b) A 208-V three-phase power system consists of an ideal 208-V Y- connected three-phase generator connected through a three phase transmission line to a Y-connected load. The transmission line has an impedance of 0.06 + j0.12 2 per phase, and the load has an impedance of 12 + j9 92 per phase. For this simple power system below; Vcm-120-240° V-120-120° 2 Van-12020⁰ 0.06 www 0.06 Ո www 208 V 0.06 www 0.12 2 j0.12 2 2012 Ω m Find; i) The magnitude of the line current IL ii) The power factor of the load 24 % % Z, = 12 + j9 Q

b) A 208-V three-phase power system consists of an ideal 208-V Y- connected three-phase generator connected through a three phase transmission line to a Y-connected load. The transmission line has an impedance of 0.06 + j0.12 2 per phase, and the load has an impedance of 12 + j9 92 per phase. For this simple power system below; Vcm-120-240° V-120-120° 2 Van-12020⁰ 0.06 www 0.06 Ո www 208 V 0.06 www 0.12 2 j0.12 2 2012 Ω m Find; i) The magnitude of the line current IL ii) The power factor of the load 24 % % Z, = 12 + j9 Q

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a three-phase system the per-unit phase voltages are 100° , Vôn = 0.8Z180° Van 0.920° , Von = 0.92 - а What are the per-unit symmetrical components V0) and V)? Express in polar notation.
19. Two single phase generators operating in parallel have no-loads emfs of E₁ = 24020° V and E₂ = 240/10° V and respective synchronous reactance of Xs1 =j2.5 ohms and Xs2 = j3.1 ohms. Resistances are neglected. The common load is purely resistance of 10 ohms. Find the common terminal voltage in volts. d. 232.65 V d. 6.05, 17.8 A d. 4,985 W a. 236.98 V 20. Referring to problem 19, find a. 6, 17.9 A 21. Referring to problem 19, find a. 4,464 W b. 234.76 V c. 240 V the current of each generator in amperes b. 5.82, 18 A c. 6.34, 17.5 A the total power in watts b. 5,792 W c. 5,616 W
An ideal boost converter is utilized in designing a PV storage system. The boost converter is operating at the boundary layer between the continuos conduction mode and discontinuous conduction mode. Design the mathematical model of the switching frequency for this boost converter in terms of load, duty cycle and inductance under the above operating conditions.
Number 17
18. A 415 V, 50 Hz, 3-phase supply of phase sequence RYB is connected to a delta connected load in which branch RY consists of R, = 100. branch YB conists of R₂ = 20 2 in series with X₂ = 60 Q and branch BR consists of a capacitor C= 30 uF. Take Vy as the reference and calculate the line currents. Draw the complete phasor diagrams. (Elect. Machines, A.M.I.E. Sec. B. 1989) 14.54, 1, 10.66 2172,92, 14.46 2-471 (1 = 7.78
Referring to the circuit shown in Figure 1 below, solve the following problems: - i) Calculate the total impedance, ZT. ii) Determine the total current, Ir supplied by the generator iii) Determine the value of current at load impedance, I1, I2 and I3. iv) Calculate total real power, PT and reactive power, Qr supplied by the generator. v) Draw a power triangle of this circuit vi) Calculate the power factor of this circuit.
Two three-generator are parallel at 6.6 kV and delivering 3000 kW at 0.8 pf. The impedance for machine A is 0.5+j10 ohm and for B 0.4+j12 ohm. The excitation of A is adjusted to deliver 150 A at lagging pf. Determine the induced emf of machine A.
please show complete solution thanks
By comparing the principle of operation of a "three" phase generation system with a single-phase system, state what are the bendfits of three phase systems? In your own words, define the "skin effect" in transmission lines and discuss how can it be minimised? Name three advantages of AC transmission in comparison to DC transmission. What are the units of active, reactive and apparent power? The current in a single-phase motor lags 50° behind the voltage. What is the power factor of the motor?
A 15-Kv, 35-KVA O.76P.flagging SOHZ Four-Pole Y-connected Stecim - turbine generatov has a synchronous reactane of 3.50r perphase and an armatnre resi stenue of 0:75r Per Phase Ihis generat is operating in parallel with large fower Systemm C Infinite bus) What is the magnitude of fA at rated to nditiun- 5IF He field Cumeit is constaut, Whet is the Max in um power possible out of this How much reserve power or tougue does this genevatou have at full load? What is te gen-eratur; tovque angle at rated candition. genevatr? O Sketch He covrespouding ghasor diagrem aud calcu. for the armatune cumert Cassume Hhe freld cument is sti une hauged) · OAt te alsolute fower posible, how much reactive prwer uwill this generatuv be Supplying or consuming ?
a syn A: A sylienfonotus generator of 100 MVA, 22 kV, and 0.25 pu transient reactance supplies a motor of 50 MVA, 22 kV, and 0.2 pu transient reactance. The motor is drawing 40 MW at 0.8 power factor leading and terminal voltage of 21.9 kV. The line connecting them has a reactance of 0.05 pu on a base of 100 MVA. Find the transient currents in the generator, the motor, and the fault when a 3-ph fault occurs at the motor terminals. Take SB = 100 MVA, VB = 22 kV, and use the internal voltages %3D %3D of the machines method.
Power engineering book Mehta