Basic Electrical Engineering) An inductance is connected to 115V, 25Hz and takes a 5A. What current will it take when the inductance and frequency are both doubled having same voltage? Show complete solution and limit your answer into three decimal places.

Basic Electrical Engineering) An inductance is connected to 115V, 25Hz and takes a 5A. What current will it take when the inductance and frequency are both doubled having same voltage? Show complete solution and limit your answer into three decimal places.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PA: You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor...

See similar textbooks

Related questions

Q: A series circuit consists of a 66.2-uF capacitor and a variable resistor. For what two values of…

Q: An inductor of 1 henry and a resistance of 2 ohm are connected in series with an EMF of 100 volts,…

A: For DC conditions , inductor acts as short circuit at steady state . using ohms law calculate…

Q: A 100mH pure inductance is connected in a parallel with a 40ohms resistor. What is the power drawn…

Q: Determine the values of resistance R and inductance L

A: We need to determine the values of R and L.

Q: Match each type of transducer with the corresponding physical phenomenon, law, or property where it…

A: We are given with the following choices: Lorentz law Charge Faraday's law Ohm's law Capacitance…

Q: A 100uf capacitor and a3.6kohm are connected in series. How long will it take for the capacitor to…

Q: 5) What is the equivalent inductance for the following?

Q: A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a…

A: As current through long time indicates that time "t" tends to infinity

Q: Find the current through the inductor shown in Figure lb. (i/p is AC, consider results upto one…

A: Ohm's Law : Ohm's Law states that voltage across any element is directly proportional to the current…

Q: Three capacitors are connected as shown below. C₁ = 4.00 F, C2 = 6.00 F, C3 = 30.0 F, and the…

A: The given circuit diagram is shown below: It is given that: C1=4 FC2=6 FC3=30 FVoltage across…

Q: Find the total inductance at the terminals a-b, for the circuit shown in FigureQ2(b). 25 μΗ 18 μΗ a…

Q: V₁ +1 R₁ www R2 ww + Xt = 0 UL - elle L iL

Q: I'm reading about the electronics in touch screen. It says when i touch the panel it distorts the…

A: According to the question, we need to explain the working of the touch screen.

Q: An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a…

A: Given: Inductor, L=0.2 H, Resistance, R=50 Ω, Frequency, f=60 Hz, Voltage, V=120 V.

Q: An inductor with an inductance of 3.6 H is connected to a 480-V,60 Hz line.Hiw much current will…

A: Given: inductance of the line L = 3.6 H Line voltage , VL = 480 v , 60 Hz To find the current in…

Q: Determine the total inductance in the below figure. L1 L3=6 mH, and L2 = L 4 = 2 mH. The result…

A: Given data, L1=L3=6 mHL2=L4=2 mH

Q: QUESTION 35 E-1, PC-2. Materials that have no free electrons are called? O thermistors O…

A: Materials that have no free electrons are called Insulators. Option D.

Q: 32/0°V( Β) -j4 Ω ΤΣ 8 8 Ω j10 Ω m 1ο ΖΩ V₂ www j6Ω ν Vo 1Ω www 14 13 -j2 Ω V3 -j4 V

Q: Calculate the total inductance at the terminals a-b, for the circuit shown in FigureQ2(b). 10mH 5mH…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Determine the values of resistance R and inductance L. need help on question C ，urgent

A: Solution (c) - The circuit diagram is shown below,

Q: ere you see a circuit with a battery, fully uncharged capacitor, C and a bulb. What would happen to…

A: Given :

Q: A capacitor has a capacitance of 18 micro- Farad. What current will it take @ 115 Volts, 60 cycles…

A: We’ll answer the first question since the exact one wasn’tspecified. Please submit a new question…

Q: An R-C series circuit has a supply voltage of 100 V. The resistance is 200 ohms and the capacitance…

Q: The resistance R and a 2 μF capacitor are connected in series across 200-V dc supply. Across the…

Q: A capacitor of 1µF is charged to 100 volts and then disconnected from the power supply. A second but…

A: First calculate initial charge on the capacitor. Now using initial charge calculate voltage across…

Q: Q3 Using superposition, determine the current through the inductance XL for each network in Figure…

Q: Three 20uF capacitors are connected in series with each other. A 1k ohm resistor and an LED…

A: C=20μFR=1kΩVT=9V

Q: A resistance of 12 ohms and capacitance of 0.01 farad is connected in series with a 200 volts…

Q: If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship…

A: The solution is given below

Q: An inductor is connected to a 240-V, 1000-Hz line. The circuit current is 0.6 A. What is the…

Q: A 2-Henry inductor has 120 turns. How may turns must be added to raise it inductance to 3 henry?…

Q: A 10uF connected in series with a 200 ohms resistor is charged by a 12 V source. How long will it…

Question

(Basic Electrical Engineering)

An inductance is connected to 115V, 25Hz and takes a 5A. What current will it take when the inductance and frequency are both doubled having same voltage? Show complete solution and limit your answer into three decimal places.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source. Solve for the current 2 milliseconds after the switch was turned on. a. 2.0000 Amperes b.1.9999 Amperes c.1.0001 Amperes d. 2.0001 Amperes
Describe the voltage across and the current through the inductor combination in both charging and discharging phases.
7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will havephase shift * 180 deg O deg 45 deg O 90 deg 8. Why do we say the "voltage across" or "the voltage with respect to?" Why can't we just say voltage? * Voltage is a measure of electric potential difference between two electrical points. O It's an electrical cliche. The other point could be negative or positive. None of the above.
I need the answer as soon as possible
A capacitor of 1µF is charged to 100 volts and then disconnected from the power supply. A second but uncharged capacitor of 3µF is then connected across the first capacitor. What is the voltage across the parallel combination? O a. 110 volts O b. 45 volts O c. 66 volts O d. 25 volts
If the charging resistor was twice as large as the discharging resistor in Figure 4, theamplitudes of the charging and discharging waveforms would be ________.a. The sameb. Different
I need the answer quickly
A Capacitance of 40 micro-Farad is connected across a 230 V (RMS), 60 cycles supply. What will be the value of the RMS current. 1.256 A 2.363 A 3.468 A 5.367 A
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
Q2) Consider the circuit in Figure (3), and answer 3 branch only. a) What type of circuit is this? b) What is the total peak secondary voltage? c) Find the peak voltage across each half of the secondary. d) Sketch the voltage waveform across RL. 4:1 120 V rms RL 1.0 k2 D2 eelee
For the series RL circuit shown in the figure below, answer the following questions and justify your answer.If the current is kept constant, does the coil have inductance?If the current is kept constant, does the coil affect the current value?Can the reverse emf ever be greater than the battery emf?