Aswatan gas occupies a space of 0.3 millike cube at a pressure of 2 bar and temperature of 77 degree Celsius it is indicate at constant volume at pressure of 7 parts determine temperature at the end of process mass of a gas changing internal energy change in enthalpy during the process assume CP is equal to 10 1.005 CV is equal to 0.712 is equal to 287

Aswatan gas occupies a space of 0.3 millike cube at a pressure of 2 bar and temperature of 77 degree Celsius it is indicate at constant volume at pressure of 7 parts determine temperature at the end of process mass of a gas changing internal energy change in enthalpy during the process assume CP is equal to 10 1.005 CV is equal to 0.712 is equal to 287

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An amount of an ideal gas undergoes the process shown in the diagram below. Assume that during the entire cycle, the number of moles of the ideal gas stays constant. P B A V (a) What are the signs of Why the gas Q, and AEint for the process CA? Wby the positive vx What is the work done by the gas if the volume is constant? What happens to the pressure? Consider the relationship of pressure, volume, and temperature in the ideal gas law. Does the temperature change? Does the internal energy change? How is the sign of AEint related to the signs of Q and Wby the gas gas vx What is the work done by the gas if the volume is constant? What happens to the pressure? Consider the relationship of pressure, volume, and temperature in the ideal gas law. Does the temperature change? Does the internal energy change? How is the sign of AEint related to the signs of Q positive and Wby the gas zero vx What is the work done by the gas if the volume is constant? What happens to the pressure? Consider the…
V. W. Th To %3D Room temperature T = 293 K V V. Vp The gas volume changes from Vp to Va at constant temperature T. The cartoon on the right shows a piston of gas undergoing this compression while submerged in a container of room temperature water, which acts as a reservoir. The initial state of this process is a piston containing 2 moles of a monatomic gas at Tc = 293 K (room temperature water) and volume V = a 1.0 m. The gas is compressed until V, = 0.2 m. During the compression, the heat bath of room temperature water maintains the temperature of the gas at T 293 K. Calculate the work done in joules by the gas during this process. Do not include units in your answer. Be careful to use the standard sign convention for work done by the gas. Write your numerical answer in normal form as described above in the instructions to this worksheet.
A sample of water that is initially at 84.00C absorbs 500 kcal of heat. As a result, the liquid water becomes water vapor at 1150C. What is the mass of the water? (Some useful information: cwater = 1 cal/g0C, Lv,water = 540 cal/g, and csteam = 0.480 cal/g0 C. a. 488 g b. 788 g c. 588 g d. 888 g e. 688 g
One mole of gas undergoes the cycle shown in the p-V diagram below. A Po B 1. D Po/32 Vo 2Vo 8V Volume 16V. (a) Classify each process in this cycle: A-B, B-C, C-D, and D-A. (b) Find y for this gas. (c) What type of gas is this, monatomic, diatomic, or polyatomic? Pressure
NOTE: Complete solution and show the derivation/cancellation of units. A steel flask of 0.04 m capacity is used to store Nitrogen at 120 bar and 20°C. The flask is protected against excessive pressure by a fusible plug which will melt and allow the gas to escape if the temperature is too high. A. How many kilogram of Nitrogen will the flask hold at the design conditions? B. At what temperature in °C must fusible plug melt in order to limit the pressure of flask to a maximum of 150 bar?
3
explain each step please.
Please answer the question
USE OF STEAM TABLE - PLEASE ANSWER BOTH QUESTION
Using the following information, determine the vapor pressure of water at 300 °C. Note: We started this problem in week 6 lecture 3. Please refer to the lecture to get started on this problem. You only need to show your work starting from where the lecture left off. H₂0 at T = 179.88 degrees C the vapor pressure is PSAT = 10 bar. The enthalpy of vaporization is 2014.59 kJ/kg V = 0.1944 m³/kg V¹ = 0.001127 m³/kg The equation we left off on in class was, cpf 1 [P² psat dpsat pi psat Tf 1 ∆vapH (TF 1 RAZ Ti dT T2a
N = 0 An insulated tank of volume 10+(10+N)/25 m and with a valve was filled with perfect tri- atomic gas at pressure 10 bar, where N is equal to the last two digitals in your student's ID number. Initially the valve was closed. A paddle wheel was mounted inside the tank and was run by 20 kW engine. The paddle wheel was turn on and at the same time the exit valve was opened. The gas temperature was constant though the whole process (due to very slow flow) and equal to 300 K. Calculate the time needed to decrease the pressure in the tank to 5 bar.
Q2/ A vessel having a capacity of 0.05 m3 contains a mixture of saturated water an saturated steam at a temperature 245oC the mass of the liquid present is 10 kg. find the following: i- The pressure. ii- The mass. iii- The specific volume. iv- The specific enthalpy. v- The specific internal energy.