(b) A mobile network designer estimated that the size of the first Fresnel zone in the middle of a 2 km link be 7.84 m. The towers (transmitter and receiver) are 10 m tall. (i) What is the maximum usable frequency to be used for this communication? (ii) How tall could an obstructed structure at that midpoint be to clear 60% of the first zone (i.e. 40% of blocking)?

(b) A mobile network designer estimated that the size of the first Fresnel zone in the middle of a 2 km link be 7.84 m. The towers (transmitter and receiver) are 10 m tall. (i) What is the maximum usable frequency to be used for this communication? (ii) How tall could an obstructed structure at that midpoint be to clear 60% of the first zone (i.e. 40% of blocking)?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Draw the architecture of the satellite electrical power subsystem, including components.
4. If the spacing between the conductors of the transmission line is made to be large compared to their diameters. The corona effect will be: a. Not change b. decrease c. Increase d. will be very high 5. The critical disruptive voltage of corona is a. the maximum phase-neutral voltage at which corona occurs. b. the minimum phase-neutral voltage at which corona occurs. c. the maximum phase-neutral voltage at which corona dissappear. d. the minimum line-line voltage at which corona dissappear. e. Non of them e. Non of them. 6. A wind turbine travels with the speed is 20 m/s and area swept by windmill is 160 m², If air density = 1.5 Kg/m³ .The extracted power from turbine is a. 6.4 MW b. 3.2 kW c. 1920 kW d. 960 kW e. Non of them
When does Naive Gauss Elimination fail?
What different types and modern usage areas of transmission lines and waveguides ? Explain and compare the operation principles and usage areas.The answers must be long
7. A microwave link consists of repeaters at 40-km intervals. What must be the minimum height of trans- mitting and receiving antennas above ground level (given that they are the same) to ensure line-of-sight conditions"
B.1. Attenuation is measured inA. parts per million (ppm).B. watts (W).C. decibels (dB).D. amperes (A). B,2. While you're wiring portions of a structured cabling system, you add a conductor termination thatautomatically removes the insulation from the conductor as it's seated into the connector. Which of thefollowing connection techniques did you use?A. Fiber optic terminationB. CleavingC. Plug-compatible connectionD. Insulation displacement connectionB.C. Which of the following is a specialty electrical wiring system that's used in patient care areas of healthcare facilities to provide added protection against the possibility of electrical shock?A. An isolated power systemB. An intrinsically safe circuit systemC. A redundant grounding systemD. An automatic transfer switching system
2.7-2.8 Theory
QUESTION 5: What is the propagation mode for the following fiber-optic cable? Does this propagation mode suitable for long distance transmission? Why?
Question 3: Draw the constellation diagram for the following cases and define the types of modulation. a. Two points at (3,0) and (2,0) b. Two points at (0,3) and (0,-3) c. Four points at (3,3), (-3,3), (-3,-3) and (3,-3) d. Four points at (2,0), (4,0), (-2,0), (-4,0)
4- Prove that the Transmission system behavior differs at low and high frequencies?