Answered: Assume if the shear stress in steel… | bartleby

Related questions

Question

100%

Assume if the shear stress in steel exceeds about 4.00 x 10 N/m2 the steel ruptures.
(a) Determine the shearing force necessary to shear a steel bolt 0.75 cm in diameter.
N
(b) Determine the shearing force necessary to punch a 2.60-cm-diameter hole in a steel plate 0.450 cm thick.
N
Need Help?
Read It
Master it

Expert Solution

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

phy
A cube with edges exactly 3.00 cm long is made of material with a bulk modulus of 7.00 x 10 9 N/m 2. When it is subjected to a pressure of 6.00 x 107 Pa its final volume in cm 3 is:
Assume that if the shear stress in steel exceeds about 4.00 x 108 N/m², the steel ruptures. (a) Determine the shearing force necessary to shear a steel bolt 1.40 cm in diameter. IN (b) Determine the shearing force necessary to punch a 1.25-cm-diameter hole in a steel plate 0.550 cm thick. N
Between each pair of vertebrae in the spinal column is a cylindrical disc of cartilage. Suppose that such a particular disc of cartilage has a a radius of 3.118 cm (100cm = 1 meter) and a thickness of 6.877 mm (1000mm= 1meter). The shear modulus of cartilage is 1.2 × 107 N/m2. Suppose that a shearing force of magnitude 9 N is applied parallel to the top surface of the disc while the bottom surface remains fixed in place. How far does the top surface move relative to the bottom surface in microns (1 meter = 106 microns)?
A plank 2.00 cm thick and 16.3 cm wide is firmly attached to the railing of a ship by clamps so that the rest of the board extends 2.00 m horizontally over the sea below. A man of mass 67.7 kg is forced to stand on the very end. If the end of the board drops by 5.40 cm because of the man's weight, find the shear modulus of the wood. 75376.05
Consider a square-faced beam supporting a section of a building. a) Before installation, the length of the beam is found to be l0 = 15.02 m (figure a). After installation and construction, the length is remeasured and found to be l = 14.98 m (figure b). Determine Young's Modulus Y in N/m2 for the beam if it supports a mass m = 35000 kg and has a side length d = 1.9 m. b) Suppose that after the beam is installed it needs to be repaired. The weight it supports is removed and replaced with a new mass m2 (figure c). After the new mass is supported, the side length is remeasured and found to be larger with a difference of Δd. Assuming that this side length deformation is uniform and small, write an expression for determining Poisson's ratio v for this beam if its Young's modulus Y is known.
Two wooden members, each having a width of b = 2.4 in. and a depth of d = 0.8 in., are joined by a simple glued scarf joint. Assume B = 47°. If the allowable shear stress for the glue used in the joint is 94 psi, what is the largest axial load P that may be applied? Answer: P = i ! Ib