As shown in the accompanying Carbon Tetrachloride figure, pipe M contais carbon tetrachloride of specific (Sp. Gr. 1.594) M gravity 1.594 under a pressure of 1.05 kg(f)/cm2 and pipe Oil N contains oil of specific gravity 0.8. If the pressure in the (Sp. Gr. 0.8) 2.5 m pipe Nis 1.75 kg(f)/cm2 and the manometric fluid is mercury, find the differencex between the levels of mercury. 1.5 m Mercury

As shown in the accompanying Carbon Tetrachloride figure, pipe M contais carbon tetrachloride of specific (Sp. Gr. 1.594) M gravity 1.594 under a pressure of 1.05 kg(f)/cm2 and pipe Oil N contains oil of specific gravity 0.8. If the pressure in the (Sp. Gr. 0.8) 2.5 m pipe Nis 1.75 kg(f)/cm2 and the manometric fluid is mercury, find the differencex between the levels of mercury. 1.5 m Mercury

Materials Science And Engineering Properties

1st Edition

ISBN:9781111988609

Author:Charles Gilmore

Publisher:Charles Gilmore

Chapter10: Oxidation, Degradation, Corrosion, Electroprocessing, Batteries, And Fuel Cells

Section: Chapter Questions

Problem 10.1P

See similar textbooks

Similar questions

10-kg of R-134a fill a 1.348-m3 rigid container at an initial temperature of 240oC. The container is then heated until the pressure is 200 kPa. Determine the final temperature and the initial pressure
3. Some industrial spent catalyst was tested as adsorbent material in a batch experiment. The data are reproduced in the following table. Determine the Final Conc., Ce (mg/L) 14.88 9.55 1.89 0.58 0.44 0.61 0.36 Uptake, q (mg/g) 8.80 8.41 7.33 6.15 5.68 4.92 3.79 a. Determine the coefficients for these data assuming a Freundlich isotherm applies. b. Determine the coefficients for these data assuming a Langmuir isotherm applies. c. Which isotherm model provides a better fit to the data? Explain.
When analyzing the stack gases, the analysis is reported in what unit?
Please choose the correct answer for each question: 1. Activity of a gas in equilibrium with solution is ______? A. its partial pressure; B.1.0; C. its molar concentration; D. 0.0 2. During a sorption procedure, the substance transferred from the gas or liquid phase to the solid phase is called ______ A. sorbent; B. sorbate; C. partition; D. none of the above 3. When a chemical has a lower KOW, it is more ______ A. hydrophobic; B. hydrophilic; C. more absorbable; D. less absorbable 4. _____ occurs on the adsorbent surface A. Adsorption; B. Sorption; C. Absorption; D. Adsorption and absorption 5. _____ addresses the change in the amount of a substance of interest with time. A. The equilibrium approach; B. The kinetic approach; C. Henry’s Law; D. Freudlich isotherm equation
2. In the figure shown, if the atmosphere pressure is 101.3 kPa and the absolute Pressure at the bottom of the tank is 300 kPa. What is the specific gravity of the unknown liquid. SAE Oil 2 s = 0.90 ---F ? 2.5m ---- Olive oil 2.5m s= 0.95 .--- Sea water 2 s= 1.03 Glycerine s= 1.26 --
Q2: Determine the resultant about the point O of the four forces and one couple which act on the plate shown in the Figure below. Note : for the resutant of 3osihys Forc es, You should computy the magnitude Kdirechion 30N 5 m- 3 ocos4s 25N 2 m 70 N-m 20N 40N o 30
During a steady flow process, the pressure of the working substance drops from 200 to 20 psia, the speed increases from 200 to 800 ft/s the internal energy decreases 20 BTU/lb and the specific volume increases from 2 to 10 ft³/lb. No heat transferred. Determine the following: a)AKE in ft-lb;/Ibm b)APE in ft-lb/lbm c)AW: (flow work) ft-lb:/lbm d)AH in BTU e) Net work in hp for 15 lb/min of fluid (use mass flow rate for this item only)
Aluminum pieces inadvertently collect on the filter. a. If left on the filter, will the percent yield of the alum be reported as too high or as too low? Explain. b. If the aluminum pieces are detected on the filter, what steps would be used to remedy the observation? Explain.
2. A 2-m long aluminum pipe at 27°C is heated until it is 2.0024 m at 77°C. What is the coefficient of linear expansion of aluminum? Complete FBD, FORMULA, AND SOLUTION
The capillary rise (height) in mm of an ethanol having a viscosity of 0.032 J/m2. The tube has a diameter of 0.1 mm and the density of the fluid is 0.71 g/cm3
The following information is given for n-pentane at 1 atm:boiling point = 36.20°C ΔHvap (36.20°C) = 357.6 J/g melting point = − 129.7°C ΔHfus (−129.7°C) = 116.7 J/g specific heat gas = 1.650 J/g ⋅ °C specific heat liquid = 2.280 J/g ⋅ °C A 26.10-g sample of liquid n-pentane is initially at −51.40°C. If the sample is heated at constant pressure (P = 1 atm), how many kJ of energy are needed to raise the temperature of the sample to 65.30°C?
An activated-carbon bed that is 12 ft x 6 ft x 2 ft deep is used in a benzene recovery system. The system is on-line for one hour and is then regenerated for one hour.