Assume a bank of heating strips is rated at 22 KW and is connected to 240 volts. The heat strips operate for 4 hours at a time and are located in an area with an ambient temperature of 86 degrees F. The termination temperature rating of the heat disconnect lugs are unknown. Copper conductors with type THWN-2 insulation are to be used because of the environment of the installation to connect the heaters. What size conductors should be used?

Q: What is the smallest square box that will accommodate four No. 12 conductors and four No. 10…

A: conductor A conductor is any piece of material that easily allows heat or electricity to pass…

Q: What size conductor should be used in a 2-wire system to service a load of 6,500 watts, 150 feet…

A:

Q: Six 1/0 aluminum conductors are to be run in a conduit. Each conductor has type THWN insulation's,…

A:

Q: What is the circuit breaker,types and how it is work?

A: a circuit breaker is a mechanical device that is used to open any type of electrical contact or to…

Q: Airframe Electrical System Question: What happens to the resistance of a wire if its temperature…

A: Resistance – at normal temperature material opposes the flow of electric charge through them, the…

Q: Find the appropriate conductor size for a THHN copper wire with 75 deg Celsius temperature capacity…

A: Note: For THHN wire rated at 75 degree Celsius, National Electric Code table should be followed…

Q: When installing grounding electrode conductor at services, it's common to use a single large common…

A: Here we discuss about grounding/earthing related concept.

Q: what are Class 2 conductors made of?

A: Conductors are made up of metallic wires.  Based on the number of strands present inside the…

Q: Give the raceway size required for each of the following conductor combinations: 1. Five, 10 AWG,…

A: The raceway size  required for each of the following conductor combination is given as per the…

Q: The minimum size for copper branch conductors in a dwelling is

A: The minimum size for copper branch conductors in a dwelling is

Q: Amprobe Clamp-On Meter (Model RS-3) How many conductors should be in the jaws of the meter when…

A: Only one individual question is to be answered. So, kindly repost the remaining questions. 1. The…

Q: 2. What fault occurs when Line and Neutral wires come with each other? Which device is actuated?

A: According to the given question, it is required to describe the fault which occurs when a line and a…

Q: list three factors that affect the resistance of conductors

A: The three factors that affect the resistance of conductors are - Length of conductor, l, Area of…

Q: A DC motor that draws 7.2A is located 85 feet from its 240VDC source. The copper conductors…

A: Given Voltage V = 240 V Current I = 7.2 A Length L = 85 ft Voltage drop = 2%

Q: Discuss application and uses of earth leakage breaker ?

A: ELCB (Earth Leakage Circuit Breaker):- An ELCB (Earth Leakage Circuit Breaker) is an electrical…

Q: What are the specific functions of a ground wire, a fuse, or a circuit breaker , and a double…

A: The main function of a ground wire is to pave a path for high currents that occur due to faults in a…

Q: Find voltage drop and R total of a 2-wire circuit loaded to a 200 A, run in conduit between two…

A: Since the temperature and material is not given in question, let us assume it to be 20 degrees…

Q: Name two types of conductor insulation designed to be underground

A:

Q: 1- For the Automatic Nighttime Thermostat circuit, describe how the sub-circuits should be connected…

A: Thermostat circuit - Thermostat circuit is used to on and off heating system depends upon air…

Q: Give the raceway size required for each of the following conductor combinations: 1. Five, 10 AWG,…

A: Given information, Number of conductors=5. Type of insulation is THW. Size of wire=10 AWG. Raceway…

Q: Assuming copper, standard wire type, and normal temperature rating, what is the typical conductor…

A: There is a standard table to know the conductor size (in AWG) in American Wire Gauge, which gives…

Q: What electrical hazards could a worn-out insulation give? How can these be prevented?

A: The hazards due to worn-out insulation are :- The insulation on the cables protects us from…

Q: Assuming copper, standard wire type, and normal temperature rating, what is the typical conductor…

A: The size of conductor depends on various factors, such as the length of the wire run and the voltage…

Q: A branch circuit conists of five conveniance outlets. Determine the size of the conductor to be used…

A:

Q: What's the maximum number of 400 kcmil THHN conductors that can be installed in a 6 in. x 6 in.…

A: Given 400 Kcmil conductors Size of wire way = 6 in.× 6 in.

Q: 10. Where a single-phase, 240-volt air-conditioning unit has a full-load current rating of 35…

A: AWG means American Wire Gauge, It is the standard form of selecting wire gauges based on different…

Q: Which of the following is?are an application of electrimagnets. A) relays, B) generations, C)…

A: An electromagnet is a type of magnet in which the magnetic field is produced by an electric current.

Q: Classify and give a detailed discussion of each category of power conductor and cables.

A: We need to explain category of power conductor and cables.

Q: 1. A 200 meter long two core cable with radius of 4 millimeter is used to transmit the electrical…

A: The solution can be achieved as follows.

Q: Four No. 12 and four No. 10 conductors are to be installed in a EMT conduit. What size EMT conduit…

A: Conductors size is selected on the basis of assigned numbers.  As the assigned number increases then…

Q: In conceal knob and tubing wiring, the clearance to be maintain between conductors is      a. 45 mm…

A: Clearance: It is the minimum distance required between conductors for safety and to avoid hazards.…

Q: With lapse of time what is the change in insulation resistance expected? Why?

A: The explanation is as follows.

Q: 70. A circuit supplies a continuous load of 38 amperes and is protected by a 50-amperecircuit…

A: Steps to calculate minimum size Given continous load current Find 125% of continous load current…

Q: c) Why ACSR Conductors are preferred over Copper Conductors?

A: Overhead transmission lines and transmission towers are a typical sight in rustic India. The…

Q: Seven 8 AWG copper conductors are run in conduit. Each conductor has type THHN insulation. The…

A: Given Copper wire AWG =8 total number of copper wires =7 Type of insulation THHN Ambient temperature…

Q: Moulded case circuit breakers generally have a magnetic element for overcurrent and Thermal element…

A: The explanation is as follows.

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.