Assay # 1 2 3 4 PNPP, conc. μΜ 150 75 37.5 18.75 Volume of 4 mM PNPP, mL 0.15 0.075 0.0375 0.01875 Volume of 0.2 M Tris pH 8, mL 0.4 0.4 0.4 0.4 Volume of H₂O, mL 3.35 3.43 3.46 3.48 Volume of 1/4 enzyme solution, mL 0.100 0.100 0.100 0.100 Total volume, mL 4 4 4 4

Assay # 1 2 3 4 PNPP, conc. μΜ 150 75 37.5 18.75 Volume of 4 mM PNPP, mL 0.15 0.075 0.0375 0.01875 Volume of 0.2 M Tris pH 8, mL 0.4 0.4 0.4 0.4 Volume of H₂O, mL 3.35 3.43 3.46 3.48 Volume of 1/4 enzyme solution, mL 0.100 0.100 0.100 0.100 Total volume, mL 4 4 4 4

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

6-what is difference between Transmittance and absorbance in spectroscopy?
Dopamine absorbs light at a λmax of 265 nm. A sample of dopamine (molar mass 153.18 g/mol) was prepared by dissolving 1.02 mg of dopamine in enough water to make a 500.00 mL sample. The UV absorbance at 280 nm was found to be 0.450 in a 1.500 cm cuvette. What is the molar absorptivity of dopamine in L mol-1 cm-1?
Absorbance measurements in the range of A = 0.3 - 2 are considered the most accurate. Why are absorbance measurements of 0.05 and 2.5 considered inaccurate? If the absorbance is too high (A = 2.5), the signal difference between the sample and the reference is too small for an accurate measurement. At A = 2.5, the transmission is too high for an accurate measurement. The difference in the absorbance of the sample and reference is too small at A = 0.05. At A = 2.5, the detector is saturated because too much light is reaching the detector. At A = 2.5, a sufficient amount of light does not reach the detector for an accurate measurement.
2. Express the following absorbances in terms of percent transmittance. a ) 0.918 b) 0.072
[X] (ppm) 0.00 10.0 15.0 20.0 25.0 30.0 35.0 x-axis Resources UV-Vis absorbance data for molecule X collected at 425 nm using a 3.50 cm cuvet is given in the table. [X] (M) 0.00 1.00 × 10 4 1.50 × 10-4 2.00 × 10-4 2.50 × 10-4 3.00 x 10-4 3.50 x 10-4 O %T %T T A 100.0 1.000 0.000 49.4 0.494 0.306 34.9 0.349 0.457 25.3 0.253 0.597 17.3 0.173 0.761 15.4 0.154 0.813 13.9 0.139 0.857 Prepare a plot using the linear range of the data to determine the molar absorptivity. What should be plotted on each axis to determine the molar absorptivity of molecule X at this wavelength? x Give Up? y-axis Hint OT 8:1
How do I go from frequency (eV) to wavenumber (cm-1)?
Using beer lambert's law: A= e.c.l ( l is the path length=1cm) determine the extinciton coeffiecient from the absorbance vs concentration graph.
Does a calibration curve alwasy compare concentration and absorbance? Or can it compare concentration and %T as well?
Spectral Analysis IR Analysis Interpret the IR spectrum. Transmitance 0.9 0.8 0.7 0.6 0.5 0.4 0.3 0.2 3500 3000 Infrared Spectrum 2500 Wavenumbers (cm-1) 2000 Cha 1500 1000