Can you distinguish the distinction between vapor compression and vapor absorption refrigeration system. Item #ParticularsAt cooling capacity greater1than 50 tons ofrefrigeration2Eco friendly3 A single unit capacityEffect of decrease ofevaporator temp45Equipment6COP7Type of energy used8Pipe material9Servicing requirement10 Space requirementsVapor Compression Vapor AbsorptionSystemSystem

Answered: At cooling capacity greater than 50…

Engineering

Mechanical Engineering

At cooling capacity greater than 50 tons of refrigeration 1 2 Eco friendly 3 A single unit capacity System System

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter44: Geothermal Heat Pumps

Section: Chapter Questions

Problem 12RQ: The function of the pressure tank in an open-loop, geo-thermal heat pump well system is to prevent...

See similar textbooks

Similar questions

IDENTIFY THE FF: AIRCONDITIONING AND VENTILATION 1. Acts as a master controller which keeps the system inautomatic operation2. Adds heat to a fluid3. Ratio of the actual partial pressure of the watervapor in a space to the saturation pressure of purewater at the same temperature.4. Also known as the heat content of air-vapormixture5. Temperature as read on an ordinary temperature6. Temperature where in water will start to condense7. Equipment that removes heat8. Is the process of treating air9. Their purpose is to create atmospheric conditionsfavorable to human health, comfort and efficiency.10. The system is to maintain indoor conditions forwinter season
All tasks
Pls. Answer thank you! An auditorium seating 1600 people is to be maintained at 80°F dry bulb and 65°F wet bulb temperature when outdoor air is at 91oF dry bulb and 75oF wet bulb. Solar heat load is 120,000 Btu/hr and supply air is at 60°F, determine the amount of supply air. (Use sensible heat load of 225 Btu/hr per person)
An air conditioning system is designed under the following conditions Outdoor conditions; 30°C dbt, 75% RH Required indoor conditions; 22°C dbt, 70% RH Amount of free air circulated; 3.33 m/sec Coil dew point temperature; 14°C The required condition is achieved first by cooling and dehumi dification and then by heating. Estimate (1) Capacity of cooling coil intons and its efficiency. (ii) Capacity of heating coil in kW. ii) Amount of water vapour removed kg/sec.
Full question solution and thanks
Problem 03.028 - DEPENDENT MULTIPART PROBLEM - ASSIGN ALL PARTS NOTE: This is a multi-part question. Once an answer is submitted, you willI be unable to return to this part. A 1.9-m3 rigid tank contains steam at 220°C. One-third of the volume is in the liquid phase and the rest is in the vapor form. The properties of steam at 220°C are given as follows: vf= 0.001190 m3/kg and vg= 0.08609 m3/kg. Steam Vm3 220°C Problem 03.028.b - Quality of a saturated mixture Determine the quality of the saturated mixture. (You must provide an answer before moving to the next part) The quality of the saturated mixture is
3:57 A Done lecture 7_b5ee35c08478147bb8a3744a... Lec. (7) tar -Dry bulb temperature O Example (1): An air conditioning equipment (figure) have the following: - Supply air mass-1.26 kg/s. The cooling coil receives 20 % outdoor air and 80% return air. tdz Fig. 18.14. Representation of supply air condition and room design condition. 0.252 kg/s Refrigeration and A/C - Outdoor air conditions are: 28°C db, 19.5°C wb Return air conditions are: 22°C db, 50% RH. The mixture air condition outlet the cooling coil are: 10°C db, 0.00735 kg/kgda Draw the system on the Psychrometric chart, then calculate: 1. Cooling coil load. 2. Room sensible heat. 3. Room latent heat. 4. Fresh (outdoor) load. 5. Duct and fan heat gain 6. Sensible heat ratio SHR. If the supply air temperature increases with a value 1°K due to fan motor heat gain and 2°K due to duct heat gain. . ← 1.008 kg/s R to Dr. Omar M. Ali LTE الغرفة المراد تكييفها (22,50 %) 1.26 kg/s R Grand Sensible Heat Factor It is defined as the ratio of…
Draw and describe the pyhsical construction, internal energy developed as well as the application of the following set of energy level: 1. Blower 2. Steam Pump 3. AC and DC generators
please provide full solution for review and comparison
Required information Problem 07.025 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Refrigerant-134a enters the coils of the evaporator of a refrigeration system as a saturated liquid-vapor mixture at a pressure of 140 kPa. The refrigerant absorbs 200 kJ of heat from the cooled space, which is maintained at -10°C, and leaves as saturated vapor at the same pressure. Problem 07.025.c - Total entropy change of the process Determine the total entropy change for this process. The total entropy change for this process is kJ/K.
Apply the ideal gas equation and calculate the volume (units: m3) for a single tank in at its fully pressurised state inside the plant room.
Hello, please help with this question for review purposes cuz my prof didn't teach us anything. Please provide charts and Table used with Plotting.