B-Correct the wrong sentence: 1. Adiabatic compression is the most desirable process to get minimum work in the compressor. 2. The thermal efficiency of constant pressure cycle is depends on the compression ratio 3. The most important fuel elements are carbon and ash. 4. The pressure of a mixture of gases is equal to the sum of partial masses of the constituents.

B-Correct the wrong sentence: 1. Adiabatic compression is the most desirable process to get minimum work in the compressor. 2. The thermal efficiency of constant pressure cycle is depends on the compression ratio 3. The most important fuel elements are carbon and ash. 4. The pressure of a mixture of gases is equal to the sum of partial masses of the constituents.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Read the question carefully before answering. Box or indicate your final answers when solving and draw your diagrams cleanly. Complete solution please. Use 2 decimal places when solving and for final answers. Draw the PV and TS diagram with proper label of points when required. 4. An ideal Brayton Cycle has air at 100kPc. and 25C entering the compresser After the heating process, the air has a max temperature of 870 C, and the pressure is 10 times of the initial pressure Draw the PV and TS diagrams, find the QA. WT. Wc, Whet, and efficiency.
What is an example of a negative entropy change in a system? a. It is not possible due to the second law of thermodynamics. b. Condensation of water in a piston-cylinder assembly c. Gas tank with a heating jacket d. Adiabatic expansion of vapor
a.Draw a schematic diagram with labels of states of a substance; b.For uniformity purposes, assign STATE 1 at the inlet of a high-pressure turbine. The states must be arranged in a chronological order; c.Plot each cycle in a t-s diagram with the states consistent to the states assignment in the schematic diagram; d.Show a detailed solution. Consider a regenerative vapor power cycle with a single open feedwater heater. Steam enters the first turbine stage at 12MPa, 500 0C, and expands to 0.3MPa where some steam is extracted and fed to the feedwater heater. The remainder expands through the second-stage turbine and exits at the condenser pressure of 0.01 MPa. Saturated liquid at 0.3 MPa leaves the open feedwater heater. If the net power output of the cycle is 100 MW,and the turbine stages and pumps are isentropic, determine (a) the thermal efficiency, and(b) the mass flow rate of steam entering the first turbine, in kg/h.
PLEASE FOLLOW THE INSTRUCTION.
PLEASE FOLLOW THE INSTRUCTION.
Show both ts and pv diagram. Show the complete and step by step solution. THERMODYNAMICS
Which of the following statement is not true of the diesel cycle? (you must use thermodynamic diagram with explanation.)a. The expansion process is an isentropic process.b. The exhaust process is a constant-volume process.c. The combustion process is a constant-volume process.d. The compression process is an adiabatic process.e. One heat transfer process is a constant-pressure process
As shown in the figure, air with a volumetric flow rate of 17,000 ft/min enters an air-handling unit at 80°F, 1 atm. The air-handling unit delivers air at 45°F, 1 atm to a duct system with three branches consisting of two 26-in.-diameter ducts and one 50-in. duct. The velocity in each 26-in. duct is 19 ft/s. Assume steady state operation and ideal gas behavior for the air. 4+D - 50 in. Duct system T2 = 73 = T, = 45°F D; = Dz = 26 in. V2 = V3 Air-handling unit 1+ Pi = P2 = P3 = P4 = 1 atm T = B0°F (AV), Determine the mass flow rate of air entering the air-handling unit, in Ib/s, the volumetric flow rate in each 26-in. duct, in ft/min, and the velocity in the 50-in. duct, in ft/s.
(a) With a neat sketch, explain the working of Floating gas holder type biogas plant. List any two disadvantages of this type of biogas plant.
Steam enters the turbine of a vapor power plant at 600 lbf/in.2, 1000°F and exits as a two-phase liquid–vapor mixture at 90°F. Condensate exits the condenser at 85°F and is pumped to 600 lbf/in.2 The turbine and pump isentropic efficiencies are 90 and 80%, respectively. The net power developed is 1 MW.Determine:(a) the percent steam quality at the turbine exit.(b) the percent thermal efficiency.(c) the steam mass flow rate, in lb/h.
Which one of the following assumptions is NOT included in Air-Standard analysis? Combustion is replaced by external heat transfer. Processes are considered to be internally reversible. There is no exhaust but a constant volume heat transfer. The air, fuel and burnt fuel are all modeled as an ideal gas. Specific heats are constant at ambient temperature values.
Bottom part only please, Discuss why the petrol engine is irreversible in terms of entropy and work lost due to the spontaneous flow of heat resulting from finite temperature differences.