(b) A cantilever truss has support reaction at A and B was hanging one pot flower of 25kg as shown in Figure Q1(b). Categorize member AC, BC and BD whether in compression or tension condition. A 02m C 02m E 0.1m G 0.1 m B 0.3m

Q: Answer the table below. The truss illustration and instruction is also below

A: Step 1: Step 2:Step 3:Step 4:

Q: The members of the truss shown has cross sections of 500 mm2 in tension and 800 mm2 in compression.…

A:

Q: Calculate the forces in members AC, AD, and DE for the loaded truss. Restraining link BC is…

A: To solve this problem we will use method of joint,which is shown in calculation below

Q: The truss structure shown below is subjected to the following loads F1=549 lb F2= 839 lb F3= 806…

A:

Q: The members of the truss shown has cross sections of 500 mm2 in tension and 800 mm2 in compression.…

A:

Q: Determine the reactions at the supports using the force method. AE is constant. Note: Consider Cx as…

A:

Q: 1. Is this truss (simple, compound or complex )truss? 2. Determine the bar force in member AF of the…

A:

Q: Determine the force in each member of the truss. State whether the members are in tension or…

A:

Q: 4. For the truss shown, determine the forces in members AB, BG, ED and GF 6 kN 2.4m B 24m C 24 m D…

A:

Q: find the forces in each member of the truss

A:

Q: For the following problems use an allowable stress equal to 25 ksi for both tension and compression.…

A: A truss is a construction made up of parts arranged in linked triangles such that the entire…

Loads and Reactive Forces

Loads are the external influences that a beam experiences under its working conditions. For instance, a beam may be subjected to shear loads, twisting loads, bending moment, and axial loads during its working conditions. Engineers primarily deal with beams and trusses in the civil engineering domain. Due to the influence of loads, it is very crucial to determine the induced stresses and deformation values. These values give an insight into the critical area of the beam that needs to be worked upon to make it fail-safe.