As shown in the PV diagram below, the cycle goes in the order of states A-B-C-D, and the system is one mole of a monatomicideal gas. The processes between each state are labelled as 1 through 4.For which process or processes will the entropy change be greater than or equal to zero (AS > 0)?1A4Po3Po42PoPoD3Vo 2Vo 3Vo 4VoO All processesO Process 1 onlyO Processes 1 and 4O Processes 2 and 3O Processes 2 and 4B.

For process 1, W=8P0V0For process 2, W=0For process 3, W=-8P0V0For process 4, W=0 We know,…

Answered: As shown in the PV diagram below, the…

Similar questions

P Example of calculation of work P = 1 Atm V%= 1 litre iii ii P V V,12 V In this cycle the system, which is an ideal monatomic gas, undergoes first isothermal (i) then adiabatic (ii) compression steps, each of which halve the volume, then returns to its starting point via first isothermal (iii) and then adiabatic (iv) expansions, each of which double the volume. How much work is done by the system during the cycle if P, is 1 atmosphere and V, =1 litre?
please answer vvv
For ice melting into water at 0 °C, the latent heat of fusion is Lp = 3.34 x 105 J/kg. For water boiling at 100 °C, the latent heat of vaporization is Ly = 2.26 x 105 J/kg. Which process involves a greater change in entropy? O melting 1.00 kg of ice at 0 °C O vaporizing 1.00 kg of liquid water at 100 °C the entropy change is the same for both
One mole of an ideal gas is used as the working substance of an engine operating in the cycle shown in the figure below. BC and DA processes are reversible adiabatic.a) Is the gas monoatomic, diatomic or triatomic?b) What is the efficiency and engine?
A monatomic gas is take through a cycle from A to B to C and back to A. At A the pressure is 100,000 pa, the volume is 4.0 liters, and the temperature is 300K. The gas is compressed adiabatically until the volume is 1.0 liters (at B). How much energy was given to or removed from the gas during the adiabatic process?
A certain gasoline engine is modeled as a monatomic ideal gas undergoing an Otto cycle, represented by the p-V diagram shown in the figure. The initial pressure, volume, and temperature are p1 = 1.05 × 105 Pa, V1 = 0.035 m3, and T1 = 290 K, respectively. a)The first step in the Otto cycle is adiabatic compression. Enter an expression for the work performed on the gas during the first step, in terms of V1, V2, and p1. b) Calculate the temperature of the gas, in kelvins, at the end of the first step. c)The fourth and last step in the Otto cycle is isochoric cooling to the initial conditions. Find the amount of heat, in joules, that is discharged by the gas during the fourth step.
Find the work for a system where temperature (T) is constant. (This is called an isothermal process) W = P(V₂ - Vf) W = 0 (V) W = P(V₁ - V₂) W = PV W = - PV) W = -nRT W = nRT W = nRT In W n(V) = nRT In