Asteel alloy sPeeimen having a rectangular crass section of dimen sians lomm X 5mm has the stress-straint behavianr Shown on the Figure If this Speemen is subjected to the tensile force of 20,000N then: a) Determine the elastic and plastic St rain valmes ? b) If the original tength is 350mm afler the loae in Ca) is applied and the relaSed, Find the Final length ?

Q: the ground and free in the upper end. a) Calculate the compressive stress, then the minimum…

A: Given Data: H=3 mm=1000 kgFOS=3σut,c=241 MPaE=190 GPa   To Find: (a) The compressive stress. (b) The…

Q: Given dĴ 9 D = 400mm T = 300k N'm Inclined plane 0=60 d = 300mm Imax F = 1.5MN 1) Draw a square…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: c) A solid homogeneous truss tie-rod has a diameter of 9.52 mm and an original length of 1.75 m…

A: Given Data The daimeter of truss tie rod is:d=9.52 mm The length is:l=1.75 m The stress experienced…

Q: 6-a) Consider a cylindrical tungsten wire with a radius of 4.0 mm and a length of 2.5 × 10 mm. The…

A: The above question is based on the elongation of a wire under elastic deformation.

Q: At a point on a component, the stress has been calculated. The direct stress in the x direction is…

A:

Q: A hollow cylinder with an OD of 100mm and an ID of 30mm, supports a load of 100kN. What is the…

A:

Q: P solid, see Fig below. The outer diameter of the hollow and solid sections is 6 cm and the inner A…

A: Given: The outer diameter of the solid and hollow section: →Do=6 Cm=0.06 m The inner diameter of the…

Q: Given an element with stresses as indicated in figure below, find the following: a) The maximum and…

A: “Since you have posted a question with multiple sub parts, we willprovide the solution only to the…

Q: Q 2: A circular rod of 15 mm diameter and 120 mm length, is subjected to 2.5 KN tensile load if the…

A:

Q: with a stress of 52.89  and diameter of 4cm and thickness of 2mm  (P) load of 2MPa how was the…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.