressor and internal combustion engine.

Q: Write a short note on heat transfer in an internal combustion engine?

A:

Q: Draw and explain four strokes of Otto cycle based internal combustion engine. Also label various…

A: A internal engine is a four stroke engine. There are four strokes in this engine. The two strokes of…

Q: discuss the  Compression-ignition engine its parts and functions

A: Introduction: Combustion, commonly known as the burning of fuel particles, is the chemical process…

Q: In your own words, differentiate diesel engine from gasoline engine.

A: Both gasoline and petrol engines are internal combustion engines used very widely for road…

Q: . List five differences between SI engines and CI engines.

A: The common five differences between the SI engine and the CI engine are as mentioned.

Q: Discuss the importance of the valve system in an internal combustion engines

A: Internal combustion engines: These are the systematic arrangement of the mechanical component which…

Q: define the concept of Combustion or reaction efficiency in the context of an ICE hybrid engine

A: Combustion: Its a chemical process which releases energy by burning some material called as fuel,…

Q: What is the challenge and solution of natural gas compressor

A: Given Natural gas compressor To find Challenges and solution

Q: b) How to Investigate the variation of air flow rate with compressor ratio (With Intercooler)?

A: Air compressors are the device which is used to increase the pressure of air by applying for dynamic…

Q: O Explain how the following jet engine works. Refer to each section of the engine and explain the…

A:

Q: Explain the rationale of the parts as listed below of the jet engine with after burner. 1. Low…

A: JET ENGINE - A jet engine is defined as a reaction engine that provides thrust or propulsions by…

Q: Write a note and explain about Modification of turbojet engine

A: TURBOJET ENGINE  A turbojet engine has all the power by expelling a high-energy gas stream from the…

Q: Explain the relation between RVP with gasoline in a combustion engine if a car start at cold…

A: RVP stands for Reid vapor pressure. It is a common measure of the volatility of gasoline and other…

Q: Arrange 5 steps from beginning to final steps in the diesel engine.

A:

Q: What is the importance of knowing different parts of the gas turbine engine

A: The gas turbine is an internal combustion engine that uses air as the working fluid. The engine…

Q: In what way does the atmospheric condition affects the performance of the engine? Give examples.

A: Why does the atmospheric conditions affect the engine performance. Atmospheric conditions effect the…

Q: Discuss the benefits offered by turbo engines detailing the reasons why the cannot be used on motor…

A: Engine: It is a device which is used to convert chemical energy of fuel into heat energy through the…

Q: Relation of Carnot engine effciency to its intake temperature and exhaust temperature.

A:

Q: Give the design formulae of a dry liner in an internal combustion engine.?

A: To write: The design formula of a dry liner in an internal combustion engine. Concept used: Dry…

Q: Explain the knocking phenomenon in compression ignition engine

A: Knocking, in an internal-combustion engine, sharp sounds caused premature combustion of part of…

Q: Sketch a detailed schematic of a rocket engine and explain how it works.

A: 1) structural system:- The structural system, or frame, is similar to the fuselage of an airplane.…

Q: (1): We can classify IC engine into two categories on the basis of number of stroke for each cycle.…

A: To Describe :  The IC engine on the basis of number of stroke.

Q: Draw a neat diagram and explain the working principle of a two-stage reciprocating air compressor?

A: Two stage air compressors: With two-stage air compressors, the air is compressed in two stages; in…

Q: Why it is important to learn OPERATING PRINCIPLES OF INTERNAL COMBUSTION ENGINE

A:

Q: Conceptualize, model and simulate a turbofan engine using any software package

A: Turbofan engine   MODELLING METHOD :- the first step in creating a model of a physical system is to…

Q: Differentiate the cycles of Otto and Diesel

A: S.R                      Otto Cycles                         Diesel Cycles    1   2  Otto…

Q: Discuss the differences of diesel and gasoline engine.

A: