Q5: B: Peripheral milling is performed on the top surface of a rectangular work part that is 300 mm long by 50 mm wide. The milling cutter is 60 mm in diameter and has four teeth. It overhangs the width of the part on both sides. Cutting speed 50 m/min, chip load 0.3 mm/tooth, and depth of cut 5 mm. Determine maximum material removal rate during the cut?

Q5: B: Peripheral milling is performed on the top surface of a rectangular work part that is 300 mm long by 50 mm wide. The milling cutter is 60 mm in diameter and has four teeth. It overhangs the width of the part on both sides. Cutting speed 50 m/min, chip load 0.3 mm/tooth, and depth of cut 5 mm. Determine maximum material removal rate during the cut?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Problem #2: Do a comparison between turning Vs. milling operations use some graphs if possible.
Please answer it correctly. Thank you
What is the feed speed (mm/min) of an end milling cutter if it mills a distance of 300 mm in ten minutes? What is the feed per tooth if it is rotating at 800 rpm?
A NC lathe cuts two passes across a cylindrical workpiece under automatic cycle. The operator loads and unloads the machine. The starting diameter of the work is 3.00 in and its length = 10 in. The work cycle consists of the following steps (with element times given in parentheses where applicable): 1 - Operator loads part into machine, starts cycle (1.00 min); 2 - NC lathe positions tool for first pass (0.10 min); 3 - NC lathe turns first pass (time depends on cutting speed); 4 - NC lathe repositions tool for second pass (0.4 min); 5 - NC lathe turns second pass (time depends on cutting speed); and 6 - Operator unloads part and places in tote pan (1.00 min). In addition, the cutting tool must be periodically changed. This tool change time takes 1.00 min. The feed rate = 0.007 in/rev and the depth of cut for each pass = 0.100 in. The cost of the operator and machine = $39/hr and the tool cost = $2.00/cutting edge. The applicable Taylor tool life equation has parameters: n = 0.26 and…
Give me correct answers someone gives fully wrong anders please
1. Peripheral milling is performed on the top surface of a rectangular work part that is 350 mm long by 60 mm wide. The milling cutter is 75 mm in diameter and has five teeth. It overhangs the width of the part on both sides. Cutting speed 55 m/min, chip load 0.25 mm/tooth, and depth of cut 5 mm. Maximum material removal rate during the cut will be mm/s. (a) 1419, (b) 1429, (c) 1439, (d) 1449, (e) 1459
i need the answer quickly
A 450 mm long work piece is finished using a face milling cutter with a diameter of 75 mm. The overrun is 4 mm and the cutting depth of 3 mm. Calculate the total milling length.
I need the answer as soon as possible