b) The motor-pump system shown in Fig. 5.36(a) is modeled as a rigid bar of mass m=50kg and mass moment of inertia A = 100 kg-m. The foundation of the system can be replaced by two springs of stiffness k = 500 N/m k = 200 N/m. and Determine the natural frequencies of the system. C.G. m, Jo Motor, Pump C.G. xt) Base (a) Foundation FIGURE 5.36 Motor-pump system on springs.

b) The motor-pump system shown in Fig. 5.36(a) is modeled as a rigid bar of mass m=50kg and mass moment of inertia A = 100 kg-m. The foundation of the system can be replaced by two springs of stiffness k = 500 N/m k = 200 N/m. and Determine the natural frequencies of the system. C.G. m, Jo Motor, Pump C.G. xt) Base (a) Foundation FIGURE 5.36 Motor-pump system on springs.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 15. In the system shown to the right, the pulley has mass m and radius r, so that the moment of…

Q: 3) A one-degree-of-freedom system has an effective mass M=4-kg, an effective spring stiffness…

Q: 6.25. A 30,000-kg locomotive is coupled to a fully loaded 20,000-kg boxcar and moving at 6.5 m/s.…

Q: 3) A one-degree-of-freedom system has an effective mass M-4-kg, an effective spring stiffness…

A: To find (a) The natural frequency ωn and critical damping ratio ζ (b) The response q as a function…

Q: k1 m1 Jo- k2 m2

Q: Equivalent stiffness of a beam system is 105 N/m and mass of the object resting on the beam system…

Q: A perfectly balanced motor with its shaft has a mass of 18 kg , and a 2 kg disc is fixed onto 18 kg…

Q: The tip of a massless clamped-free beam connected to mass m = 2 kg by a spring with stiffness k =…

A: The mass of the block, The stiffness of the spring, The mass is excited by the force, The Young's…

Q: ounted on a vertical wall to support a 64.4 lb mass. At t=0 and an initial velocity of 9 in/sec. to…

A: GIVEN:K=54lb/inm=64.4lbv=9in/sec

Q: natural frequencies -

A: m=50 kg Jo=100 kg-m2k1=500N/m…

Q: Q.22 The natural frequencies corresponding to the spring-mass systems I and II are o, and O,…

Q: b. The semidefinite system shown in Figure 6 consists of a translating mass m=100 kg attached to a…

Q: Problem 4.3 The equation of motion of a certain mass-spring-damper systems is 5x + cx + 10x = f(t)…

A: The equation is The applied force is The maximum amplitude at stready state is no greater than

Q: System is shown. mass=M Length = L Uniform rod is pivoted about one end and oscillates in a…

A: givenmass of uniform rod=Mlength of uniform rod =Lone place a mass m=M

Q: 59. A mass m is mounted betwe two springs with constants k, and k2, as shown in Fig. 13.32. Show…

A: As per the policy of the bartleby I can answer 1st question only. All the questions are different to…

Q: Q.5 The rotating unbalance of a 185 kg machine is 0.65 kg.m. The machine is paced at the midspan of…

Q: 1. For the system shown, the spring constant k = 400 kN/m, damping coefficient zeta = 0.5 and the…

Q: Exercise 1. A mass trailer M, attached to a wall by a spring and a damper with damping coefficient…

Q: The following system is oscillating under the action of a moment M = 20 sin(3t), it consists of a…

Q: A mass of 2 kg is attached to a spring with a spring constant of 100 N/m. The mass is pulled 100 mm…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: In the system shown, a force P(t) is applied at C. Bar ABCD is of negligible mass. Determine: The…

Q: As shown in the figure, a homogeneous rod with a length L = 1 (m) and mass m=0.1 (kg) is fixed so…

A: givenhomogeneous rod with a length L=1mmass of uniform rod m=0.1kguniform rod hinged at middle…

Q: For the system below, the mass, m is attached to the end of a cantilever beam of length, l,…

Q: end mass m is supported by two springs of stiffness K. Choose x and ordinates at the center of…

A: Draw a diagram and giving small angular displacement 'θ'- 1- Elongation in spring…

Q: (a) A mass suspended from a helical spring of stiffness s, is displaced by a distance x from its…

Q: The tail rotor section of the helicopter has 4 blades. Each of mass 2.3kg and the engine box of mass…

A: option B is correct

Q: A 1-kg mass is attached to a spring with stiffness 1 N/m. The damping constant for the suystem is 2…

A: Given data: massm=1 kgspring stiffnessk=1 N/mdamping constantc=2 N sec/minitial velocityv=30…

Q: The model shown is to be studied. Determine: Natural frequencies and Modes Obtain the response of…

A: FREE BODY DIAGRAM is a diagram of the system which represents all the forces acting on the system.…

Q: A rotational spring-mass system is shown to the right. The slender rigid bar nas a mass of 18 kg and…

A: Springs generally deform under an applied force. This deformation is a function of nature of force.…

Q: Q.22 The natural frequencies corresponding to the spring-mass systems I and Il are o, and O,…

Q: Pravinbhai

A: The objective of the question is to find the amplitude of the oscillation of the mass connected to…

Q: 4) A planet that has a hollow core consists of a uniform spherical shell with mass M, outer radius…

A: Given Data: The mass of the planet is M. The outer radius is R and the inner radius is R/2. Part…

Q: Mo To 2k /7 1/7

Q: Q5) The motor-pump system shown in Fig. 3 is modeled as a rigid bar of mass m = 50 kg, and mass…

A: Introduction: A spring-mass system, which is used to isolate vibrating equipment from its support…

Concept explainers

Properties of Pure Substances

A substance with fixed chemical composition throughout is called a pure substance like water, air, and nitrogen. A pure substance does not have to be a single element or compound. A mixture of two or more phases of a pure substance is also a pure substance as long as the chemical composition is the same for all phases. These substances mainly have a constant/ uniform composition. The substances also have fixed boiling and melting points. A pure substance takes part in a chemical reaction to form predictable products.

Question

b) The motor-pump system shown in Fig. 5.36(a) is modeled as a rigid bar of
mass m=50kg and mass moment of inertia A = 100 kg-m². The foundation of
the system can be replaced by two springs of stiffness k = 500 N/m k = 200
N/m. and Determine the natural frequencies of the system.
C.G. m, Jo
Motor
- Pump
C.G.
Base
Foundation
(a)
FIGURE 5.36 Motor-pump system on springs.
0mm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

-For the vibrometer with mass (2kg) & spring stiffness (k), base excitation y(t)=b sin(wt), itation frequency=5Hz, 2Z=24mm & zeta=0.2, frequency ratio (r)=2, find: ● Wn. K. ● ● ● Amplitude ratio Z/Y. b & delta. 2 kg Structure. W D 24 mm
Q2. A young child is suspended in a baby bouncer as shown in Figure Q2, with k = 555 N/m and c = 6 Ns/m, and it is observed that the equilibrium is established when the flexible chords are stretched down by 224 mm. k,c Figure Q2 The parents pull the child down by 185 mm from the equilibrium position and release her. (a) Determine the mass of the child. (b) Determine the circular frequency of the undamped vibration. (c) Calculate the damping ratio. (d) What is the amplitude of the vertical displacement of the child from the equilibrium position after 5 oscillations? (e) Calculate the amount of energy stored in the chords when the child is back in the equilibrium position.
Problem 1. For the spring-mass-damper system shown to the right, x is measured from the static equi- librium position, and the surface is friction- 手 less. a) Determine the governing equations of m motion. 6 k 2 c b) What is the period of each oscilla- tion in terms of the system parameters (т, k, с)? For what value of c is the system criti- cally damped? d) If the system is released with the initial conditions: x(0) = 0.0 m, à (0) = 5.0 m/s, find the resulting solution x(t) if m = 2 kg, k = 48 N/m and c= 4 N/(m/s).
A mass of m = 12 kg is suspended by a spring of stiffness of S = 1 KN/m from a fixedsupport. The mass vibrates freely with amplitude of 0.008 m. Ignore the effect of dampingand mass of the spring. Calculatei. The maximum restoring force.ii. The natural frequency.
(Please solve by hand and explain procedure)
A dynamic torsional system, consisting of five disks keyed to a 1 inch diameter steel shaft is vibrating freely at a natural frequency. An end disk has a moment of inertia, I1 of 5 in-lb-sec2 while the next one to it has a I2 of 10 in-lb-sec2. The distance between these disks is 8 inches. The amplitude ratio of these disks Theta1/ Theta2 is -2. Determine its natural frequency in cpm. Use G=12x106 psi.
- A (50 kg) mass is hanging from a spring of stiffness (5 *10ª N/m). A harmonic force has magnitude (100 N) and frequency (100 rad/s) is applied to the system. Determine the following: a) The Amplitude of the forced response if the c. b) The natural frequency of the system.
A block of mass m = 400 g, is attached to a horizontal spring and set in simple harmonic motion as shown. At what point(s) in the motion is the velocity of the block at its maximum? ww X = -A O a. x = 0, and x = -A O b. x=0, x= -A, and x = -A O e. O c. O d. x = 0 x = -A, and x = +A . x = 0, and x = +A m x = 0 X = +A
A single degree of freedom spring mass system has a natural frequency of 10 cycles per second. Another single degree of freedom spring mass system is attached to it. The latter had a natural frequency of 20 cycles/second. What is the approximate fundamental frequency of composite system?
2) A massless bar of length L carrying a tip mass m is rigidly connected to a homogenous disk of radius R and mass m as shown below. The disk rolls without slipping on the ground. Note that gravity acts down and that a spring of stiffness k and a dashpot of constant c connect the center of the disk to an oscillating wall and a fixed one respectively. Determine the amplitude of response of the angle 0(t).
DEPARTMENT OF MECHANICAL ENGINEERINGMENG 331 DYNAMICS OF MACHINERY
Question 1: Determine the natural frequency (wn) for the system shown in fig which consist of a slender bar with mass (m), spring of stiffens k and mass (M) fixed by rigid link, M