Based on the standard requirement of a system, it is given that the diameter of the bore of cylinders for clamping and drilling processes are 100 mm and 80 mm, respectively. It is expected that the clamping process will take a load of 700N while 650N will be loaded for drilling process. The speed movement for the clamping and drilling process is designed to be 120cm/min and 180mm/min, respectively. i. Compute the required flowrate for the pump for both clamping and drilling processes.  ii. Calculate the working pressure required for the system if only one cylinder is to be choose for both clamping and drilling processes.  iii. Which horse power of the motor is required?

Q: Fig. 3 shows the load torque variation for one cycle of a shaft driven by a constant torque With an…

A: Here given we have b=2tCs=0.2δ=8050 kg/m3I=125 kgm2Cycle time =4π

Q: Required information A 24-mm-diameter uniform steel shaft is 600 mm long between bearings. Take the…

A: the diameter of the steel rod d = 24 mm = 0.024 mthe length of the steel rod l = 600 mm = 0.6 mthe…

Q: A double acting hydraulic cylinder with the stroke of 4.5 in, has a bore diameter of 3 in. The rod…

A:

Q: 4. Ø.009MAB@ Answer:

A: refer generalized representation of geometric tolerance.

Q: Q.3 In a bushmandrel system, a bush was turned on a mandrel. The mandrel diameter in millimeter is…

A:

Q: 2. A thin flywheel rim 1.2m in diameter, is made of cast iron density 7.21 g/cm³. Find the speed in…

A:

Q: A single-threaded power screw with square threads pushes against a load of 3,736 N at a speed of 42…

A: Here,  is lead angle,  is pitch,  is mean thread diameter.

Q: An electric motor delivers 2 hp @ 1725 rpm to the input shaft of a reduction gear drive having a…

A: The power to input shaft iis The speed of gear of input shaft is The gear ratio is The loss in power…

Q: A single cylinder marine engine has a compression ratio () of 6.75, a clearance volume of 1200 cm…

A: Compression ratio, r=6.75 Clearance volume, VC=1200 cm3 Length of stroke, L=500 mm Determine the…

Q: 8. Calculating advancing and retracting times toandvel a) Calculate the cylinder's surface area…

A:

Q: An engine cylinder has a compression ratio (r) of 7.5, a clearance volume of 35 cm³ and a piston…

A:

Q: has a compression ratio (r) of 7.5, a clearance volume of 35 cm3 and a piston stroke length of 325…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.