(b) An earth embankment is to be constructed. The soil is to be compacted at maximum dry density of 18 kN/m³ at optimum moisture content = 15%. The in-situ bulk density and water content in borrow pit are 17 kN/m³ and 8% respectively. How much excavation should be carried out in the borrow pit for each cubic meter of embankment? Assume: G = 2.7; Y₁ = 10 kN/m³.

(b) An earth embankment is to be constructed. The soil is to be compacted at maximum dry density of 18 kN/m³ at optimum moisture content = 15%. The in-situ bulk density and water content in borrow pit are 17 kN/m³ and 8% respectively. How much excavation should be carried out in the borrow pit for each cubic meter of embankment? Assume: G = 2.7; Y₁ = 10 kN/m³.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The rate of upward seepage taking place through a granular soil contained in a tank is 976.5 cm³/sec. Given that H1 = h = 1.8 m, the area of the tank = 0.62 m², void ratio of the soil = 0.55, the specific gravity is 2.65, and the hydraulic conductivity of the sand is 0.21 cm/sec, determine the following: a. The hydraulic gradient. b. Length of H2. c. The critical hydraulic gradient of the soil sample. d. If boiling will occur at h = 2.5 m? Justify your answer by showing the appropriate comparison by solving. e. The value ofh to cause boiling. (は) A H2 Valve (open) Inflow
Q4 A 0.7m long soil specimen is subject to a steady-state flow, as shown in Figure Q4. The saturated unit weight of the soil is 20 kN/m³. Determine the following: Water 0.3 m 0.8 m А 0.3 m Datum 0.4 m Y Figure Q4 a) Total head (m) at point A, B and C. b) Elevation head (m) at point A, B and C. c) Porewater pressure head (m) at point A, B and C.
An exploratory drill hole was made in a stiff saturated clay having a moisture content of 29% and G, = 2.68 (Figure 9.27). The sand layer underlying the clay was observed to be under artesian pressure. Water in the drill hole rose to a height of 6 m above the top of the sand layer. a. If an open excavation is to be made in the clay, determine the safe depth of excavation before the bottom heaves. b. How much is the pressure at the interface of the clay and sand? c. If a factor of safety of 2.0 is to be ensured, how deep should be the excavation from the ground surface?
Embankment is to be built with 15 km length of proposed road with 2 m height of road embankment. The cross sectional area of embankment and distance of borrow pit from embankment are 30 m² and 10 km respectively. Soil is to be compacted to 97 % of the max dry density. Information given as follows: (a) Results from laboratory compaction test: Max dry density-1.80 Mg/m³ Optimum water content=12% (b) Borrow material: Dry density-1.70 Mg/m² Water content-8% Calculate volume of additional water required for the entire volume of the embankment Final answer should be = 27, 486 m³
4. With two cases shown in the following figure: Plot pore pressure with depth for the soils if hydraulic conductivity of soils K1 = 5 x K2. a- b- flow through a unit thickness of the cross-section if K1 = 5 x 10$ (f/s) and K2 = 1 x 10$ (f/s). Estimate the rate of seepage (q) per linear foot of cross-section, i.e. calculate the rate of C- Plot flow net for 2 cases. -z (ft) z (ft) Water Water 3 ft 3 ft Soil 1 1.5 ft Soll 1 Sol 2 3 ft 3 ft 3 ft 1.5 ft Soil 2 Datum psf Datum psf porous stone porous stone 3 ft 1.5 ft 1.5 ft Case 1 Case 2
The proposed grading at a project site will consist of 25,100 m³ of cut and 23,300 m³ of fill and will be a balanced earthwork job. The cut area has an average moisture content of 8.3%. The fill will be compacted to an average relative compaction of 93% based on a maximum dry unit weight of 18.3 kN/m³ and an optimum moisture content of 12.9% obtained from the modified Proctor test. Compute the volume of water in kiloliters that will be required to bring these soils to the optimum moisture content.
How to solve this question? A soil has a dry density of 1.84 g/cm3 and void ratio of 0.45. Calculate the factor of safety against quick sand condition if the hydraulic gradient is given as 0.46.
The section through a long cofferdam is shown below, the coefficient of permeability of the soil being 6x10-8 m/s. Determine the quantity of seepage entering the cofferdam. 5.50 m I 0 1 2 3 4 5 As = 0.70 ml +cl 10 B ax 15 m
Determine the maximum dry unit weight and the optimum moisture content. W% 6.2 8.1 9.8 11.5 12.3 13.2 ybkN/m3 16.9 18.7 19.5 20.5 20.4 20.1 sivah a What is the dry unit weight and w at 95% standard compaction? b. Determine the degree of saturation at the maximum yd , Gs = 2.7? C Plot the zero air voids line?
ssion begins when the primary consolidation ends. B. The soil from a borrow area is excavated and used in a compacted fill for an embankment. The void ratio at the borrow area and the compacted fill are 0.96 and 0.62, respectively. What would be the volume of the excavation in the borrow area to construct 200,000 m3 of compacted fill? Q2:
A flow net below a dam consists of 24 equipotential drops and 7 flow channels. The difference between the upstream and downstream water levels is 6 m. The length of the flow line adjacent to the toe of the dam at exit is 1 m. The specific gravity and void ratio of the soil below the dam are 2.70 and 0.70, respectively. The factor of safety against piping is
A fill having volume of 150000 m³ is to be constructed at a void ratio of 0.8. The borrow pit solid has a void ratio of 1.4. The volume of soil required to be excavated from the borrow pit will be (a) 150000 m³ (c) 250000 m³ (b) 200000 m³ (d) 300000 m³