At cross-section 1 the average velocity of the water in the pipe is 0.922 m/s and the pressure is 2.943 bar. Assume that energy losses are negligible. T) Find the total flow rate in the system. g) Find the velocity at cross-section 2. h) Find the pressure at cross-section 2. The pipeline branches just beyond cross-section 2 into two pipes of diameter d3 = 1504 mm and d4 = 1504 mm as shown in the figure. The average velocity at cross-section 3 is of the velocity in the main pipeline at cross-section 2. i) What is the average velocity of flow at cross-section 4?

Q: 1) A pipe carries water from the bottom of a pool to the top of a water slide with the aid of a…

A: Given: energy output of the pump per unit volume=62 KJm3 and volume flow rate→Q=0.3 m3sec so power…

Q: Questo ): The fluid (SG = 0.8 and μ = 1.25x10-³ Pa-s) is flowing inside a 30-cm-diameter tube with…

A:

Q: 1 QUESTION 1 Consider a desired pump operating condition which adds 35 psi at a flowrate of 500 gpm…

A: Given data  Flow rate = 500 gpm Pressure = 35 psi Density = 62 lbm/ft^3 Find the pump head

Q: Tractor mounted sprayer having 14 nozzles 60 cm apart is moving at a forward speed of 35 km/h. The…

A: Number of nozzles: 14Nozzle spacing: 60 cmForward speed: 35 km/hRate of chemical mixed with water:…

Q: A) Fnd the flow rate in m. B) the maximum height h, to which The Water Can flow if thz Velocity at…

A:

Q: Answer the following:  e.) What is the pump head?  f.) Pump horsepower or water power

A:

Q: 7. Water at 10°C is flowing at 0.1 m/s velocity flows through a circular pipe with an inner diameter…

A:

Q: 6. A fabricated assembly made from three different sizes of standard steel tubing is shown below.…

A:

Q: 1.A fluid at a temperature of 28 oC flows at a speed of 10 m/s across a pipe outer diameter of 5 cm…

A: Given, Initial temperature,Ti=28°CFinal temperature,Tf=125°CVelocity, V=10m/sDiameter, D=5cma). Air…

Q: Find the flow rate for this Sprinkler head. Given a flow factor, for a 1/2" sprinkler orifice, of K…

A:

Q: this is incorrect Note that n-th geometric cash flow = A1(1+g)^n-1

A: Given:Cost of natural gas in first year,  The cost increment in the next year is the total number of…

Q: An incompressible fluid flows through a pipe that has two sections: a wide section with a diameter…

A: Introduction In fluid dynamics, an incompressible flow is a flow in which the density is constant…

Q: If the fluid motor has an efficiency of 78 percent, how much power is delivered by the motor? 1-in…

A: Hydraulics and pneumatics technologies are referred to as "fluid power." To transmit power from one…

Q: The difference between the headwater and the tail water elevation is 150 m. The head utilized by the…

A:

Q: Hydraulic motor calculations Theoretical flow = 1.5 GPM RPM output = 100 RPM Mechanical power =…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.